Homework Answers
Add Answer to:
A 15-foot steel (k 7.2 Btu/h ft F) pipe is carrying steam at a temperature of...
1. A ¾ inch (nominal), Schedule 40, mild steel pipe carries 40 psia steam through a...
1. A ¾ inch (nominal), Schedule 40, mild steel pipe carries 40 psia steam through a room having an air temperature of 80°F. The pipe is covered with a 0.125 ft thick layer of fiberglass insulation having a thermal conductivity of 0.037 Btu/(h ft ‘F). The hi value on the steam side of the pipe is 1000 Btu/h ft2 °F. The ho value on the outside of the insulation is 2.0 Btu/(h ft2 ’F). For the mild steel, k=26Btu/(ft H...
A pipe with insulation material is used to carry steam to an operating plant. The conditions...
A pipe with insulation material is used to carry steam to an operating plant. The conditions and dimensions for the system are as follows Variable Value Length of pipe, L 100 ft Inner diameter of pipe, Do 1 inch Outer diameter of pipe, D1 1.24 inches Outer diameter of insulation, D2 2 inches Inside film heat transfer coefficient for condensing saturated steam, ho 800 Btu/hr-ft2.oF Outside film heat transfer coefficient for air, ht 2 Btu/hr-ft2.oF Thermal conductivity of the pipe,...
A 6 in. schedule 80 steel pipe (OD=6.62 in.) will be used to transport 450◦F steam...
A 6 in. schedule 80 steel pipe (OD=6.62 in.) will be used to transport 450◦F steam from a boiler house to a new process unit. The pipe will be buried at a depth of 3 ft (to the pipe centerline). The soil at the plant site has an average thermal conductivity of 0.4 Btu/h · ft · ◦F and the minimum expected ground surface temperature is 20◦F. Estimate the rate of heat loss per foot of pipe length for the...
Help with a-g, answers given. Show work The inner pipe of a double-pipe heat exchanger has...
Help with a-g, answers given. Show work
The inner pipe of a double-pipe heat exchanger has an OD of 1.9 in. and contains 36 rectangular fins of the type shown in the sketch below. The fins are made of steel (k 34.9 Btu/h ft. "F) and are 0.5 in. high and 0.035 in. thi temperature is 250°F and the fluid in the annulus surrounding the fins is at 150°F with a heat-transfer c ck. The pipe wall ft2 、 c,...
B Steam flows in a steel pipe, which is insulated by gypsum plaster. The inner and...
B Steam flows in a steel pipe, which is insulated by gypsum plaster. The inner and outer diameter of the pipe are 8 cm and 6 cm respectively with pipe length of 20-m. The thickness of gypsum plaster which wraps the pipe is 4 cm. The heat transfer coefficient of the inner pipe and outer insulation are 800 W/m2.°C and 200 W/m2.°C with inner pipe temperature of 200°C and outer insulator temperature of 10°C. The thermal conductivity of the pipe...
Steam at 150 °C flows in a stainless steel pipe which has a thermal conductivity of...
Steam at 150 °C flows in a stainless steel pipe which has a thermal conductivity of 16 W m-1 K -1 whose inner and outer diameters are 5 and 6 cm respectively. The pipe is covered with 3 cm think insulation having a thermal conductivity of 0.035 W m-1 K -1 . The combined convection and radiation heat transfer coefficient at the outside surface of the insulation is 20 W m-2 K -1 and the surroundings are at 10 °C....
a 0.4 m diameter, thin walled steel pipe is used to transport saturated steam Problem 3.049...
a 0.4 m diameter, thin walled steel pipe is used to transport
saturated steam
Problem 3.049 A 0.4-m-diameter, thin-walled steel pipe is used to transport saturated steam at a pressure of 20 bars in a room for which the air temperature is 25°C and the convection heat transfer coefficient at the outer surface of the pipe is 20 W/m2-K. (a) What is the heat loss per unit length from the bare pipe (no insulation)? (b) Estimate the heat loss per...
Consider a pipe consisting of two layers: Consider a pipe consisting of two layers: • an...
Consider a pipe consisting of two layers:
Consider a pipe consisting of two layers: • an inner layer of AISI 1010 steel with thickness 2 cm, and • an outer layer of insulation (k = 0.034 W/(m · K)) with thickness 4 cm The pipe's contents keep the inner surface at a constant temperature of 120 °C, while the outside experiences convection with overall convection coefficient h 30 W/(m²K) to the surroundings at T = 25°C. The pipe's inner diameter...
(c) Steam flows a pipe of external diameter 30 mm, where the pipe outer surface temperature...
