A three-phase transmission line operating at 345kV, 500 MVA, has a three phase CT and a three phase VT connected to it. The VT and CT are connected(Y/Y). The CT ratio is 1200:5 and the VT ratio is 3000:1. Draw the schematic diagram and Determine the CT line and phase secondary currents and VT line and phase secondary voltages
We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
A three-phase transmission line operating at 345kV, 500 MVA, has a three phase CT and a three phase VT connected to it. The VT and CT are connected(Y/Y). The CT ratio is 1200:5 and the VT ratio is 3000:1. Draw the schematic diagram and Determine the CT li
a. Three single phase step-up transformers rated at 40 MVA, 13.2 kV/80 kV are connected in delta-wye on a 13.2 kV transmission line. If they feed a 90 MVA load calculate the following: i. The secondary line voltage ii. The current in the transformer windings iii. The incoming line currents iv. If the transformer types are two (2) additive and one (1) subtractive draw the connection diagram for the configuration stated using physical representation. b. A 3-phase squirrel cage motor has twelve (12) leads (labelled 1 to...
18. The primary conductor in Figure 10.2 is one phase of a three-phase trans- mission line operating at 345 kV, 700 MVA, 0.95 power factor lagging. The CT ratio is 1200:5, and the VT ratio is 3000:1. Determine the CT second- ary current and the VT secondary voltage V. Assume zero CT error. A CO-8 relay with a current tap setting of 5 amperes is used with the 100:5 CT in Example 10.1. The CT secondary current I' is the...
1. Three single-phase step-up transformers rated at 75 MVA, 13.2 kV/80 kV are connected in delta- wye on a 13.2 kV transmission line. If they feed a 180 MVA load, calculate the following: a. The secondary line voltage b. The currents in the primary and secondary windings C. The incoming and outgoing transmission line currents
1. In order to meet an emergency, three single-phase transformers with 12.470/7.200 V are connected in Delta-Wye to form a three-phase transformer which is fed by a 12.470 V transmission line. If the transformer supplies 60 MVA to a load, calculate: (3 marks) a. The turns ratio for each transformer b. The currents in the primary and secondary windings of the transformer c. The primary and secondary transmission line currents 2. A Wye-Delta transformer is connected to a 66 kV...
The ratings of a three-phase, three-winding transformer are Y connected, 66 kV, 20 MVA Primary (1): Secondary (2):Y connected, 13.2 kV, 15 MVA Tertiary (3): A connected, 2.3 kV, 5 MVA Neglecting winding resistances and exciting current, the per-unit leakage reactances are: X12 0.08 on a 20-MVA, 66-kV base X13 0.10 on a 20-MVA, 66-kV base X23 0.09 on a 15-MVA, 13.2-kV base (a) Determine the per-unit reactances Xi, X2, X3 of the equivalent circuit on a 20- MVA, 66-kV...
Draw the reactance diagram for the power system shown in Fig. 1 on a 1200 MVA base and 26 kV base at G4 If each motor is operating at its rated current and voltage and 0.9 power factor lagging, find the voltage at bus C. Component Ratin 500 MVA, 22 kV 600 MVA, 23 kV 1200 MVA, 24 kV/500 kV 1500 MVA, 500 kV/13.8 kV Each: 400 MVA, 13.8 kV 700 MVA, 26 kV Three single-phase transformers, each 250 MVA,...
1500:5 dan VT 3000:1 dalam rekebantuk anda. Lakarkan gambarajah zon perlindungan B42 Rajah 4 1 Figure 4 5/7 KEEE4253 Figure 4 shows 132 kV transmission line system. Line 1-2, 2-3, and 2-4 are 64 km, 64 km, and 96 km respectively. The positive-sequence impedance of the lines 112. L23 and L24 are 0.05+0.50 0.054j0.6 and 0.08+0.8 per km respectively. Design a three-zone distance-relaying system for the relay line L12 on bus 1. Use CT with ratio of 1500:5 and VT...
Draw schematic (connection) diagrams for three-phase Y-Y and Y-Δ connected transformers using three single-phase (50 VA, 120V/25V) transformers you have previously worked with in the lab. Show proper dot markings for each configuration. I. 2. Find the line-line voltage ratio (VuVa) for each configuration. For a three-phase Δ-connected resistive load (25 Ω in each leg), connected on the transformer low voltage side, calculate the line current on each side of the transformer for each configuratio Is it safe to operate...
10. In order to meet an emergency, three single-phase transformers with 12.4707.200 Vrms are connected in A-Y to form a three-płuase transformer wluch is fed by a 12,470-V transmission line. If the transformer supplies 60 MVA to a lood, find (a) the tum ratio for each transformer, (b) the currents in the primary and secondary windings of the transformer, (c) the incoming and outgoing transmission line cuarents
A three-phase generator connected in a star generates a phase voltage of Vθ = 24 KVrms and supplies a three-phase transformer connected in star. The transformation ratio is 115: 1. Each of the three coils of the secondary transformer feed 3 equal charges each composed of them by R = 18Ω, XC = 2Ω and XL = 20Ω. a) Calculate the phase, line and charge currents after the b) Calculate the phase, line and load voltages c) Calculate the Apparent...