7.35. Methane is compressed adiabatically in a pipeline pumping station from 3500 kPa and 35°C to...
7.35. Methane is compressed adiabatically in a
pipeline pumping station from 3500 kPa
and 35°C to 5500 kPa at a rate of 1.5 kg mol⋅s−1. If the compressor
efficiency is
0.78, what is the power requirement of the compressor and what is
the discharge
temperature of the methane?
Homework Answers
using definition of compressor efficiency and adibatic work we can find the power and discharge temperature of methane.
For any calrification on solution please write in comments
Add Answer to:
7.35. Methane is compressed adiabatically in a
pipeline pumping station from 3500 kPa
and 35°C to...
If methane (assumed to be in its ideal-gas state) is compressed adiabatically from 20 degree celcius...
If methane (assumed to be in its ideal-gas state) is compressed adiabatically from 20 degree celcius and 140 kPa to 560 kPa, estimate the work requirement and the discharge temperature of the methane. The compressor efficiency is 0.75.
Air is compressed steadily and adiabatically from 17 C and 97 kPa to 276 C and...
Air is compressed steadily and adiabatically from 17 C and 97 kPa to 276 C and 604 kPa. Assuming constant specific heats for air at room temperature, what is the isentropic efficiency of the compressor?
Consider a closed Brayton cycle heat-engine. Air is compressed from 300K, 100 kPa to 580K, 700...
Consider a closed Brayton cycle heat-engine. Air is compressed from 300K, 100 kPa to 580K, 700 kPa. The air is heated at the rate of 950 kJ/kg before it enters the turbine. The isentropic efficiency of the turbine is 86%. Determine: a) the fraction of the turbine shaft power used to drive the compressor, and b) the thermal efficiency of the engine. Sketch the prooess on a T-s diagram. Do the calculation first with variable specific heats and then repeat...
An equimolar mixture Of methane and propane 's discharged from a compressor at 5,500 kPa and...
An equimolar mixture Of methane and propane 's discharged from a compressor at 5,500 kPa and 900 oC at the rate of 1.4 kg a) If the velocity in the discharge line is not to exceed 30 m s-i, as an engineer, calculate what is the minimum diameter of the discharge line? b) What will be the impact towards society, health, safety, and/or environment if the engineer used diameter Of discharge line less than the minimum diameter found in part...
Nitrogen gas is compressed adiabatically in a steady-flow, steady-state process from 0.1 MPa and 25oC at...
Nitrogen gas is compressed adiabatically in a steady-flow, steady-state process from 0.1 MPa and 25oC at a rate of 0.2 kg/s. The air exits the compression at a temperature of 125oC. Assuming cold-air constant properties, use the values found in Table A-2(a) and determine the exit pressure [kPa] by using the polytropic relationship using n=k.
For a gas compressor compresses gas (Cv= 718 J/KgK and Cp= 1005 J/KgK) adiabatically from 1...
For a gas compressor compresses gas (Cv= 718 J/KgK and Cp= 1005 J/KgK) adiabatically from 1 bar and 15 ºC to 10 bar with an isentropic efficiency of 0.89. The gas flow rate is 5 kg/s. Calculate the temperature after compression and the power input
A pump operates adiabatically with liquid water entering at T1 25 °C P, = 1 bar with a mass flow ...
A pump operates adiabatically with liquid water entering at T1 25 °C P, = 1 bar with a mass flow rate of 100 kg/s. The exhaust pressure is 20 bar and the pump efficiency is 0.75 (i) Determine the actual power requirement of the pump and the temperature of the discharged water 7 marks) (İİ) What is the rate of entropy generation of the adiabatic irreversible process?
A pump operates adiabatically with liquid water entering at T1 25 °C P,...
Refrigerant-134a enters the condenser of a residential heat pump at 800 kPa and 35°C at a...
Refrigerant-134a enters the condenser of a residential heat pump at 800 kPa and 35°C at a rate of 0.018 kg/s and leaves at 800 kPa as a saturated liquid. If the compressor consumes 1.2 kW of power, determine (a) the COP of the heat pump and (b) the rate of heat absorption from the outside air.
Q3: Air is compressed steadily by a reversible compressor from an inlet state of 100 kPa and 27 C...
