The poles and zeroes arranged in ascending order are as,
1E3 Z, 1.5E3 P, 2E3 Z, 4E3 P, 1E9 P, 1.5E9 P, 2.7E9 Z
The asymptotic bodeplot of this looks like,
From the graph it is clear that,
And mid band gain is between them,
In the mid-band region,
s>>>P,Z for P,Z to the left of mid-band
P,Z>>>s for P,Z to the right of mid-band
Then,
Problem 1 The following transfer function characterizes the frequency response of an amplifier. Using the information o...
Problem Consider a voltage amplifier having a frequency response of the low-pass STC 1ype with a de gain of 60 dB and a 3-dB frequency of 1000 Hz Find the gain in dB at f- 10 Hz, 10kHz, 100 kHz, and 1 MHz Problem For the circuit shown below first, evalusteand the coresponding comer froquency. Second evalmt and the corresponding comer froquency. At the end caloulate overall transfer function T(w)= and reurite it in the standard fom ( and draw...
Determine the transfer function for a 2nd order Chebyshev low pass filter with 3dB frequency of 100krad/sec, a maximum gain of OdB, and a passband ripple of 1dB. (40 points) (a) (b) A bandpass filter is made by cascading the filter described in part (a) with a 2nd order Chebyshev high pass filter with 3dB frequency of 1krad/sec, a maximum gain of OdB and passband ripple of 2dB. Determine the midband gain of the filter. (30 points) A Chebyshev bandpass...
1. Find the transfer function (voltage gain) of the following amplifier. You may assume a high frequency model for the transistor. You may assume that the transistor has been biased properly. Your answer will indeed be in terms of circuit components. Vcc 10v C1 01 R2 V1 C2 RE Vout
D. Since a frequency response as seen in C. is clearly unacceptable, the capacitor Cl is used to decrease the feedback signal at higher frequencies. Components are chosen as follows: R1-320k2, R2-10k2, C1-4.7nF. The transfer function of the feedback network is therefore 10, 000 Ro GRVoUT() urs) RRC1+RR 15.5330, 000 Determine the combined transfer function IsPx(s)/V(s) when the frequency compensation capacitor CI is installed and determine the poles and zeros (if any) of the new transfer function. [10 points] Problem1...
QI (a) () Design an active filter using non-inverting amplifier that will produce a frequency response as shown in Figure Ql(a). The bandwidth of the filter is 30 kHz. Use a capacitor value of 10 nF. (9 marks) Draw the circuit and clearly label it. (5 marks) (b) Derive the transfer function of the filter in Q1(b). (6 marks) Av (dB) 28 dB 25 dB - 20 dB/decade + 20 dB/decade - 1 1 35 kHz 40 kHz Figure Qi(a)...
Frequency Response of Unknown Dynamic System Determine the system transfer function from the 2 -5 following Bode plot: 10 o -15 -20 -25 -30 0 10%2 10 10 10 Frequency (rad/s)
Figure 1 shows an amplifier application using a JFET. Given that VGSQ = -2.48 V, Ipo = 2.07 mA and yes = 0.1 ms. i) Determine the voltage gain at mid-range frequency, Avimid). ii) Determine fia, fic and fis for the network. iii) Determine which value contributes to the low frequency response for the network. iv) Plot the asymptotes for low frequency response of the network. Use the semi-log graph paper given in APPENDIX II for your answer. v) Plot...
b) Given a second order system with the following open loop transfer function where damping ratio, } = 0.707 and natural frequency, Wn= 2.5. wn? G(S) = S2 + 23wns +wn? i. Determine the steady state error to an appropriate input via a calculation method using the transfer function. Compare your answer with the steady state error from the exact frequency response for this system given in Figure Q4(b). (5 marks) ii. Evaluate the difference of the exact frequency response...
Hi can you help me solve the following analog electronic frequency response question? Please show me step by step how to draw the magnitude plot. Thank you! ) A voltage amplifier has the transfer function: 2000 (1+; 20->1+3168/+370) (i) Determine all the pole and zero frequencies. (4 Marks) (ii) What is the frequency (to a good approximation) at which the phase shift is -90° ? (iii) What is the magnitude of gain at the frequency determined in part (ii)? Express...
Figure 1 shows an amplifier application using a JFET. Given that Vasq=-2.48 V. IDQ = 2.07 mA and you = 0.1 ms. 1) Determine the voltage gain at mid-range frequency, Awwid). ii) Determine fio, fic and fts for the network iii) Determine which value contributes to the low frequency response for the network. iv) Plot the asymptotes for low frequency response of the network. Use the semi-log graph paper given in APPENDIX II for your answer. v) Plot the actual...