29) In an air separation plant, air is cooled and its components are separated from the mixture. ...
please solve it quickly ignore p=75 Problem 3 Part a P=57 Moist air enters the cooler of an air conditioning unit at 25 °C and a relative humidity of 70%. The cooled and dehumidified air leaves the cooler saturated at 18 °C. The temperature of condensed water is 18 °C. The pressure is constant at 101.325 kPa. The mass flow rate of the dry air is mda=67 kg/s. Use the psychometric chart to determine a) The humidity ratio at the...
A rectangular forced air heating duct is suspended from the ceiling of a basement whose air and walls are at a temperature of ∞T∞=Tsur= 5°C. The duct is 15 m long, and its cross section is 350 mm × 188 mm. (1) For an uninsulated duct whose average surface temperature is 50°C, estimate the rate of heat loss from the duct. The surface emissivity and convection coefficient are approximately 0.5 and 4 W/m2·K, respectively. (2) If heated air enters the...
Water entering a wet cooling tower at 35°C at a rate of 100 kg/s is cooled to 22°C in the cooling tower by air that enters the tower at 1 atm, 20°C, and 60% relative humidity and leaves saturated at 30°C. The makeup water of 22°C is supplied to the outlet to make the mass flow rate of the cool water the same as that at the inlet, see Figure Q5. Q.5Water entering a wet cooling tower at 35°C at...
Problem 3: (35pts) Atmospheric air enters the heated section of a circular tube at a flow rate of 0.005 kg/s and a temperature of 30°C. The tube is of diameter D =60mm, and fully developed conditions with h = 30W/m2K exist over the entire length of L-4m. Take cp-1015 /kg.K 2 (a) (10pts) For the case of uniform surface heat flux at q"-1000W/m, determine the total heat transfer rate q and the mean temperature of the air leaving the tube...
the examinatiU to Heat Transfer" by Frank P. Incropera and Bavid F. Air entering a circular stainless steel tube D 50 mm outside diameter by d 45 mm inside diameter by L 5 m long atTa 20 C is heated by saturated steam at T100 c through which the tube passes. The thermal conductivity of the stainless steel tube kss .. 16.3 w/m° ? and the heat transfer coefficient at the interface between the tube and the steam h. 5000...
a shell and tube heat exchanger is required to heat brine for a food processing plant. Hot waste water from another part of the plant is available at 90°C and a flow rate of 0.7kg/s to perform the heating duty. An existing heat exchanger is available that has twoshell passesand 4 tube passes. Each tube pass has a total length of 20m and the tubes are found to be thin walled copper with a nominal diameter of 25mm. The brine...
Homework 7 heat transfer 2018-20 1) A horizontal tube of 12.5-mm dimeter with an outer srface temperature of 240°C is placed in a room with an air temperature of 20°C. Estimate the heat transfer rate per unit length of the tube due to free convection. 2) Air at -10°C flows at 10 m/s over the roof plate of two 5m length rooms whose air is at Too-200C. The roof plate is 0.20-m thick concrete (k = 0.6 w/ m. K)....
summarizr the followung info and write them in your own words and break them into different key points. 6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
3. 1 kg of moist air at mixture pressure 100 kPa has a dry bulb temperature of 30°C and relative humidity of 60%. It is then cooled to a dry bulb temperature of 5°C where it reaches saturation. Without using the psychrometric chart, determine: (35 pts) i) Initial humidity ratio ii) Mass of dry air (kg) iii) Mass of condensate (kg) 720 Tables in SI Units Sal U; X 10 Temp. "C 01 00 ON A 10 11 12 13...