A 6 in. schedule 80 steel pipe (OD=6.62 in.) will be used to transport 450◦F steam...
A 6 in. schedule 80 steel pipe (OD=6.62 in.) will be used to transport 450◦F steam from a boiler house to a new process unit. The pipe will be buried at a depth of 3 ft (to the pipe centerline). The soil at the plant site has an average thermal conductivity of 0.4 Btu/h · ft · ◦F and the minimum expected ground surface temperature is 20◦F. Estimate the rate of heat loss per foot of pipe length for the following cases:
(a) The pipe is not insulated.
(b) The pipe is covered with a 2-in. thick layer of magnesia insulation. Neglect the thermal resistance of the pipe wall and the contact resistance between the insulation and pipe wall.
Ans. (a) 350 Btu/h · ft of pipe. (b) 160 Btu/h · ft of pipe.
Homework Answers
Add Answer to:
A 6 in. schedule 80 steel pipe (OD=6.62 in.) will be used to
transport 450◦F steam...
1. A ¾ inch (nominal), Schedule 40, mild steel pipe carries 40 psia steam through a...
1. A ¾ inch (nominal), Schedule 40, mild steel pipe carries 40 psia steam through a room having an air temperature of 80°F. The pipe is covered with a 0.125 ft thick layer of fiberglass insulation having a thermal conductivity of 0.037 Btu/(h ft ‘F). The hi value on the steam side of the pipe is 1000 Btu/h ft2 °F. The ho value on the outside of the insulation is 2.0 Btu/(h ft2 ’F). For the mild steel, k=26Btu/(ft H...
A pipe with insulation material is used to carry steam to an operating plant. The conditions...
A pipe with insulation material is used to carry steam to an operating plant. The conditions and dimensions for the system are as follows Variable Value Length of pipe, L 100 ft Inner diameter of pipe, Do 1 inch Outer diameter of pipe, D1 1.24 inches Outer diameter of insulation, D2 2 inches Inside film heat transfer coefficient for condensing saturated steam, ho 800 Btu/hr-ft2.oF Outside film heat transfer coefficient for air, ht 2 Btu/hr-ft2.oF Thermal conductivity of the pipe,...
a 0.4 m diameter, thin walled steel pipe is used to transport saturated steam Problem 3.049...
a 0.4 m diameter, thin walled steel pipe is used to transport
saturated steam
Problem 3.049 A 0.4-m-diameter, thin-walled steel pipe is used to transport saturated steam at a pressure of 20 bars in a room for which the air temperature is 25°C and the convection heat transfer coefficient at the outer surface of the pipe is 20 W/m2-K. (a) What is the heat loss per unit length from the bare pipe (no insulation)? (b) Estimate the heat loss per...
A steel pipe carrying saturated steam at 4000 kpa, is 304.8 mm OD. The pipe is...
A steel pipe carrying saturated steam at 4000 kpa, is 304.8 mm OD. The pipe is 150 m long. Temp outside the pipe is 18 degrees C. It is insulated with formed insulation with thermal conductivity of 0.023 W/m/K. If the design is to allow for condensation of 80 kg of steam per hour, how thick must the insulation be?
A 15-foot steel (k 7.2 Btu/h ft F) pipe is carrying steam at a temperature of...
A 15-foot steel (k 7.2 Btu/h ft F) pipe is carrying steam at a temperature of 250 F. The pipe geometry has the following dimensions: inner diameter 4" and an outer diameter 4.8". The outside surface of the pipe is cooled via convection-assume convection coefficient (h) 125 Btu/h ft2 F. If the temperature of the outer surface of the pipe is 160 F address the following: (a) develop an expression for the heat equation and associated boundary conditions and (b)...
Problem 1. Steam at 120°C is transported in a long 8" outer diameter pipe. Its outer surface is c...
Problem 1. Steam at 120°C is transported in a long 8" outer diameter pipe. Its outer surface is covered with a 1" thick fiberglass (thermal conductivity, 0.05 W/(mK)) insulation. When the outer temperature is 0°C, the rate of condensation of steam is measured to equal 0.06 g per meter of the pipe length. Estimate the heat transfer coefficient. The heat of vaporization of the steam is 2600 J/g. The resistance to the heat transfer through the pipe wall may be...
Problem 3 (30): Steam at Too,1 340 °C flows in a cast iron pipe [k- 80 W/m.°C] whose inner and outer diameter are Di 6 cm and D2 -8 cm, respectively. The pipe is covered with a 4-cm thick glass wool...
Problem 3 (30): Steam at Too,1 340 °C flows in a cast iron pipe [k- 80 W/m.°C] whose inner and outer diameter are Di 6 cm and D2 -8 cm, respectively. The pipe is covered with a 4-cm thick glass wool insulation [k-0.05 W/ m°C]. Heat is lost to the surroundings at Too,2 - 21°C by natural convection and radiation, with a combined heat transfer coefficient of h- 18 W/m2 °C. Taking the heat transfer coefficient inside the pipe to...
