The construction of a new embankment induces a uniform load of 18kN/m^2 on the top of...
The construction of a new embankment induces a uniform
load of 18kN/m^2 on the top of a 12 meter thick layer of saturated
clay, whose characteristics are as follows:
bulk unit weight γ=16kN/m^3
intial void ratio is 1.8
compression index Cc= 0.7
the water table is at the initial ground level top of
the clay laye. Assuming the clay is normally consolidated.
a) Estimate the settlement of the clay layer after the realization
of the embankment.
b) Compare results obtained by dividing the clay layer in 3
sub-layers.
Homework Answers
Add Answer to:
The construction of a new embankment induces a uniform
load of 18kN/m^2 on the top of...
relatively 5E m2/sec The 2. A new, wide highway embankment is planned deposit of doubly-drained, saturated clay soil wi...
relatively 5E m2/sec The 2. A new, wide highway embankment is planned deposit of doubly-drained, saturated clay soil with c settlement analysis of the 10 m thick clay layer yielded consolidation settlement of 800 mm for the new embankment loading. Determine and plot the settlement of the clay layer (as measured at the ground surface) at 0, 0.49, 3.12, 6.39, 13.44, and 18.44 years. recent across a an estimated
relatively 5E m2/sec The 2. A new, wide highway embankment is...
geotechnical engineering The soil profile at a site consists of a clay layer 10 m thick,...
geotechnical engineering
The soil profile at a site consists of a clay layer 10 m thick, sandwich between two sand layers. The top sand layer has a density of 1.9 Mg/m² and is 5 m thick. Below this layer is a 10 m thick clay layer with a saturated density of 1.8 Mg/m' and a saturated water content 42%. The deeper sand layer has a saturated density of 1.9 Mg/m² and extend to the depth investigated at the site. The...
Problem 2. [2596] Figure 2 shows a soil profile. The uniformly distributed load on the ground...
Problem 2. [2596] Figure 2 shows a soil profile. The uniformly distributed load on the ground surface is (1) Estimate the primary consolidation settlement of the clay layer due to the application of Ap. (2) If the clay layer is preconsolidated and the average preconsolidation pressure is 80 kPa, what will be the expected primary consolidation settlement if the recompression index is C 0.2 x Cc? p 87 kPa 1 m Dry Sand Sand: Saturated Sand Dry Unit weight: 14.6...
Two undisturbed clay samples were taken from the middle of the overconsolidated and normally consolidated clay layers in the soil profile shown. The water table is at the top of the overconsolidated c...
Two undisturbed clay samples were taken from the middle of the
overconsolidated and normally consolidated clay layers in the soil
profile shown. The water table is at the top of the
overconsolidated clay layer. Consolidation tests were carried out
on the two samples and the results are summarized in the table
below. Assume that the bulk, dry, and saturated unit weights of the
sand are 16 kN/m3, 16 kN/m3 and 19
kN/m3, respectively. The specific gravity of the clay
soil...
Problem 7 The soil profile at a site consists of a top 4 m layer of...
Problem 7 The soil profile at a site consists of a top 4 m layer of dense sand followed by 2 m of clay, which is underlain by a stiff stratum. The water table is at 2 m below the ground level. The following data was obtained from a consolidation test on an undisturbed sample obtained from the middle of the clay layer: water content 5 36%, specific gravity of the clay grains = 2.72, compression index = 0.72, recompression...
Question 5 (20 marks) A I-m thick, c applied on the top surface of the clay using Sheepsfoot rollers t Ily-saturate...
Question 5 (20 marks) A I-m thick, c applied on the top surface of the clay using Sheepsfoot rollers t Ily-saturated clay is resting on a dry sand when a uniform load of 200 kN/m2 is expedite consolidation process For the saturated clay layer, the initial void ratio of 5.0, specific gravity of 2.65, pre-consolidation ression index of 0.2, and the stress of 20 kN/m2: the compression index of 0.5, the recomp coefficient of consolidation of 0.001 cm2 s" a)...
Please, show step by step and clearly. problem 9.17, (Use 3 equally divided sub-layers for the 15...
Please, show step by step and clearly. problem 9.17, (Use 3
equally divided sub-layers for the 15 m clay layer). thanks
please, resolve question 9.17 (Use 3 equally divided sub-layers
for the 15 m clay layer)
9.16 The soil profile and the loading condition are given in the followin n) figure. Total new footing stress including the foundation at z 2 is 400 kN/m2. The soil profile has a rather thick clay layer (15 so that the layer should be...
Question 2 [Marks: 15 +10=25] 200kPa of construction stress was applied on top of the soil...
