An AM transmitter with a carrier power of 20 kW is connected to a 50 Ω antenna. In order to design a lightning arrestor for the antenna, it is necessary to know the maximum instantaneous voltage that will appear at the antenna terminals. Calculate this voltage, assuming 100 modulation for the transmitter.
Hint: For 100 % modulation, Emax = 2 × Ec (peak)
An AM transmitter with a carrier power of 20 kW is connected to a 50 Ω...
What is the total average power for a commercial AM transmitter with an unmodulated carrier power of 20 kW and 100% modulation? 20 kW 30 kW 53.34 kW 80 kW
A radio transmitter is connected to an antenna having impedance 8 + j40 Ω with a 50 coaxial cable. If the transmitter can deliver 30 W to the load, how much power is delivered to the antenna? a. (10 Marks) b. Alossless 50 ohms transmission line is connected to unknown load impedance. Voltage measurements along the line reveal that the maximum and minimum voltage values are (1)volts and (V2 - 1)volts respectively. The distance at which maximum voltage is observed...
An AM receiver is tuned to broadcast station at 600 kHz. Calculate the image rejection in dB, assuming that the input filter consist of one tuned circuit with a Q of 40? An SSB system transmit a peak envelope power of 100 W into a 75 ohms load. The carrier signal is modulated by two tones, with frequencies 2 kHz and 3 kHz with equal magnitude and only the lower sideband is transmitted with a suppressed carrier. Determine the average...
Assume that an AM transmitter is modulated with a video testing signal given by em(t) = =20 + 60 sin (2πf1t), where f1 = 3.57 MHz. Let the carrier signal c(t) = Ac cos(2πfct), where Ac = 100 and fc = 100 MHz. The AM signal is fed into a 50-Ω load. (a) Derive an expression for the AM DSB-FC signal in time domain. (b) Construct the AM waveform, giving numerical values of the maximum amplitude, Amax and the minimum...
An AM receiver is tuned to broadcast station at 600 kHz. Calculate the image rejection in dB, assuming that the input filter consist of one tuned circuit with a Q of 40? An SSB system transmit a peak envelope power of 100 W into a 75 ohms load. The carrier signal is modulated by two tones, with frequencies 2 kHz and 3 kHz with equal magnitude and only the lower sideband is transmitted with a suppressed carrier. Determine the average...
4. An AM radio transmitter broadcasts 62.5 kW of power uniformly in all directions. Assuming all of the radio waves that strike the ground are completely absorbed, and that there is no absorption by the atmosphere or other objects, what is the intensity 30.5 km away? (Hint: Half the power will be spread over the area of a hemisphere.) What is the maximum electric field strength at this distance? a. b.
In a broadcasting system, the transmitted signal power is 50 kW, the attenuation of the signal is 155 dB (in passing from the input to the transmitting antenna to the output of the receiving antenna), and the available mean power-spectral density of the noise in the system from all sources has a mean power spectral density level 10-18 W/Hz (as if added at the receiving antenna's output). The bandwidth of the message signal m(t) is 8 KHz. Determine the output...
A radio station on the earth's surface emits a sinusoidal wave with average total power 50 kW (Fig. 32.19). Assuming that the trans- mitter radiates equally in all directions above the ground (which is unlikely in real situations), find the electric-field and magnetic field amplitudes Emax and Bmar detected by a satellite 100 km from the antenna 32.19 A radio station radiates waves into the hemisphere shown. Satellite = 100 km
Consider a 50 kW, 3-phase, 380 V line-to-line, 50 Hz, 6 pole Y-connected wound-rotor induction motor. The stator winding ac resistance is 0.1 Ω/phase. The effective stator-to-rotor turns ratio is 2. The exciting branch is negligible. It is found that when an external resistor of 0.09 Ω/phase is connected to the rotor terminals maximum starting torque of 1150 Nm is obtained. a. Compute the internal mechanical power and the internal torque developed by this motor when it drives a load...
If a l V rms signal source with an internal resistance of 50 Ω is connected to the amplifier in Figure what is the actual rms signal applied to the amplifier input? Assume Bac 200 +15 V RI 1.0 kΩ 01 Di C3 02 75 Ω 1.0 kΩ Class C Power Amplifiers A certain class C amplifier transistor is on for 10 percent of the input cycle. If Veetsa) 0.18 V and Ie(sa)25 mA, what is the average power dissipation...