3. Signal xe)8+12e07eo+)is sampled periodically with the rate j20T (-1) F Hz to obtain the discre...
Signal xo(t) 5 cos (200π1+ 품 ) + 4 sin (300π) is sampled at a rate of Fs = 1 kHz to obtain the discrete-time signal x[n]. (a) Determine the spectrum X(ej ) of x[n] and plot its magnitude as a function of ω rad sam in tad and as a function of F in Hz. Explain whether the original signal xe(t) can be recovered from xln]. (b) Repeat part (a) for 500 Hz. (c) Repeat part (a) for 100...
Please explain why. Thank you. (5%) The following signals r t) is sanpled periodically to obtained the discrete-time signal [n. For each of the given sampling rates in F, Hz or in T period, (i) determine the spectrum x(eM) of x[n]; (ii) plot its magnitude and phase as a function of w in and as a function of sampling frequency Fs in HZ; and (iii explain whether e(t) can be recovered from rn] (a) re(t) 8 +12e-3207e-j0(+), with sampling rate...
Q2.) Consider the sampling of the continuous-time signal x(t) to obtain a discrete-time signal x[n (1)-10cos(1000m + π/3) + 20cos(2000m + π/6). 110points! ], where x a) What is the maximum sampling interval (minimum sampling frequency) that could be used to ensure an aliasing free sampling of this signal? b) Plot the spectrum of the sampled signal if x() is sampled using a sampling frequency of (i) 2500 Hz (ii) 1800 Hz and state whether there will be an aliasing...
1. Given the spectrum X(f) of an analog signal x(t), sketch the spectrum of its sampled version x[n], assuming a sampling rate of 50, 40, and 30 Hz. (a) X()=rect(f/40) (b) X()=tri(f/20)
10ρ 18ρ A signal (t) has the Fourier transform X(jw) indicated in the figure. The signal is sampled to obtain the discrete time signal 1. Sketch the Fourier transform Xr(jw) of x[n] for T-to. 2. Can x(t) be recovered for T? How? What is the maximum value of T so that r(t) can be recovered? 10ρ 18ρ A signal (t) has the Fourier transform X(jw) indicated in the figure. The signal is sampled to obtain the discrete time signal 1....
MATLAB Fourier transform. Suppose that a signal x(t) is sampled with sampling frequency fs =100Hz. The sequence x[n] obtained after the sampling is given below: Take the DFT of the sampled sequence and plot its magnitude and phase. What is the frequency resolution (Δf) of your plot? N= 20, 100 Hz N= 20, 100 Hz
Problem 3: Sampling a Cosine (again) The continuous-time signal ra(t) = cos (150) is sampled with sampling period T, to obtain a discrete-time signal x[n] = XanT). 1. Compute and sketch the magnitude of the continuous-time Fourier transform of ra(t) and the discrete-time Fourier Transform of x[n] for T, = 1 ms and T, = 2 ms. 2. What is the maximum sampling period Ts max such that no aliasing occurs in the sampling process?
10. Find the Fourier transform of a continuous-time signal x(t) = 10e Su(t). Plot the magnitude spectrum and the phase spectrum. If the signal is going to be sampled, what should be the minimum sampling frequency so that the aliasing error is less than 0.1 % of the maximum original magnitude at half the sampling frequency. 11. A signal x(t) = 5cos(2nt + 1/6) is sampled at every 0.2 seconds. Find the sequence obtained over the interval 0 st 3...
An analog signal is given as below x(t) = 10sin 4rtt The signal is sampled by two different frequencies f, = 1Hz, f, = 10Hz respectively, and the output are yı, Yz. (i) Sketch signal x(t) in the time domain. (3 marks) (ii) Sketch frequency spectrum of x(t). (3 marks) (iii) After sampling, the continuous signal is converted to a discrete signal. Draw the two discrete signals Yı, Y2: (4 marks) (iv) Discuss whether f1, f, can successfully sample the...
Consider the function r (t)7sin (11π) A discrete-time signal is produced by sampling x (t) at a rate f, to give x [n] Acos (aon + φ) Determine values for A, a, and φ, and determine whether the signal has been over-sampled or under-sampled, when a) fs10 Hz b) f 5 Hz