P6.010 The mechanism shown in the figure is in equilibrium for an applied load of 25 kN. Specifications for the mechanism limit the shear stress in the steel [G82 Ga] shaft BC to 58 MPa, the shear st...
the modulus of elasticity is not given Problem 4.2: The mechanism below is in equilibrium for an applied load of P = 20 kN. Specifications for the mechanism limit the shear stress in the steel [G = 80 GPa) shaft BC to 70 MPa, the shear stress in bolt A to 100 MPa, and the vertical deflection of joint D to a maximum value of 25 mm. Assume that the bearings allow the shaft to rotate freely. Using L =...
A vertical load P = 150 kN is applied to a circular solid shaft which in turn is supported by a circular end cap as shown below. Both members are made of steel with allowable normal stress = 160 MPa, allowable shear stress 100 MPa, and allowable bearing stress 200 MPa. Determine the minimum required diameter of the solid shaft, and the minimum required outer diameter and thickness of the circular end plate. P 150 kN ds d 30 mm...
The gears attached to the fixed-end steel shaft are subjected to the torques shown in the figure. If the shear modulus of elasticity is 150 GPa a determine the following: nd the shaft has a diameter of 14 mm, a. Sketch the torque diagram along the steel shaft. b. Determine the maximum shear stress at Tmax and specify location. c. Sketch the shear stress distribution along the radial line at location specified in (b). d. Determine the displacement of the...