Question 2 [Marks: 15 +10=25] 200kPa of construction stress was applied on top of the soil layers as shown in the figure below. (1) Calculate the settlement in the clay layer due to the construction (minimum of 2 sub layers is to be used). (W) If the soil went through 90% average degree of consolidation in 1 year, calculate the coefficient of consolidation (C.). 个 Sand Y = 20kN/m 4m Water table Clay (over consolidated) y = 16kN/m 100 4m...
relatively 5E m2/sec The 2. A new, wide highway embankment is planned deposit of doubly-drained, saturated clay soil with c settlement analysis of the 10 m thick clay layer yielded consolidation settlement of 800 mm for the new embankment loading. Determine and plot the settlement of the clay layer (as measured at the ground surface) at 0, 0.49, 3.12, 6.39, 13.44, and 18.44 years. recent across a an estimated
relatively 5E m2/sec The 2. A new, wide highway embankment is...
geotechnical engineering
The soil profile at a site consists of a clay layer 10 m thick, sandwich between two sand layers. The top sand layer has a density of 1.9 Mg/m² and is 5 m thick. Below this layer is a 10 m thick clay layer with a saturated density of 1.8 Mg/m' and a saturated water content 42%. The deeper sand layer has a saturated density of 1.9 Mg/m² and extend to the depth investigated at the site. The...
Problem 2. [2596] Figure 2 shows a soil profile. The uniformly distributed load on the ground surface is (1) Estimate the primary consolidation settlement of the clay layer due to the application of Ap. (2) If the clay layer is preconsolidated and the average preconsolidation pressure is 80 kPa, what will be the expected primary consolidation settlement if the recompression index is C 0.2 x Cc? p 87 kPa 1 m Dry Sand Sand: Saturated Sand Dry Unit weight: 14.6...
Two undisturbed clay samples were taken from the middle of the
overconsolidated and normally consolidated clay layers in the soil
profile shown. The water table is at the top of the
overconsolidated clay layer. Consolidation tests were carried out
on the two samples and the results are summarized in the table
below. Assume that the bulk, dry, and saturated unit weights of the
sand are 16 kN/m3, 16 kN/m3 and 19
kN/m3, respectively. The specific gravity of the clay
soil...
Problem 7 The soil profile at a site consists of a top 4 m layer of dense sand followed by 2 m of clay, which is underlain by a stiff stratum. The water table is at 2 m below the ground level. The following data was obtained from a consolidation test on an undisturbed sample obtained from the middle of the clay layer: water content 5 36%, specific gravity of the clay grains = 2.72, compression index = 0.72, recompression...
Question 5 (20 marks) A I-m thick, c applied on the top surface of the clay using Sheepsfoot rollers t Ily-saturated clay is resting on a dry sand when a uniform load of 200 kN/m2 is expedite consolidation process For the saturated clay layer, the initial void ratio of 5.0, specific gravity of 2.65, pre-consolidation ression index of 0.2, and the stress of 20 kN/m2: the compression index of 0.5, the recomp coefficient of consolidation of 0.001 cm2 s" a)...
Please, show step by step and clearly. problem 9.17, (Use 3
equally divided sub-layers for the 15 m clay layer). thanks
please, resolve question 9.17 (Use 3 equally divided sub-layers
for the 15 m clay layer)
9.16 The soil profile and the loading condition are given in the followin n) figure. Total new footing stress including the foundation at z 2 is 400 kN/m2. The soil profile has a rather thick clay layer (15 so that the layer should be...
Question 2 [Marks: 15 +10=25] 200kPa of construction stress was applied on top of the soil layers as shown in the figure below. (1) Calculate the settlement in the clay layer due to the construction (minimum of 2 sub layers is to be used). (W) If the soil went through 90% average degree of consolidation in 1 year, calculate the coefficient of consolidation (C.). 个 Sand Y = 20kN/m 4m Water table Clay (over consolidated) y = 16kN/m 100 4m...
Most questions answered within 3 hours.
-
Write a program to solve the Josephus problem, with the following
modification:
Sample Input:
./a.out n...
asked 1 hour ago -
At the start of a CD it is spinning at a rate of 525 rpm
(revolutions...
asked 2 hours ago -
4. Without doing any calculations, predict whether the observed
∆T would increase, decrease or remain the...
asked 3 hours ago -
Based on the range, which of the following sets of scores has
the greatest variability? 3,...
asked 4 hours ago -
Ripples in a pond travel at a velocity of 3 m/s with one peak
passing a...
asked 4 hours ago -
A man stands on the roof of a building of height 13.0 mm and
throws a...
asked 4 hours ago -
The extent to which assets are financed by borrowed funds and
other liabilities is indicated by:...
asked 5 hours ago -
Explain in detail
Germany is the fifth largest economy
explain what goods and services Germany specializes...
asked 5 hours ago -
The density of platinum is 21.45 g/mL. If a cube of platinum
with a mass of...
asked 5 hours ago -
Accounts Receivable
Sales
A/R Posting
Extended Sales Invoice
Packing Slip
Compare invoice to packing slip 2...
asked 6 hours ago -
Michaella, age 23, is a full-time law student and is claimed by
her parents as a...
asked 6 hours ago -
Why are polymers not typically casted into products?
asked 6 hours ago