Question

You put a thin pot containing 2kg of 20c water on a hot electric stove. You...

You put a thin pot containing 2kg of 20c water on a hot electric stove. You observe that after 180s the water is at 30c.


A) How much thermal energy transfer Q was there into the water

A. 418000
B. 83600
C. -418000
D. -83600
E. None

B) What was the change E_thermal in the water

A. -418000
B. -83600
C. 83600
D. 418000
E. None of the above

C) What was the change E_surroundings in the rest of the universe?

A. -418000
b. 83600
c. -83600
D. 418000
E. None of the above.

D) What is the power output of the electric stove
A. 464W
B. 929 W
C. 2322 W
D. 1393 W
E. None of the above

0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
You put a thin pot containing 2kg of 20c water on a hot electric stove. You...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Water is in a pot on the stove boiling at constant temperature. The water is the...

    Water is in a pot on the stove boiling at constant temperature. The water is the system a. ∆U + ∆Ek = Q b. ∆U = -∆EP c. ∆U = Q d. ∆U + ∆Ek + ∆EP = Q-W e. W = Q A system in which does not allow heat to transfer across the system boundary (Q=0) is known as Adiabatic Transient Differential Stead state Differential The internal energy change of a system cannot be assumed to be zero...

  • A copper pot (m = 2kg) is placed on a stove and heated to 150C. Then...

    A copper pot (m = 2kg) is placed on a stove and heated to 150C. Then water (m = 100g) at 25C is poured into the pot and the lid is quickly sealed to the top. What is the final temperature of this system and how much steam is produced? a. Write an equation that shows no water converts to steam. b. adjust your equation to show all water converts to steam. c. Adjust it again to show only a...

  • please help :( A hungry student placed a pot of spaghetti water on a hot plate...

    please help :( A hungry student placed a pot of spaghetti water on a hot plate which had power 1.0 kW. The pot contained 2.01 water with temperature 11 °C. The following values apply to water; thermal capacity 4.18 JK-1g-1, density 1.0 g/ml, evaporation enthalpy 41 kJmol-1. (a) Calculate the temperature of the water after the hob has been running for 10 my. Overlook the heating of the saucepan and stove top. (b) Calculate the temperature of the water after...

  • Exercise 10 Consider a 2-m-high electric hot water heater that has a diameter of 40 cm...

    Exercise 10 Consider a 2-m-high electric hot water heater that has a diameter of 40 cm and maintains the hot water at 55°C. The tank is located in a small room whose average temperature is 27°C, and the heat transfer coefficients on the inner and outer surfaces of the heater are 50 and 12 W/m2.°C, respectively. The tank is placed in another 46-cm-diameter sheet metal tank of negligible thickness, and the space between the two tanks is filled with foam...

  • Waste heat of exhaust hot air from a manufacturing process may be recovered by passing water through a thin-walled tube of 1.00 cm diameter as shown. Assume the temperature of the hot air is 177℃ in...

    Waste heat of exhaust hot air from a manufacturing process may be recovered by passing water through a thin-walled tube of 1.00 cm diameter as shown. Assume the temperature of the hot air is 177℃ in cross flow with a velocity of 20 m/s over the tube. The inlet and outlet temperature of water are 20C and 60 C, rospectively, and the ilow rate is 0.2 k/s. Deiemine (a) the total heat transfer rate from air to water, (b) The...

  • Water made to fall drop by drop on the surface of a pot containing water. One...

    Water made to fall drop by drop on the surface of a pot containing water. One drop falls every 2 seconds on the surface of water. [ 5pts] 1) What do you observe on the surface of water? 2) The waves propagating on the surface of 3. are water transverse.why? 3) Calculate the period and frequency of this 4) If we repeat the experiment but every 10 What will be the period and the frequency? motion. drops fall on the...

  • EI. A Watched Pot... When heating water on a stove, a full pan of water takes...

    EI. A Watched Pot... When heating water on a stove, a full pan of water takes longer to reach the boiling point than if the pan is half full. Why? Explain using the appropriate formula. E2. A Pressing Matter! We viewed a video of Rodrigo smacking the top of a bottle full of water with his palm. Then, the BOTTOM of the bottle broke and the water rushed out. WHY? did this happen? a. (10) Name and State the important...

  • Q#:3,4,68,69,73,76,92 and 94 3) You plant a seed in a pot with soil, add water, and...

    Q#:3,4,68,69,73,76,92 and 94 3) You plant a seed in a pot with soil, add water, and then place it in the sunlight in a closed chamber. Before the seedling emerges from the soil, carbon dioxide levels increase in the closed chamber. This indicates that is occurring. A) cellular respiration B) alcohol fermentation C) sucrose production D) fertilization E) photosynthesis directs water from the roots into the 4) The waxy barrier called the endodermis and then into the xylem. A) sieve...

  • question 18 & 19 18) For a certain hot system in contact with cool surroundings, the...

    question 18 & 19 18) For a certain hot system in contact with cool surroundings, the half-life time for loss of excess thermal energy to the surroundings is 10 minutes. This means what about the excess thermal energy? It is a) all gone in 20 minutes b) half gone in 5 minutes c ) half gone in 20 minutes d) all gone in 10 minutes e) none of the above 19 You have 400 ml of a saturated solution of...

  • Could someone help me with this question please as I am kinda lost as in how to do these type of questions please explain each step a) Draw a diagram of a solar hot water system and discuss the funct...

    Could someone help me with this question please as I am kinda lost as in how to do these type of questions please explain each step a) Draw a diagram of a solar hot water system and discuss the functions of its [5 marks For the solar collector, analyse the solar radiation heat gain and heat losses through different modes of heat transfer. How is the heat transfer rate to the water per unit area of the collector calculated? b)...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT