A rope of negligible mass is wrapped around a 225-kg solid cylinder of radius 0.400 m. The cylinder is suspended several meters off the ground with its axis oriented horizontally, and turns on that axis without friction.
(a) If a 75.0-kg man takes hold of the free end of the rope and
falls under the force of gravity, what is his acceleration?
m/s2
(b) What is the angular acceleration of the cylinder?
rad/s2
A rope of negligible mass is wrapped around a 225-kg solid cylinder of radius 0.400 m....
A solid cylinder is mounted above the ground with its axis of rotation oriented horizontally. A rope is wound around the cylinder and its free end is attached to a block of mass 76.0 kg that rests on a platform. The cylinder has a mass of 275 kg and a radius of 0.480 m. Assume that the cylinder can rotate about its axis without any friction and the rope is of negligible mass. The platform is suddenly removed from under...
A bucket of water of mass 15.7 kg is suspended by a rope wrapped around a windlass, that is a solid cylinder with diameter 0.280 m with mass 11.4 kg . The cylinder pivots on a frictionless axle through its center. The bucket is released from rest at the top of a well and falls a distance 10.6 m to the water. You can ignore the weight of the rope. Part A What is the tension in the rope while...
A 2.7-kg 12-cm-radius cylinder, initially at rest, is free to rotate about the axis of the cylinder. A rope of negligible mass is wrapped around it and pulled with a force of 18 N. (a) Find the magnitude of the torque exerted by the rope. N · m (b) Find the angular acceleration of the cylinder. rad/s2 (c) Find the angular velocity of the cylinder at t = 0.70 s. rad/s
A bucket of water of mass 14.4 kg is suspended by a rope wrapped around a windlass, that is a solid cylinder with diameter 0.350 m with mass 13.0 kg . The cylinder pivots on a frictionless axle through its center. The bucket is released from rest at the top of a well and falls a distance 10.0 m to the water. You can ignore the weight of the rope. Take the free fall acceleration to be g = 9.80...
A uniform cylinder of mass 3.0 kg and radius 10.0 cm has a rope wrapped around its edge; a tension of 5.0 N is exerted on the rope. The cylinder rotates at a constantly increasing rate, starting from rest. 10DCH 1. A uniform cylinder of mass 3.0 kg and radius 10.0 cm has a rope wrapped around its edge; a tension of 5.0 N is exerted on the rope. The cylinder rotates at a constantly increasing rate, starting from rest....
A 2.20 kg mass is attached to a light cord that is wrapped around a pulley of radius 4.35 cm, which turns with negligible friction. The mass falls at a constant acceleration of 2.05 m/s2. Find the moment of inertia of the pulley.
A light cable is wrapped around a solid cylinder with mass M = 1.50 kg and radius R = 0.20 m as shown in the figure below. The cylinder rotates with negligible friction about a stationary horizontal axis. The free end of the cable is tied to a block of mass m = 0.50 kg. The block, initially at rest, is released at a height h = 1.00 m above the floor. As the block falls, the cable unwinds without...
A rope is wrapped around the rim of a large uniform solid disk of mass 225 kg and radius 2.50 m. The horizontal disk is made to rotate by pulling on the rope with a constant force of 195 N. If the disk starts from rest, what is its angular speed in rev/s at the end of 1.65 s?
A 250 kg disk of radius 1.5 meters has a rope wrapped around the rim. You pull on the end of the rope and increase the frequency of rotation by 1 Hz in 2 seconds. a. What is the angular acceleration in radians/s2? b. What is the force required to cause the acceleration in the last part?
6. A 25-kg solid cylinder with a radius of 11 cm, initially at rest, is free to rotate about the axis of the cylinder. A rope of negligible mass is wrapped around it and pulled with a force of 17 N. Assuming that the rope does not slip, determine the following a) The torque exerted on the cylinder by the rope b) The angular acceleration of the cylinder c) The angular speed of the cylinder after 0.5 s