Homework Answers
this is a problem based on Rankine cycle
Add Answer to:
3. (40 pts) A steam power plant based on the Rankine cycle, shown in the below,...
A steam power plant is based on the Rankine cycle with reheat (refer to the figure below). Steam ...
A steam power plant is based on the Rankine cycle with reheat (refer to the figure below). Steam is produced by the boiler/superheater (H-1) at 100 bar and 600 C at a rate of 2.5 kgs. This is expanded to 10 bar in the turbine T-1 and then reheated to 600 °C in heater H-2. The steam is then expanded in turbine T-2 to a pressure of 0.1 bar. The steam is then condensed in condenser (C-1) which operates at...
3. The Rankine cycle is the ideal cycle for vapor-driven power plants. A Rankine cycle with...
3. The Rankine cycle is the ideal cycle for vapor-driven power plants. A Rankine cycle with water as the working fluid operates between the pressure limits of 4 MPa in the boiler and 20 kPa in the condenser. The turbine inlet temperature is 700°C and the flow rate is 30 kg/s. State the assumptions and show the complete reduction of the governing equations. (Total: 20 pts.) (a) Show the cycle on a T-s diagram. (b) Determine the power produced by...
Water is the working fluid in a Carnot vapor power cycle. Saturated liquid enters the boiler...
Water is the working fluid in a Carnot vapor power cycle.
Saturated liquid enters the boiler at a pressure of 160 bar, and
saturated vapor enters the turbine. The condenser pressure is 0.08
bar. Determine
(a) the thermal efficiency.
(b) the back work ratio.
(c) the heat transfer to the working fluid per
unit mass passing through boiler, in kJ/kg.
(d) the heat transfer from the working fluid per
unit mass passing through the condenser, in kJ/kg.
Problem 8.03 Water...
Problem 4 In the vapor power cycle shown below, steam (H20) is the working fluid. Saturated...
Problem 4 In the vapor power cycle shown below, steam (H20) is the working fluid. Saturated vapor enters the turbine at 100 bar and saturated liquid exits the condenser at a pressure of 0.1 bar. The net power output of the cycle, Weycle, is 150 MW. Isentropic efficiency of the turbine and the pump (n (hi-h2)/(h1-h2s), np=(h25-h1)/(h2-h1)) are both 80%. Determine the followings. [30 pts] (a) Thermal efficiency, n (b) Mass flow rate of the steam, m, in kg/s (c)...
Tutorial Questions 1 1. Water is the working fluid in an ideal Rankine cycle. The condenser...
Tutorial Questions 1.1. Water is the working fluid in an ideal Rankine cycle. The condenser pressure is kPa, and saturated vapor enters the turbine at 10 MPa. Determine the heat transfer rates, in kJ per kg of steam flowing, for the working fluid passing through the boiler and condenser and calculate the thermal efficiency.2. Water is the working fluid in an ideal Rankine cycle. Saturated vapor enters the turbine at 16 MPa, and the condenser pressure is 8 kPa ....
Consider a steam power plant which operates on the simple ideal Rankine cycle (shown in the...
Consider a steam power plant which operates on the simple ideal
Rankine cycle (shown in the next page), where the boiler pressure
is 3 MPa and the condenser saturation temperature is 50°C. The
temperature at the exit of the boiler is 500°C. Water leaves the
condenser as a saturated liquid. The mass flow rate through each
component is 15 kg/s. Calculate:
1. The power output of the steam power plant
2. The thermal efficiency of the steam power plant
Now,...
3. (10 pts) A simple Rankine cycle operates with water as the working fluid between the...
3. (10 pts) A simple Rankine cycle operates with water as the working fluid between the pressures of 4 MPa and 20 kPa. The fluid leaves the boiler at 550°C, the turbine efficiency is 89% and the fluid exits the condenser as saturated liquid. The flow rate is 81.5 kg/s and the pump efficiency is 52%. Determine: a. The net power output, in kW. b. The rate of heat input in the boiler, in kW. C. The rate of heat...
3. A water vapor thermoelectric plant operates in the regenerative Rankine cycle with two open feed...
3. A water vapor thermoelectric plant operates in the
regenerative Rankine cycle with two open feed water heaters as
shown in the figure. The plant maintains the turbine inlet at 10
MPa and 600 ° C, and operates the condenser at 5 kPa. Steam is
drawn from the turbine at 0.6 and 0.2 MPa. The water comes out of
both feed water heaters as a saturated liquid. The isentropic
efficiency for the turbine and the pumps is 90%. For a...
Consider a power plant with water as working fluid that operates on a reheat Rankine cycle...
Consider a power plant with water as working fluid that operates on a reheat Rankine cycle and has a net power output of 75 MW. Steam enters the high-pressure turbine at 10 MPa and 400°C and the low-pressure turbine at 1 MPa and 400°C. Water leaves the condenser as a saturated liquid at a pressure of 100 kPa. The isentropic efficiency of the high-pressure turbine is 85% and the low-pressure turbine in 100%. The pump has an isentropic efficiency of...
A nuclear power plant based on the Rankine cycle operates with a boiling-water reactor to develop...
A nuclear power plant based on the Rankine cycle operates with a boiling-water reactor to develop net cycle power of 3 MW. Steam exits the reactor core at 100 bar, 52O degree C and expands through the turbine to the condenser pressure of 1 bar. Saturated liquid exits the condenser and is pumped to the reactor pressure of l00 bar. Isentropic efficiencies of the turbine and pump are 81% and 78%, respectively. Cooling water enters the condenser at 15 degree...
