List 6 semiconductor carbon nanotubes (n,m) in order from smallest to largest band gap.
List 6 metallic carbon nanotubes
Answer:-
6 Semiconductor carbon nanotubes are (n,m):-
1:- (13,0)
2:- (11,0)
3:- (10,0)
4:- (8,0)
5:- (7,0)
6:- (5,0)
6 Metallic carbon nanotubes are:-
1:- (12,0)
2:- (9,0)
3:- (6,0)
4:- (4,1)
5:- (3,0)
6:- (1,1)
Carbon nanotubes (CNTs) can be classified into two main categories based on their band gap: semiconductor CNTs and metallic CNTs. The band gap of CNTs is determined by their (n, m) indices, where n and m are integers that define the tube's chirality.
Semiconductor Carbon Nanotubes (in order of smallest to largest band gap): (5,0), (4,2), (3,3), (6,0), (8,0), (9,0)
Metallic Carbon Nanotubes (in no particular order): (5,5), (10,0), (7,0), (6,6), (12,0), (9,9)
Please note that the band gap of CNTs can be affected by various factors, and the values provided here are general trends. The exact band gaps may vary based on different experimental conditions and the specific arrangement of carbon atoms in the nanotubes.
List 6 semiconductor carbon nanotubes (n,m) in order from smallest to largest band gap. List 6...
A photovoltatic cell created from a semiconductor with band gap 1.4 eV is coated on its top (light receiving) surface with another semiconductor with band gap 2.5 eV. Compute the maximum potential fraction of incident radiation converted to useful power if this cell is illuminated by light with wavelengths uniformly distributed between 400 and 700 nm. Assume the top semiconductor layer does not contribute to electrical power production.
The energy gap between the valence band and the conduction band in the widely-usd semiconductor gallium arsenide (GaAs) is A- 1.424 ev. (k 8.617x105 eV/K) At T 0 K the valence band has all the electrons. At T 0 K (shown), electrons are thermally excited across the gap into the conduction band, leaving an equal number of holes behind. Conduction band Energy gap, A Valence band 1) The density of free electrons (ne number per volumer) in a pure crystal...
6. For each set of elements below, make a list of the largest radius, smallest radius, highest first ionization energy, lowest first ionization energy, most metallic, and least metallic. It may help to design a table that lists the elements in the first column and then has 6 headings to answer the other questions. a. Na, K, Rb, Cs b. B, N, F.Ne c. C, Ge, Sn, Pb
3. Many parameters of crystals are dependent on the band gap. a) From the optical absorption spectrum of a certain semiconductor, one finds that the longest wavelength of radiation absorbed is 1.40 m. What is the band gap for this semiconductor? Explain how the band gap gives rise to this behavior. b) What band gap would be needed to make blue (450 nm) LEDs? Explain why. c) Most of the sun's radiation has wavelengths shorter than 1000 nm. For a...
Please help me to put these in order from smallest to largest asymptotically: n! n log n n^2 n 2^n log n
List the correct order of lengths, from the smallest to the largest. nanometer, meter, kilometer, ls, AU, ly meter, nanometer, kilometer, ls, AU, ly nanometer, meter, kilometer, AU, ls, ly nanometer, meter, kilometer, ls, ly, AU
List the following compounds in order of decreasing boiling point: Rank from largest to smallest. To rank items as equivalent, overlap them. Reset Help CH3CH2CH2CH3 CH3CH2CH2CH2OH CH3CH2OCH,CH; highest boiling point lowest boiling point The correct ranking cannot be determined.
Order the following three solutions from smallest to largest pH: 0.20 M HClO3 0.0030 M HNO3 1.50 M HCl
Order the following functions in increasing asymptotic order from smallest to largest, using an = to indicate functions that are asymptotically equal. You may assume that n is the only non constant variable.
semiconductor devices . Electron-hole recombination in direct band-gap semiconductors is known to yield photons. (0) For which application this property is used? Explain briefly (ii) Calculate the primary wavelength of photons emitted from InP as a result of such recombination. (ii) Is it possible to see the emitted photons? Explain briefly (iv) Suppose you desire to detect the radiation from a GaP laser, can you use a Ge photodetector for that purpose? Explain briefly