(c) Steam flows a pipe of external diameter 30 mm, where the pipe outer surface temperature is 130oC. Circular annular fins (k = 180 W·m-1·K-1) of outer diameter 60 mm and thickness 1 mm are fitted tightly to the pipe. Heat is transferred by convection (h=10 W·m-2·K-1) to the surrounding air at 20oC. (i) Determine the efficiency of a single fin. (ii) Determine the heat transfer rate for a single fin. (8 marks) (6 marks) (iii) Determine the effectiveness of...
a) what is the heat loss per unit length from the pipe in W/m? b) Estimate...
a) what is the heat loss per unit length from the pipe in
W/m?
b) Estimate the heat loss per unit length if a 50 mm thick layer
of insulation with a conductivity of 0.058 W/m K. Neglect radiation
for this part.
3. A 0.20-m diameter, thin-walled steel pipe is used to transport saturated steam at a temperature of 486K in a room for which the air temperature is 25°C and convection heat transfer coefficient at the outer surface of...
A pipe with insulation material is used to carry steam to an operating plant. The conditions and dimensions for the system are as follows Variable Value Length of pipe, L 100 ft Inner diameter of pipe, Do 1 inch Outer diameter of pipe, D1 1.24 inches Outer diameter of insulation, D2 2 inches Inside film heat transfer coefficient for condensing saturated steam, ho 800 Btu/hr-ft2.oF Outside film heat transfer coefficient for air, ht 2 Btu/hr-ft2.oF Thermal conductivity of the pipe,...
Help with a-g, answers given. Show work
The inner pipe of a double-pipe heat exchanger has an OD of 1.9 in. and contains 36 rectangular fins of the type shown in the sketch below. The fins are made of steel (k 34.9 Btu/h ft. "F) and are 0.5 in. high and 0.035 in. thi temperature is 250°F and the fluid in the annulus surrounding the fins is at 150°F with a heat-transfer c ck. The pipe wall ft2 、 c,...
B Steam flows in a steel pipe, which is insulated by gypsum plaster. The inner and outer diameter of the pipe are 8 cm and 6 cm respectively with pipe length of 20-m. The thickness of gypsum plaster which wraps the pipe is 4 cm. The heat transfer coefficient of the inner pipe and outer insulation are 800 W/m2.°C and 200 W/m2.°C with inner pipe temperature of 200°C and outer insulator temperature of 10°C. The thermal conductivity of the pipe...
a 0.4 m diameter, thin walled steel pipe is used to transport
saturated steam
Problem 3.049 A 0.4-m-diameter, thin-walled steel pipe is used to transport saturated steam at a pressure of 20 bars in a room for which the air temperature is 25°C and the convection heat transfer coefficient at the outer surface of the pipe is 20 W/m2-K. (a) What is the heat loss per unit length from the bare pipe (no insulation)? (b) Estimate the heat loss per...
Consider a pipe consisting of two layers:
Consider a pipe consisting of two layers: • an inner layer of AISI 1010 steel with thickness 2 cm, and • an outer layer of insulation (k = 0.034 W/(m · K)) with thickness 4 cm The pipe's contents keep the inner surface at a constant temperature of 120 °C, while the outside experiences convection with overall convection coefficient h 30 W/(m²K) to the surroundings at T = 25°C. The pipe's inner diameter...
a) what is the heat loss per unit length from the pipe in
W/m?
b) Estimate the heat loss per unit length if a 50 mm thick layer
of insulation with a conductivity of 0.058 W/m K. Neglect radiation
for this part.
3. A 0.20-m diameter, thin-walled steel pipe is used to transport saturated steam at a temperature of 486K in a room for which the air temperature is 25°C and convection heat transfer coefficient at the outer surface of...
Most questions answered within 3 hours.
-
Place letters corresponding to amounts in the proper order for
lightest to heaviest samples:
a) 2100...
asked 57 seconds ago -
Consider the multicore processor with 6 heterogeneous cores
labelled C1, C2, C3, C4, C5, and C6....
asked 3 minutes ago -
Document system components according to standards and procedures
(Implement and hand over system components) IT administrative
asked 3 minutes ago -
The college asked 700 students if they wanted a longer spring
break and 600 students said...
asked 3 minutes ago -
Determine the temperature (in Celsius) at which 1.00 mole of an
ideal gas will have a...
asked 27 minutes ago -
Japan’s combination of X and Y
Canada’s combination of X and Y
100x and 0y
50x...
asked 20 minutes ago -
[1] Household statistics include individuals living alone or in
groups in:
A) apartments.
B) military barracks....
asked 30 minutes ago -
What is the % w/v when 80 mL of a 2.0% solution is mixed with 50...
asked 34 minutes ago -
How can I solve the following using a TI83
Claim: Most adults would erase all of...
asked 47 minutes ago -
Analysis of 3-ethyl-3-buten-2-ol gave C, 72.13%; H, 11.92%.
Calculate the percent deviation of these results from...
asked 44 minutes ago -
Which VALS segment is most likely to have a top of the line
brand new (2015)...
asked 48 minutes ago -
Write a program to score the paper-rock-scissor game. Each of
two users types in either P,R...
asked 1 hour ago