Question

A sluice gate is useful in controlling the water flow out of a reservoir by allowing...

A sluice gate is useful in controlling the water flow out of a reservoir by allowing flow to pass under it. For a 6 ft deep reservoir and an 8 ft wide gate, estimate how high you would have to raise the gate to allow for 150 ft3/s outflow.

0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
A sluice gate is useful in controlling the water flow out of a reservoir by allowing...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Problem 12.29 8 of 13 1 Review Water flow passes under the sluice gate. Suppose that...

    Problem 12.29 8 of 13 1 Review Water flow passes under the sluice gate. Suppose that Y1 = 6 m and y2 = 1.4 m. (Figure 1) Part A Determine the volumetric flow of water through the gate. Express your answer to three significant figures and include the appropriate units. Figure < 1 of 1 0 μΑ ? 4 m Q = Value Units Submit Request Answer Problem 12.29 < 8 of 13 Review Water flow passes under the sluice...

  • 4) The flow of water from a reservoir is controlled by a 5-ft-wide L-shaped gate hinged...

    4) The flow of water from a reservoir is controlled by a 5-ft-wide L-shaped gate hinged at point A, as shown. If it is desired that the gate open when the water height is 12 ft, determine the mass of the required weight W. 8 ft Gate 15 ft 12 ft

  • A flow passes under the sluice gate. At the depth y0 = 12 ft the water is essentially at rest.

     A flow passes under the sluice gate. At the depth y0 = 12 ft the water is essentially at rest. (Figure 1) Part A Determine the volumetric flow through the channel as a function of depth yz measured in fit 

  • A flow of 7200 ft3/min passes under the sluice gate. At depth yo = 6.5 ft...

    A flow of 7200 ft3/min passes under the sluice gate. At depth yo = 6.5 ft the water is essentially at rest. (Figure 1) Y2 = 1.71 ft Submit Previous Answers Correct Figure < 1 of 1 Part B 4 ft Determine the depth yi just before the gate. Express your answer to three significant figures and include the appropriate units. μΑ ? y = 4.93 yo Submit Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining Water...

  • EXPERIMENT 4 FLOW UNDER A SLUICE GATE AND THE HYDRAULIC JUMP 4.1 Introduction The sluice gate provides acenv...

    EXPERIMENT 4 FLOW UNDER A SLUICE GATE AND THE HYDRAULIC JUMP 4.1 Introduction The sluice gate provides acenvenient means of flow regulation, especially in irrigation and drairage schemses where low has to be distributed in notworks of interconnected chanmels. The gane is peovided wih a lifting mechanis so at the aperture beeeath it may be set to any desired position When closed, the sperture is closed so that no Bow ca pass through the gale. In this experiment we measure...

  • Suppose a gauge at the outflow of a reservoir measures the flow rate of water in...

    Suppose a gauge at the outflow of a reservoir measures the flow rate of water in units of ft /hr. The total amount of water that flows out of the reservoir is the area under the flow rate curve. Consider the flow rate function shown in the figure to the right. Complete parts (a) through (d) below. /hr) 100001 Water flow rate ( 8000 6000- 4000- 2000- as 10 Time (hr) a. Find the amount of water that flows out...

  • 1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver...

    1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver vessel which is maintained at p4 6 bar (absolute) through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are as shown. All valves are gate valves (k = 0.15)...

  • 1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver...

    1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver vessel which is maintained at p4 6 bar (absolute) through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are as shown. All valves are gate valves (k = 0.15)...

  • Hydrology ENV 321 Homework #1 Due: Friday, September 6 at 1:00pm 1. Convert (show all conversion...

    Hydrology ENV 321 Homework #1 Due: Friday, September 6 at 1:00pm 1. Convert (show all conversion steps for full credit; convert only one unit for cach step as demonstrated in class): a) acre-feet/day to mgd (mgd is million gallons per day] b) cfs to cms c) inches/hr rainfall to mm/day rainfall d) short tons/acre-day to Mg/hectare-year [Mg is megagrams e) inches"F to cm/ C [be careful, this one may trick you] 2. Define the hydrologic cycle component and indicate how...

  • I am a student in mechanical engineering. I would like to solve this question in the...

    I am a student in mechanical engineering. I would like to solve this question in the material of turbocharged engines with me an hour .. Thank you Q3) A centrifugal pump has a suction left of 2.6 m and supply water to a tank which is at a vertical high of 18 m above the center line of the pump. The diameter of the suction pipe is 30 cm and it is 8 m long. At the end of the...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT