What's the minimum number of flip-flops needed to build a synchronous binary counter capable of counting from 0 to 17 inclusive?
What's the minimum number of flip-flops needed to build a synchronous binary counter capable of counting...
9) Using JK flip flops and in the space below, design a synchronous counter that counts up from 0 to 5 and recycles to 0. (Positive edge triggered, PRE & CLR active low) Show all connections except the power and ground inputs to the flip flops.
Design a non-sequential synchronous counter using a positive edge triggered JK Flip Flops for the following output 0?2?3?5?4?7?6?0 Design a non-sequential synchronous counter using positive edge triggered JK Flip Flops for the following output 0 rightarrow 2 rightarrow 3 rightarrow 5 rightarrow 4 rightarrow 7 rightarrow 6 rightarrow 0
1) Design a synchronous 3-bit binary UP/DOWN counter uses the following counting pattern 10.2.3.7.6.40.1.3...) the counter will count in this pattern indefinitely when the input X is equal to 1. When the input the counter will reverse direction and count in the opposite pattern 0. 4 7310) Complete the state diagram, transition table, New state s and solve for the recitation equations for flipflops that will perform this function. (You do not need to draw the flip-flops Use the state...
Designa synchronous counter using jk flip flops with the following repeated sequence: 0,1,2,3
Using S-R flip-flops, design a 3-bit counter (C,B,A) with the repeating binary counting sequence: 1, 3, 2, 6, 7, 5, 4. - Show the circuit's state table with the present-state entries in ascending order, which should have the present state (t), next state (t+1), and flip-flop inputs. - Find the flip-flop input equations for RC, RB, and RA in Product of Sums form.
Design a modulo-3 binary counter using SR flip-flops.
(b)(i) Using T flip-flop as main components, design a 3-bit synchronous counter that perform counting as the following sequence 0,2,4,6,1,3,5,7 then repeats (its sequence) [20 marks] (ii) Draw a complete circuit to show how the T flip-flops are interconnected and label it appropriately. Also show how the counter can be asynchronous reset. [5 marks] (iii) Draw a timing diagram for at least four clock cycles [8 marks)
3. Construct a modulo-5 parallel (synchronous) down counter using master-slave T flip- flops. The counter should count in the sequence 0-4-3-2-1-0 and then back to 4, counting continuously. The counter stages are x,y and z, where z is the most significant bit. The Qoutputs are Qx, Qy and Qu. The T-inputs of the three stages are Tx, Ty and Tz. Use Karnaugh map method (truth table for Tinputs followed by K-map) to determine each of the T-inputs (not the short-cut...
(a) Design an asynchronous Binary Coded Decimal (BCD) count-up counter using JK flip-flops. Draw the counter circuit clearly showing the configuration of the JK flip-flops and the necessary logic gate(s). Sketch the input and output waveforms of this counter (7 Marks) (b) The binary up/down counter for a cargo lift controller in a 7-storey building has an up-down (UID) control input and a buzzer output (B). The buzzer will sound B 1) when the lift is at level 1 or...
Design serial (asynchronous) counter modulo 7 using synchronous flip-flops (T, D or JK). The counter should count up.