soil mechanics please solve part A and part B al column loads shown in the figure below the net stress increase yt the center of the footing at a depth of I. A combined footing 10 h below the b) D...
HW#10 Given the following column loading and footing information, determine the size of a mat foundation shown below: I 15 Column Information: Column A: Live load = 40 kips, Dead load = 50 kips Column B: Live load = 80 kips, Dead load = 100 kips. Distance between two columns: 15 ft. W soil = 120 psf 24" I CA C. Footing information: Distance from column A to edge of footing: 1 ft. Allowable soil bearing capacity = 3000 psf...
S. Al-Martini, PhD, P. Eng. Question No. 5 (35minutes) 19 marks) As shown in the figure, a 9-ft 6-in square footing supporting an 18-in. -square tied concrete column and it is subjected to service dead load 225 kips, and service live load 175 kips. column is a typical interior column in a building. Assume normal-weight concrete.. soil pressure (ga) 5000 psf (5 ksf), f'e for column 4000 psi, f's for the footing lsteel 60, 000 psi. The density of the...
S. Al-Martini, PhD, P. Eng. Question No. 5 (35minutes) 19 marks) As shown in the figure, a 9-ft 6-in square footing supporting an 18-in. -square tied concrete column and it is subjected to service dead load 225 kips, and service live load 175 kips. column is a typical interior column in a building. Assume normal-weight concrete.. soil pressure (ga) 5000 psf (5 ksf), f'e for column 4000 psi, f's for the footing lsteel 60, 000 psi. The density of the...
Part-I: OPEN BOOK Problem 1 (30 points). For the isolated square footing shown below, assume that the combined weight of soil and concrete above the base of the footing is equal to 120 pcf. Assume fc-3000 psf and column size of 18in. x 18 in. Determine the followings: a) If the footing size of 10ft. x10ftx 2ft. is adequate based on allowable soil-bearing capacity qa 6,000 psf b) If the footing 10ft. x10ft.x 2ft. is adequate for shear e) Calculate...
Homework #10 A soil exploration result of a site is shown in the following figure. A building is to be constructed at that site. First, it has been proposed to raise the elevation of the ground by filling the site with 10 ft thick compacted soil at an area of 25 ft x 25 ft. The unit weight of the compacted moist soil was 120 pcf. The foundation of proposed building was constructed at the center of the compaction area...
help please
A square footing is founded at 3-ft depth below ground surface as shown in Fig1, The factored axial load acting on the square footing is 140 kips, Determine the size of the footing (B x B) if the Factor of Safety (F.S.) is 3.0. Ground surface ЗА B-? Silty Sand Fig.1 A 68-ft long pre-stressed concrete pile with square cross section (14 inch) is driven into the soil profile shown in Fig. 2. Compute the ultimate compressive load...
Questions 5-8
A steel frame shown below is subjected to combined uniformly distributed gravity load (w 2 kips/f) and a horizontal earthquake load of H-10 kips Both the beams and the columns are made of W12x120 section having a yield strength of F 45 ksi. The Young's modulus of steel s E-29,000 ksi. The distributed load w is used to simulate the self-weight of the beam, the load transferred from roof slab, as well addition superimposed dead loads. The self-weigh...