Question

5. (30 pts) A pn junction with the characteristic shown in the figure below is required for an oscillator application. Determine VO, Co. and ND when Na = 2.10-18. Assume the junction is an abrupt junction. Here Cjo ColA, C-C/A, and their units are fFlum C(UFIum2) 2.2 -1.5-0.5 -Vy (V)

0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
5. (30 pts) A pn junction with the characteristic shown in the figure below is required...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • 3. (40 pts) The capacitance of a silicon pn junction diode with an area 10° cm2 is measured. A pl...

    3. (40 pts) The capacitance of a silicon pn junction diode with an area 10° cm2 is measured. A plot of 1/C2 vs. the applied voltage Va is shown. The dashed line is extrapolated, continuing the data with a constant slope. From the junction capacitance formula and the dependence of W on Vbi-VA, one can obtain an equation for 1/C (a) If the diode is a one-sided junction, find the doping density on the low side from the measured (estimate...

  • Wdep P-Type N -Type Q1. Consider the PN junction at equilibrium shown in the figure above....

    Wdep P-Type N -Type Q1. Consider the PN junction at equilibrium shown in the figure above. Both N-side and P-side has same doping density NA ND 1017 /cm3. Assume both electron and hole mobility to be same, i.e Me - 1000cm2/Vs. a equilibrium energy band diagram. Find (EF Et at(i)x-0. (ii) x »xn (iii) X <K_Xp Find the value of built-in voltage and total depletion width (5+5 points) Find electron and hole densities at (i) x = 0. (ii) x...

  • 4.15 A PN diode with lengths much larger than the carrier diffusion length such as shown...

    4.15 A PN diode with lengths much larger than the carrier diffusion length such as shown in Fig. 4-18 is called a long-base diode. A short-base diode has lengths much shorter than the diffusion lengths, and its excess carrier concentration is similar to that shown in Fig. 8-6. A uniformly doped short-base Si diode has Nd- 101cm-3and Na 1016cm3. tp n1 us, Dp 10 cms, Dn 30 cm-s, and cross-sectional area10 cm. The length of the quasi-neutral N-type and P-type...

  • Write down the electronegativity for each of the halogens shown in chang figure 9.5 EXCEPT At....

    Write down the electronegativity for each of the halogens shown in chang figure 9.5 EXCEPT At. If increasing electronegativity means that the corresponding anion is more stable, then would you expect that iodine I2 would be able to oxidize fluoride ion to fluorine? EXPLAIN YOUR ANSWER. Increasing electronegativity 2.1 2A, 3A 4A 5A. 6A. 7A Li Be B C N O F 1.5 2.0 2.5 3.0 3.5 4.0 Na Mg Al Si P S CI 25 3B 4B 6B 8B...

  • Question 9 5 pts The circuit shown in the figure contains four capacitors whose values are...

    Question 9 5 pts The circuit shown in the figure contains four capacitors whose values are as follows: C1=6 F, C2=2 F, and C3=C4=4 F. The battery voltage Vo=5 V. When the circuit is connected what will be charge on C3? CA C₂ C3 Vo 30C 200 15 C O 100 O 50

  • Question 9 5 pts The circuit shown in the figure contains four capacitors whose values are...

    Question 9 5 pts The circuit shown in the figure contains four capacitors whose values are as follows: C1=6 F, C2=2 F, and C3=C4=4 F. The battery voltage Vo=5 V. When the circuit is connected what will be charge on C2? C4 C1 C2 C3 V 5C O 10 C 15 C 20 C 30 C

  • Question 8 5 pts The circuit shown in the figure below contains three resistors (R1, R2,...

    Question 8 5 pts The circuit shown in the figure below contains three resistors (R1, R2, and Rs) and three batteries (VA. Vg, and V). The resistor values are: R2-2 Ohms, R2-R3-6 Ohms, and the battery voltages are VA-25 V. V8-15V, and Vc-20 V. When the circuit is connected, what will be the power dissipated by R2? VC R 3 VA VB R2 R₃ 10W 2.0 W oooo 5.0 W 6.0 W 7.5 W Question 9 5 pts The circuit...

  • 2.5 2 1.8 0.5 O -05 -18 FIGURE 2. Figure for Problem 5. 5. (5 pts)...

    2.5 2 1.8 0.5 O -05 -18 FIGURE 2. Figure for Problem 5. 5. (5 pts) Let f(x,y) be a smooth function with Vf(0,0), V/ (0,0) and V,0,0) shown as OÀ, OB and OC in Figure 2. The r and y-axes are horizontal and vertical, respectively. (a) Compute the directional derivative (0,0). (b) Is there a direction in which the rate of change of fat (0,0) is -2.5? Circle your answer: Yes No Give a reason: (c) If f(0,0) =...

  • Question 8 5 pts The circuit shown in the figure below contains three resistors (R1, R2,...

    Question 8 5 pts The circuit shown in the figure below contains three resistors (R1, R2, and Rg) and three batteries (VA. V. and Vc). The resistor values are: Rq=2 Ohms, R2=R3-6 Ohms, and the battery voltages are VA-25V, Vo=15 V, and Vc=20V. When the circuit is connected, what will be the power dissipated by R2? Vc R R2 R3 1.0 W 20w 5.0 W 6.0W 7.5 W

  • Q4 (20 pts): Water flows steadily through the funnel shown in the figure below. Throughout most...

    Q4 (20 pts): Water flows steadily through the funnel shown in the figure below. Throughout most of the funnel the flow is approximately radial (along rays from 0) with a velocity of V = c/rwhere r is the radial coordinate and c is a constant. If the velocity is 0.5 m/s when r=0.2 m determine: (a) the acceleration magnitude at point A, (b) the acceleration magnitude at point B. 12 m T 0.6 m 0.2 m

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT