1. Molecule A has a partition coefficient of 4 and a molecule B has partition coefficient of 2. Which molecule, will move faster across the membrane and why?
2. What is the osmolarity of 2M Fe2(SO4)3solution (write the units too)?
Answer
1. Molecule A with partition coefficient 4 will move faster across the membrane. The higher the partition coefficient, higher will be solubility and one with greater solubility will pass more quickly across the membrane.
2. Fe2(SO4)3 solution will dissociate into, Fe2(SO4)3 ------------>. 3Fe+ +SO4- (4 ions)
. Osmolarity = Molarity X dissociated ions
. = 2 mol/L X 4 ions
. = 6 Osmol/L
1. Molecule A has a partition coefficient of 4 and a molecule B has partition coefficient...
Molecule A has a partition coefficient of 2 and a molecule B has partition coefficient of 4. Which molecule will move faster across the membrane? Why?
4. What is the osmolarity of 3M Fe2(SO4)3 solution (Show calculations ; write the units too)?
Question 5 4 pts 5. Write an equation to show how Fe2(SO4)3 correctly splits apart into its IONS Fe2(SO4)3-> 3 Fe2+2 50,3 b. Fe2(SO4)3-> 2Fe+3 +3504? Fe (50s);-> 2Fe +352-0,1 d. Fe2(SO4)3-> 2Fe+9+352 . 1202 Fe2(SO4)3->2Fe +350 D Question 1 4 pts 1. Which molecule has polar bonds but is NOT a polar molecule? Please note: lone pairs have been omitted on surrounding atoms, but ARE shown on each central atom. H-O: O-C-0 O-CAS
A) B) Question 7 of 13 > Attempt 2 Solute S has a partition coefficient of 4.6 between water (phase 1) and hexane (phase 2). Calculate the concentration of solute S in hexane if [S]water is 0.020 M. [Shexane = If the volume of water is 67.0 mL and the volume of hexane is 20.0 mL, find the ratio of the moles of solute S in hexane to the moles of solute S in water. mol Sheuane mol Swaler Solute...
Solute A has a partition coefficient K = 2 for an extraction between water (phase 1) and benzene (phase 2). If 100 mL of a 0.01M solution of A in water is extracted one time with 300 mL benzene, what fraction will be extracted?
Na' Key Na transport channel Figure A Figure B For the figures above, the inner circle represents a cell which is surrounded by a solution. For the purposes of these questions, assume each molecule of Nat 1 M and each molecule of Ca2+ 2M. Assume each molecule of H2O represents 100 mL. Hint: Don't overthink these! I) Figure A: Suppose the cell pictured is at its normal volume and has a semipermeable membrane. Which of the 3 molecules in the...
B. Molecular size: What is the initial osmotic gradient when the RBC’s are placed in 300 mM methanol? What molecules contribute to the osmolarity of the cytoplasm? of the surrounding solution? Does the osmotic gradient change over time as the RBC’s remain in the 300 mM methanol solution? In this scenario, which molecules are moving across the membrane, the methanol or the molecules inside the cell? What causes these molecules to move? How do they cross the membrane? What affects...
3 2 Rate of molecule transport 1 Molecule concentration difference across plasma membrane humans, fructose, a disaccharide, is taken up from the intestine by facilitated transport. Respond to the following questions Adressing the transport of fructose molecules as shown in the diagram, above. the number of transport proteins is the same for the membranes with Rates 1, 2, and 3, which arrow corresponds to eatest concentration difference of fructose across the cell membrane? (Click to select) the fructose concentration difference...
1. An analyte has a partition coefficient of 2.0 between water and 1-pentanol. Given that 200 mL of a 5 % EtOH solution in water was extracted with 1-pentanol, calculate the fraction q of the analyte remaining in the aqueous phase (a) if one extraction of 200 mL is performed and (b) ten extractions of 100 mL are performed. (Hint: see page 49 in the manual. 2. For both 1a and 1b now calculate the Extraction Efficiency as a percentage
A solute with a partition coefficient of 3.5 is extracted from 10.0 mL of phase 1 into phase 2. What volume of phase 2 (in mL) is required to extract 99% of the solute from phase 1 in a single extraction?