Two large parallel plates with surface conditions approximating those of a blackbody are maintained at 800°C...
Two large parallel plates with surface conditions approximating those of a blackbody are maintained at 800°C and 100°C, respectively. Determine the rate of heal transfer by radiation between the plates in Wim and the radiative heat transfer coefficient in W/m K ) 12 Write down the one-dimensional sent heal conduction equation for a plane wall with constant thermal conductivity and heat generation in its simplest form, and indicate what each variable represents 13 Write down the one-dimensional transient heat conduction...
summatize the following info and break them into differeng key points. write them in yojr own...
summatize the following info and break them into differeng key points. write them in yojr own words
apartus
6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
A pipe with insulation material is used to carry steam to an operating plant. The conditions and dimensions for the system are as follows Variable Value Length of pipe, L 100 ft Inner diameter of pipe, Do 1 inch Outer diameter of pipe, D1 1.24 inches Outer diameter of insulation, D2 2 inches Inside film heat transfer coefficient for condensing saturated steam, ho 800 Btu/hr-ft2.oF Outside film heat transfer coefficient for air, ht 2 Btu/hr-ft2.oF Thermal conductivity of the pipe,...
a 0.4 m diameter, thin walled steel pipe is used to transport
saturated steam
Problem 3.049 A 0.4-m-diameter, thin-walled steel pipe is used to transport saturated steam at a pressure of 20 bars in a room for which the air temperature is 25°C and the convection heat transfer coefficient at the outer surface of the pipe is 20 W/m2-K. (a) What is the heat loss per unit length from the bare pipe (no insulation)? (b) Estimate the heat loss per...
A 15-foot steel (k 7.2 Btu/h ft F) pipe is carrying steam at a temperature of 250 F. The pipe geometry has the following dimensions: inner diameter 4" and an outer diameter 4.8". The outside surface of the pipe is cooled via convection-assume convection coefficient (h) 125 Btu/h ft2 F. If the temperature of the outer surface of the pipe is 160 F address the following: (a) develop an expression for the heat equation and associated boundary conditions and (b)...
Problem 1. Steam at 120°C is transported in a long 8" outer diameter pipe. Its outer surface is covered with a 1" thick fiberglass (thermal conductivity, 0.05 W/(mK)) insulation. When the outer temperature is 0°C, the rate of condensation of steam is measured to equal 0.06 g per meter of the pipe length. Estimate the heat transfer coefficient. The heat of vaporization of the steam is 2600 J/g. The resistance to the heat transfer through the pipe wall may be...
Problem 3 (30): Steam at Too,1 340 °C flows in a cast iron pipe [k- 80 W/m.°C] whose inner and outer diameter are Di 6 cm and D2 -8 cm, respectively. The pipe is covered with a 4-cm thick glass wool insulation [k-0.05 W/ m°C]. Heat is lost to the surroundings at Too,2 - 21°C by natural convection and radiation, with a combined heat transfer coefficient of h- 18 W/m2 °C. Taking the heat transfer coefficient inside the pipe to...
Two large parallel plates with surface conditions approximating those of a blackbody are maintained at 800°C and 100°C, respectively. Determine the rate of heal transfer by radiation between the plates in Wim and the radiative heat transfer coefficient in W/m K ) 12 Write down the one-dimensional sent heal conduction equation for a plane wall with constant thermal conductivity and heat generation in its simplest form, and indicate what each variable represents 13 Write down the one-dimensional transient heat conduction...
summatize the following info and break them into differeng key points. write them in yojr own words
apartus
6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
Most questions answered within 3 hours.
-
----Can someone please help me solve this one using JAVA
----I thank you in advance
Create...
asked 8 seconds ago -
1. What force primarily attracts the potassium ion to
the nitrate ion?
a. London forces...
asked 1 minute ago -
What are the negative effects of abruptly stopping the use of
all fossil fuels? Give at...
asked 8 minutes ago -
Given that many conflict are the result of different parties having
different interests, is it possible...
asked 13 minutes ago -
A 750 g block can slide uniformly along the horizontal track
when a string attached to...
asked 16 minutes ago -
In 2017, Juan entered into a contract to write a book. The
publisher advanced Juan $50,000,...
asked 30 minutes ago -
Determine the number of kinds of protons in each molecule (w/
respect to NMR spectroscopy). Drawing...
asked 40 minutes ago -
A jeweler whose near point is 68 cm from his eye uses a
magnifying glass as...
asked 38 minutes ago -
A company wants to determine how many units of each of two
products, A and B,...
asked 42 minutes ago -
The blood pressure of a person changes throughout the day.
Suppose the systolic blood pressure of...
asked 51 minutes ago -
A chemistry student desired to study sulfur. Sulfur exhibited
the following characteristics with oxygen:
(a) It...
asked 46 minutes ago -
An Atwood machine is constructed of a solid-disk frictionless
pulley of mass m3 and radius R....
asked 48 minutes ago