Q3: Air is compressed steadily by a reversible compressor from an inlet state of 100 kPa and 27 C to an exit pressure of 900 kPa. Determine the compressor work with the mass flow rate of 0.12 kg/s;(R-0,287 kJ/kgK) 0 a) Polytropic compression with n-1.3, b) Ideal two stage compression with intercooling with a polytropic exponent of 1 .3. Hava särekli akh, tersinir bir kompresörde 100 kPa basinç ve 27 C sicakliktan, 900 kPa basinca sikaşturidmaktadur. Akgkarun kätle debisinin 0.12...
The centrifugal compressor shown here compresses air from 100 kPa, 27 °C to 600 kPa. This...
The centrifugal compressor shown here compresses air from 100 kPa, 27 °C to 600 kPa. This compressor has an isentropic efficiency of 85%. What is the air temperature at the compressor outlet and how much power does it require if the air volumetric flow rate is 9 m3/min at the compressor inlet? ideal has-hi 1 halt hasthi K- K TI OUT CH 300 =.599 Tas AR ENTERS f1technical.net .S99T25=100
Consider a closed Brayton cycle heat-engine. Air is compressed from 300K, 100 kPa to 580K, 700 kPa. The air is heated at the rate of 950 kJ/kg before it enters the turbine. The isentropic efficiency of the turbine is 86%. Determine: a) the fraction of the turbine shaft power used to drive the compressor, and b) the thermal efficiency of the engine. Sketch the prooess on a T-s diagram. Do the calculation first with variable specific heats and then repeat...
A pump operates adiabatically with liquid water entering at T1 25 °C P, = 1 bar with a mass flow rate of 100 kg/s. The exhaust pressure is 20 bar and the pump efficiency is 0.75 (i) Determine the actual power requirement of the pump and the temperature of the discharged water 7 marks) (İİ) What is the rate of entropy generation of the adiabatic irreversible process?
A pump operates adiabatically with liquid water entering at T1 25 °C P,...
Q3: Air is compressed steadily by a reversible compressor from an inlet state of 100 kPa and 27 C to an exit pressure of 900 kPa. Determine the compressor work with the mass flow rate of 0.12 kg/s;(R-0,287 kJ/kgK) 0 a) Polytropic compression with n-1.3, b) Ideal two stage compression with intercooling with a polytropic exponent of 1 .3. Hava särekli akh, tersinir bir kompresörde 100 kPa basinç ve 27 C sicakliktan, 900 kPa basinca sikaşturidmaktadur. Akgkarun kätle debisinin 0.12...
The centrifugal compressor shown here compresses air from 100 kPa, 27 °C to 600 kPa. This compressor has an isentropic efficiency of 85%. What is the air temperature at the compressor outlet and how much power does it require if the air volumetric flow rate is 9 m3/min at the compressor inlet? ideal has-hi 1 halt hasthi K- K TI OUT CH 300 =.599 Tas AR ENTERS f1technical.net .S99T25=100
Most questions answered within 3 hours.
-
Why does entrepreneurs trying to employ AI into their
business organizations? What are the advantages and...
asked 1 minute from now -
Hello, I need some help creating this class in Java. This is for
a larger project....
asked 41 seconds ago -
// This program is supposed to display every fifth year
// starting with 2017; that is,...
asked 29 seconds ago -
for each of the following situation, explain in what way the
experimentally determine molecular weight would...
asked 6 minutes ago -
Meiosis makes _____ cells, mitosis makes _____ cells
diploid, haploid
No answer text provided.
diploid, diploid...
asked 12 minutes ago -
13. An object slides on a horizontal surface and comes to rest
with an acceleration of...
asked 14 minutes ago -
Beta Enterprises, Inc. has a WACC of 11% and is considering a
project that requires a...
asked 14 minutes ago -
1. Interferons elicit two types of responses to virus-infected
cells. What are these?
2. What are...
asked 25 minutes ago -
Manufacturer Limited ("Manufacturer") is a
dealer in carbon fiber. Stick Limited ("SL") makes
hockey sticks. On...
asked 31 minutes ago -
Two samples of n = 5 subjects were analyzed with an
independent-samples t-test, producing a t...
asked 31 minutes ago -
A bag of rice weighs 2.00 lb on Earth. What would it weigh on
the Moon,...
asked 35 minutes ago -
Discuss this concept: "In an economy without FIs, the level of
fund flows between household savers...
asked 41 minutes ago