In case of any doubt please comment...
PLease answer asap In the circuit shown below, the source voltage has an rms value of 18.0 V at a frequency of 60.0 Hz. Here R,-2R2-R. When the switch is in position 1, the rms current is 291 mA. When...
Consider a RLC series circuit connected to a 220 V rms voltage source with a frequency of 120 Hz. WhatConsider a RLC series circuit connected to a 220 V rms voltage source with a frequency of 120 Hz. What is the peak current through the circuit if R = 250Ω, C = 90 μF, and L = 4.5 mH?is the peak current through the circuit if R = 250Ω, C = 90 μF, and L = 4.5 mH? A. 1.24...
Answer all parts 1) What is the rms current in an RC circuit if R = 6.00 kΩ , C = 1.70 μF , and the rms applied voltage is 120 V at 60.0 Hz ? What is the power dissipated by the circuit? 2) A circuit contains two elements, but it is not known if they are L, R, or C. The current in this circuit when connected to a 120-V 60 Hz source is 5.4 A and lags...
Problem 3: (20 points) When a DC source is connected to a series RC cireuit the time constant is 15.0 ms. When an 18.0 V RMS AC source is connected to the same series RC circuit you measure 3.17 V RMS across the capacitor a) (3 points) What is the resistor voltage? c) (5 points) What is the frequency of the source? If the resistor is 750.0 Q, what is the value of C? d) (6 points) An inductor is...
In the circuit shown below, the voltage source has an EMF of 14.1 V, and some internal resistance, r. You connect the circuit as shown, with two equal external resistances R. The current through the battery is 0.463 A when the switch is open and 0.792 A when the switch is closed. What is the internal resistance, r? Give your answer in Ohms to at least 3 significant figures to avoid being counted off for rounding. Do not include units...
The input sinusoid has a 1 V amplitude and 5,000 Hz frequency. Analyze the circuit of Figure to determine, for each value of R_L. Use the given values and answer questions a-g. Please show work. V. Load Figure 2 Using Figure 2 Calculate for the questions a-g using the values given of R_T. RLand inductor resistance values for the parameters in the circuit of Figure 2.ee . 1.00-12.000 es the input sinusold her a IV.,amplitude and a Se frequency) ....
A common source amplifier circuit based on a single n-channel MOSFET is shown in Figure 4b. Assume that the transconductance gm-60 mS (equivalent to mA/ V) and drain source resistance, os, is so large it may be neglected. 0) Calculate the open circuit voltage gain Av Yout/ Vis. i) The amplifier has a load of 10 k2. Determine the current gain Va. = 12 V 150k 4k3 Vout Vin 200k GND = 0 V Figure 4b a) State the name...
1) An inductor of 45 mH that has a 2.6 mA current when connected to a circuit. There is a sinusoidal voltage of 12 V applied across the inductor. a) How much time does it take for this to happen? I 2) When resistors are connected in series, the equivalence resistances will be closest to the value of a) Smallest resistor value b) Middle resistor value c) Largest resistor value 3) An electro-magnetic wave of a moving charge will have...