A steam power plant is based on the Rankine cycle with reheat (refer to the figure below). Steam is produced by the boiler/superheater (H-1) at 100 bar and 600 C at a rate of 2.5 kgs. This is expanded to 10 bar in the turbine T-1 and then reheated to 600 °C in heater H-2. The steam is then expanded in turbine T-2 to a pressure of 0.1 bar. The steam is then condensed in condenser (C-1) which operates at...
3. The Rankine cycle is the ideal cycle for vapor-driven power plants. A Rankine cycle with water as the working fluid operates between the pressure limits of 4 MPa in the boiler and 20 kPa in the condenser. The turbine inlet temperature is 700°C and the flow rate is 30 kg/s. State the assumptions and show the complete reduction of the governing equations. (Total: 20 pts.) (a) Show the cycle on a T-s diagram. (b) Determine the power produced by...
Water is the working fluid in a Carnot vapor power cycle.
Saturated liquid enters the boiler at a pressure of 160 bar, and
saturated vapor enters the turbine. The condenser pressure is 0.08
bar. Determine
(a) the thermal efficiency.
(b) the back work ratio.
(c) the heat transfer to the working fluid per
unit mass passing through boiler, in kJ/kg.
(d) the heat transfer from the working fluid per
unit mass passing through the condenser, in kJ/kg.
Problem 8.03 Water...
Problem 4 In the vapor power cycle shown below, steam (H20) is the working fluid. Saturated vapor enters the turbine at 100 bar and saturated liquid exits the condenser at a pressure of 0.1 bar. The net power output of the cycle, Weycle, is 150 MW. Isentropic efficiency of the turbine and the pump (n (hi-h2)/(h1-h2s), np=(h25-h1)/(h2-h1)) are both 80%. Determine the followings. [30 pts] (a) Thermal efficiency, n (b) Mass flow rate of the steam, m, in kg/s (c)...
Consider a steam power plant which operates on the simple ideal
Rankine cycle (shown in the next page), where the boiler pressure
is 3 MPa and the condenser saturation temperature is 50°C. The
temperature at the exit of the boiler is 500°C. Water leaves the
condenser as a saturated liquid. The mass flow rate through each
component is 15 kg/s. Calculate:
1. The power output of the steam power plant
2. The thermal efficiency of the steam power plant
Now,...
3. (10 pts) A simple Rankine cycle operates with water as the working fluid between the pressures of 4 MPa and 20 kPa. The fluid leaves the boiler at 550°C, the turbine efficiency is 89% and the fluid exits the condenser as saturated liquid. The flow rate is 81.5 kg/s and the pump efficiency is 52%. Determine: a. The net power output, in kW. b. The rate of heat input in the boiler, in kW. C. The rate of heat...
3. A water vapor thermoelectric plant operates in the
regenerative Rankine cycle with two open feed water heaters as
shown in the figure. The plant maintains the turbine inlet at 10
MPa and 600 ° C, and operates the condenser at 5 kPa. Steam is
drawn from the turbine at 0.6 and 0.2 MPa. The water comes out of
both feed water heaters as a saturated liquid. The isentropic
efficiency for the turbine and the pumps is 90%. For a...
Consider a power plant with water as working fluid that operates on a reheat Rankine cycle and has a net power output of 75 MW. Steam enters the high-pressure turbine at 10 MPa and 400°C and the low-pressure turbine at 1 MPa and 400°C. Water leaves the condenser as a saturated liquid at a pressure of 100 kPa. The isentropic efficiency of the high-pressure turbine is 85% and the low-pressure turbine in 100%. The pump has an isentropic efficiency of...
A nuclear power plant based on the Rankine cycle operates with a boiling-water reactor to develop net cycle power of 3 MW. Steam exits the reactor core at 100 bar, 52O degree C and expands through the turbine to the condenser pressure of 1 bar. Saturated liquid exits the condenser and is pumped to the reactor pressure of l00 bar. Isentropic efficiencies of the turbine and pump are 81% and 78%, respectively. Cooling water enters the condenser at 15 degree...
Most questions answered within 3 hours.
-
A) Asha Company completed its inventory count. It arrived at a
total inventory value of
$200,000....
asked 4 minutes ago -
When you move a rope up and down, waves are created. If the
waves pass through...
asked 39 minutes ago -
QUESTION 52
Which of the following is a direct result of scarcity?
A college student misses...
asked 40 minutes ago -
The zero order reaction 2N2O→2N2+O2 has the rate constant k of
7.20×10−3 molL s. If the...
asked 42 minutes ago -
When you borrow money to buy a house, a car, or for some other
purpose, you...
asked 57 minutes ago -
Write a c program that finds the uncommon elements from two
array elements using pointers
only...
asked 1 hour ago -
SQL help:
Design a database diagram for a database that stores information
about the Downloads that...
asked 2 hours ago -
In 1970s and 1980s, molecular biologists discovered that the
hormone testosterone, binds a receptor protein that...
asked 4 hours ago -
january 1 2010 road catering service purchase a piece of
equipment for 58000 which is expected...
asked 4 hours ago -
Explain Mertons concept of anomie is and what the
modes of adaptation to it are?
asked 5 hours ago -
Jamie is doing a survey at her school about whether the students
feel the cafeteria food...
asked 7 hours ago -
How many liters of 0.669 M KOH will be needed to raise the pH of
0.339...
asked 9 hours ago