rankine cycle TS diagram
3: Consider the Rankine power cycle using vapor and liquid. a: Explain what kinds of problems the Carnot Vapor Cycle has. b: Draw a T-s diagram for the ideal Rankine cycle and label each process...
3. The Rankine cycle is the ideal cycle for vapor-driven power plants. A Rankine cycle with water as the working fluid operates between the pressure limits of 4 MPa in the boiler and 20 kPa in the condenser. The turbine inlet temperature is 700°C and the flow rate is 30 kg/s. State the assumptions and show the complete reduction of the governing equations. (Total: 20 pts.) (a) Show the cycle on a T-s diagram. (b) Determine the power produced by...
(30 points) Rankine Cycle An ideal Rankine cycle has a turbine power output of 4 MW. Saturated liquid at 20 kPa leaves the condenser, and the vapor at the exit to the isentropic turbine has a quality of 95 percent. The boiler pressure is 1.4 MPa. a. Find the mass flow rate of the steam (kg/s) b. What is the heat transfer into the boiler? c. What is the thermal efficiency for this cycle? Condenser
Thermodynamics 1. Saturated liquid H20 at 16 MPa is fed into the boiler of a variant of a Carnot cycle (but simplified Rankin cycle) where the working fluid is not an ideal gas. Saturated H20 vapor is fed into the turbine of the same turbine. The condenser of this turbine is operated at 8 kPa. The mass flowrate of the H20 in this cycle is 7.2x103 kg/min. Draw the path of this process on T-s diagram. Estimate the thermal efficiency...
3) A solar powered steam generator operates under an ideal Rankine cycle. Water at a pressure of 15MPa enters the turbine as saturated vapor and leaves with a pressure of 0.125MPa. The mass flow rate in the cycle is 100 kg/s, while the temperature difference in the condenser water is 24 Celsius. Draw the T-s diagram of this ideal Rankine cycle. Determine the following: A) The net power developed in the cycle in kW B) The rate of heat transfer...
3. (40 pts) A steam power plant based on the Rankine cycle, shown in the below, operates to develop net cycle power. Saturated vapor at 8 bar enters the turbine where it expands to the condenser pressure of 1 bar. Water liquid exits the condenser 30 °C and 1 bar and it is pumped to the boiler pressure of 8 bar. Isentropic efficiencies of the turbine and pump are 80% and 60%. Assume kinetic and potential energies are negligible at...
(1) Ideal Rankine A power plant operates using an ideal Rankine cycle. Saturated liquid water enters the pump at P1 = 25 kPa. After being pumped, it passes through the boiler before entering the turbine at P3 = 5 MPa and T3 = 500 °C. If the mass flowrate of the working fluid is m = 20 kg/s, what are Wnet, Oh, and ntn? Draw this on a T-s diagram, labeling the given pressures and temperature as well as arrows...
6. Water is the working fluid in an ideal Rankine cycle. Saturated vapor enters the turbine at 16 MPa, and the condenser pressure is 8 kPa. The mass flow rate of steam entering the turbine is 120 kg/s. Determine: (a) Draw the ideal Rankine cycle in T-S diagram (b) The net power developed, in kW. (b) The rate of heat transfer to the steam passing through the boiler, in kW. (c) The thermal efficiency. 2 P (kPa) 16000 16000 TC)...
1. A Steam Power Plant that operates on an ideal regenerative Rankine Cycle with an open feedwater heater is considered. The turbine inlet conditions are 6 MPa, 450 C. The regeneration pressure is 0.4 MPa. The condenser pressure is 20 kPa. a) Draw the T-s diagram, and the sketch of the steam power plant. b) Calculate the low pressure pump work. c) Calculate the high pressure pump work. d) Calculate the fraction of the steam extracted from the turbine for...
Consider a steam power plant which operates on the simple ideal Rankine cycle (shown in the next page), where the boiler pressure is 3 MPa and the condenser saturation temperature is 50°C. The temperature at the exit of the boiler is 500°C. Water leaves the condenser as a saturated liquid. The mass flow rate through each component is 15 kg/s. Calculate: 1. The power output of the steam power plant 2. The thermal efficiency of the steam power plant Now,...
Problem4 (a) (40 points) A combined gas-steam powe cycles. The ideal Brayton and Rankine plant operates on Rankine cycle has a reheater. The Brayton cycle operates on a gas- of the gas-turbine cycle 1400 K The 15MPa to ercooling, reheating, and regeneration cycle. The pressure ratio 300 K for compressor stages is do Air enters compressors a combustion gases leaving the lower pressure gas turbine are used to heat the steam at C in a heat exchanger. The combustion gases...