ZuoTi.Pro
Question

Please answer with clear hand writing. Thanks The annual peak load of the feeder is 3000...

Please answer with clear hand writing. Thanks

The annual peak load of the feeder is 3000 kW. Total copper loss at peak load is 300 kW. If the total annual energy supplied to the sending end of the feeder is 9000 MWh, determine the following:
a) The annual loss factor for an urban area
b) The annual loss factor for a rural area
c) The total amount of energy lost due to copper losses per year in part (a) and its value at $0.06/kWh
d) The total amount of energy lost due to copper losses per year in part (b) and its value at $0.06/kWh

engineering   Electrical-Engineering   
0 0
Add a comment Improve this question Transcribed image text
Next > < Previous
Sort answers by oldest

Homework Answers

Answer #1

0 0
Add a comment
Know the answer?
Add Answer to:
Please answer with clear hand writing. Thanks The annual peak load of the feeder is 3000...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions

  • The load data for a primary feeder of a power company for a typical winter day...

    The load data for a primary feeder of a power company for a typical winter day are as follows Street Lighting 1 AM to 6 AM 500 kW 7 AM 300 kW 8 AM to 5 PM 0 kW 6 PM 200 kW 7 PM 300 kW 8 PMto 12 AM 500 kW Residential Load 1 AM to 5 AM 100 kW 6 AM 250 kW 7 AM to 8 AM 400 kW 9 AM 300 kW 10 AM to...

  • 1) Use the data given in Example 2.1 and assume that the feeder has the peak loss of 72 kW at peak load and an annual lo...

    1) Use the data given in Example 2.1 and assume that the feeder has the peak loss of 72 kW at peak load and an annual loss factor of 0.14. Determine the following: a. The daily average load of the feeder: b. The average power loss of the feeder (Example 2.1 Assume that the loading data given in Table 2.1 belongs to one of the primary feeders of the No Light & No Power (NL&NP) Company and that they are...

  • 2.14 Repeat Example 2.12, assuming that there are eight houses connected on each DT and that there are a tot...

    2.14 Repeat Example 2.12, assuming that there are eight houses connected on each DT and that there are a total of 120 DTs and 960 residences supplied by the primary feeder Example 2.15 Assume that a 5 kW air conditioner would run 80 % of the time (80% duty cycle) and, during the peak hour, might be limited by utility remote control to a duty cycle of 65%. Determine the following a. The number of minutes of operation denied at...

  • 14. The following details are known about a 200 hp, 500 V, 435 rpm de shunt motor: full-load current is 330 A, insulation class is H, weight is 3400 kg, external diameter of the frame is 915 mm a...

    14. The following details are known about a 200 hp, 500 V, 435 rpm de shunt motor: full-load current is 330 A, insulation class is H, weight is 3400 kg, external diameter of the frame is 915 mm and length of the frame is 1260 mm. If the motor is running at full-load, calculate: a. the total losses and efficiency. b, the approximate shunt field exciting current if the shunt field causes 15% of the total losses. the value of...

  • Consider a house in Blacksburg, Virginia. The typical annual space-heating load for this size of a...

    Consider a house in Blacksburg, Virginia. The typical annual space-heating load for this size of a house is 100 x105 Btu. That is, with no insulation in the attic, we lose about 100 x 105 Btu per year. With insulation in the attic the amount of heat lost each year will be reduced. The value of energy savings that results from adding insulation and reducing heat loss is dependent on what type of residential heating furnace is installed. Assume that...

  • A small coastal town in Queensland is subject to an increasing permanent population and also a...

    A small coastal town in Queensland is subject to an increasing permanent population and also a transient influx of tourists during the summer period. Council already receives frequent complaints of restricted water supply. The water supply system comprises a rising trunk main from the treatment plant A to the service reservoir B, the service reservoir, and service mains to the consumption areas. Two consumption areas C and D at different elevations are gravity supplied from the service reservoir. The service...

  • Please answer as many as possible!! QUESTION 10 As the hydrogen ion [H +] concentration in...

    Please answer as many as possible!! QUESTION 10 As the hydrogen ion [H +] concentration in a solution decreases, the hydroxide ion [OH -] concentration increases and the pH increases. decreases and the pH increases. increases and the pH decreases. decreases and the pH stays the same. decreases and the pH decreases. 1 points    QUESTION 11 Environmental science is a theoretical approach in interpreting the environment. way to see the world in scientific terms. narrowly defined set of physical,...

  • summarizr the followung info and write them in your own words and break them into different...

    summarizr the followung info and write them in your own words and break them into different key points.   6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...

  • summatize the following info and break them into differeng key points. write them in yojr own...

    summatize the following info and break them into differeng key points. write them in yojr own words   apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...

  • Please read the article and answer about questions. You and the Law Business and law are...

    Please read the article and answer about questions. You and the Law Business and law are inseparable. For B-Money, the two predictably merged when he was negotiat- ing a deal for his tracks. At other times, the merger is unpredictable, like when your business faces an unexpected auto accident, product recall, or government regulation change. In either type of situation, when business owners know the law, they can better protect themselves and sometimes even avoid the problems completely. This chapter...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT