7. derive the Bragg's condition to obtain an XRD pattern four marks
8. compare the powder x-ray pattern of NaCl and KCl solid five marks
7. derive the Bragg's condition to obtain an XRD pattern four marks 8. compare the powder...
Numerical Methods Consider the following IVP dy=0.01(70-y)(50-y), with y(0)-0 (a) [10 marks Use the Runge-Kutta method of order four to obtain an approximate solution to the ODE at the points t-0.5 and t1 with a step sizeh 0.5. b) [8 marks Find the exact solution analytically. (c) 7 marks] Use MATLAB to plot the graph of the true and approximate solutions in one figure over the interval [.201. Display graphically the true errors after each steps of calculations. Consider the...
could you please answer this question QUESTION 2 Consider a system with an open-loop trans fer function given by Y(s) s+7 U(s) s2 +3s-8 (a) (8 marks) Derive a state-space model for the system in canonical form. (b) (4 marks) Check the observability of the system. (c) 8 marks) Design a suitable full-order state observer for the system. Explain your choice of the observer's poles. d) (10 marks) Design a PI controller for the system so the output of the...
Please solve Q 7 & 8 7. 14+6 marks] Consider the initial value problem y_y2, 2,y(1) = 1 y'= 1-t (a) Assuming y(t) is bounded on [1, 2], Show that f(t,v)--satisfies Lipschitz condition with respect to y. (b) Use second order Taylor method with h 0.2 to approximate y(1.2), then use the Runge- Kutta method: to compute an approximation of y(1.4). 8. [4 marks) Assuming that a1, o2 are non negative constants, determine the parameters o and β1 of the...
7. Evaluate the following integral. b) SO3(2-1)05 dz c) f (xl dx (15 marks) 8. A shaded region S is bounded by the curve y = the x-axis, the vertical lines x = 1 and x = V2. The x(4-2)1/4 region is rotated through 21 radians about x-axis to form a solid of revolution. Compute the exact volume of the solid of revolution formed. (10 marks) 9. Between the two towers of a suspension bridge that are 2 kilometres apart,...
Design and implement a combinational circuit with four inputs w,x, y and z and four outputs A, B ,C and D using CMOS transistors. When the binary input is 0, 1, 2,3,4,5,6 or 7 the binary output is five greater than the input. When the binary input is 8,,10,11,12,13,14 or 15 the binary output is seven less than the input. for question (a) find the troth table for the inputs (ABCD) then implement using K-map to find the equations to...
QUESTION 7 CASE STUDY 16: Determine which of the following CPT should be reported for the OP services. A. 93452, 93454 B. 93459 C. 93458 D. 93461 10 points QUESTION 8 CASE STUDY 16: Which statement from the procedural record indicates that a left heart catheterization was performed? (This question counts as 0 points, since it meant to demonstrate the differences between arteriography and a heart catheterization.) A. Approximate 60-70% stenosis in the midportion of the posterior descending coronary...
QUESTION 7 CASE STUDY 16: Determine which of the following CPT should be reported for the OP services. A. 93452, 93454 B. 93459 C. 93458 D. 93461 10 points QUESTION 8 CASE STUDY 16: Which statement from the procedural record indicates that a left heart catheterization was performed? (This question counts as 0 points, since it meant to demonstrate the differences between arteriography and a heart catheterization.) A. Approximate 60-70% stenosis in the midportion of the posterior descending coronary...
Project 7-1: Classify Patient Incidents According to Policy This primary source of information on patient safety will be used to analyze the incidents according to level of severity. The following policies define the three categories of severity Policy on Level I Event: An incident that resulted in patient death or serious short or long-term (6 weeks or more) disability or harm Policy on Level II Event: An incident that resulted in minimal short-term patient disability or harm Policy on Level...
Problem 3: Design Problem On Figure P3a, you have a Common Source (CS) n-channel MOSFET amplifier. Notice the absence of a source resistor Rsig and load resistor R. If we know how the present amplifier (the one on Figure P3a) behaves without Rsig and RL, we can infer its behaviors if Rsig and R were to be added. design the amplifier circuit on Figure P3a, i.e., you have to find appropriate values for RGj You are to RG,, RD, and...
Code the following reports utilizing CPT codes, ICD-10-CM codes, and apply any applicable modifiers. Assignment #1 Description: The right upper lobe wedge biopsy shows a poorly differentiated non-small cell carcinoma with a solid growth pattern and without definite glandular differentiation by light microscopy. GROSS DESCRIPTION: A. Received fresh labeled with patient's name, designated 'right upper lobe wedge', is an 8.0 x 3.5 x 3.0 cm wedge of lung which has an 11.5 cm staple line. There is a 0.8 x...