please thumsup
Student ID K-map to simply the function f e and "d" is the least si (3 points each) CO: 3] 3. Five bits of information and a parity bit are to be transmitted on a noisy channel. The trans...
part c Problem 3 [10 points a) (5 points) Construct a circuit that takes as input a 3-bit number X-XXXo and increments it by one. L.e. if the input is 101 the output should be 110. Use only half adders. b) Construct a circuit that takes as input a 3-bit number X-XXxo and decrements it by one 1. (5 points) Show the truth table of the circuit. Then use a decoder and additional gates to implement it. So Ys Y2...
please solve the question completely and show the steps ... thumb up will be given (5 points each) [CO: 6] a. If RO and R1 are both 16-bit serial shift registers, each with a single serial input (S_IN) and a single serial output (S_OUT), clock and reset. Design using RO and Rl additional logic, a circuit that would store the output S_OUT of either RO or Rl into a D-FF based on input CH. If CH is 0, S OUT...
3) (30 points) Given three 8-bit unsigned inputs A, B, C, design a circuit that outputs 1 if the smallest absolute distance between any pair of values is less than 15 or greater than 50. Note: your circuit must work for any 8-bit unsigned numbers given in A, B, C. 18 18 18 - Assume that you have the following Datapath components available (unsigned only) - decoders, encoders, muxes, parallel load registers, adders, A B C subtractors, magnitude comparators, array...
number 4 and 5 please! PROBLEM STATEMENT A logic circuit is needed to add multi-bit binary numbers. A 2-level circuit that would add two four-bit numbers would have 9 inputs and five outputs. Although a 2-level SOP or POS circuit theoretically would be very fast, it has numerous drawbacks that make it impractical. The design would be very complex in terms of the number of logic gates. The number of inputs for each gate would challenge target technologies. Testing would...