Please show all steps and write explanations for any assumptions, simplifications. I am not just looking for the answer but how you get to the answer.
Homework Answers
Kindly upvote if it's helpful for you .
Add Answer to:
Please show all steps and write explanations for any assumptions, simplifications. I am not just looking for the ans...
Please show all your work clearly and write out explanations. I know the solution involves a cotangent equation but...
Please show all your work clearly and write out
explanations. I know the solution involves a cotangent equation but
I don't know where it comes from. Can you please show a derivation
for that equation? thanks
Problem 2.29 A 50-MHz generator with Z, 50 2 is connected to a load 2L = (50_/25) Ω The time-average power transferred from the generator into the load is maximum when Zg = , where ZL is the complex this condition without changing Zg,...
7) Two half-wave dipole antennas, each with an impedance of 75 Ω, are connected in parallel throu...
7) Two half-wave dipole antennas, each with an impedance of 75 Ω, are connected in parallel through a pair of 0.5-A transmission lines, and the combination is connected to a feed 0.25-2 transmission line, as shown in the Figure. 75Ω (Antenna) (a) What is the impedance of the 0.25-2 feed transmission line such that Zin will be matched to a 5042 TL? (b) If the result of (a) is connected to a 50 Ω TL that is, in turn, connected...
Hello, I am providing the answers for this assignment but can you do it and show...
Hello, I am providing the answers for this assignment but can
you do it and show the work. I also had a questions, I am not sure
when the answers will be 0, so how am i able to tell when the
current and voltage will be 0 and when they will not. Is there an
easy way to tell this?
The circuit shown below has a triangle wave voltage source with Vpeak-10 V, Vminimum10 Vand period T-3 mS series...
Good day all. I am facing the following problem and would like to seek some kind...
Good day all.
I am facing the following problem and would like to seek some
kind help, please.
Sincerely appreciate all help and input.
- Ms Tan
1. An 10 MVA, 33 kV, 34 pole, 60 Hz, three-phase wye-connected synchronous generator has a synchronous reactance of 10 and a negligible armature resistance. a. Find the synchronous speed of this generator. b. At a certain excitation, the generator delivers 50% of rated load at 0.7 leading power factor at '33' kV....
Please show all the steps and write neatly. Do not skip any steps and write out...
Please show all the steps and write neatly. Do not skip any
steps and write out any formula u used please. write neatly as
well. Thank you
Problem 2: (35 Points Design the reinforced concrete (normal weight concrete, NWC) beam AB shown in Fig. 2. The beam shown in Fig. 2 is the same beam as shown in Fig. 1. The beam is subjected to an uniformly distributed loading which can be calculated from Fig. (based on tributary area). In...
Can you please sow the work for the highlighted portion of the question. I have no...
Can you please sow the work for the highlighted portion of the
question. I have no idea how that is found. Please show all steps.
Thanks
4, A 50 Ω lossless transmission line of 2 ¼ λ long is connected to an AC source, having a phasor voltage V,- 15 V and a terminal impedance of 50 Ω, and a load Z-50 +j 100 Ω. 1) Draw a schematic of this transmission line circuit; 2) Find the power delivered to...
Please show all work and explain steps So that I can see where I am going...
Please show all work and explain steps So that I can see where I
am going wrong.
After having been in position 1 for a long time, the switch in the circuit as shown below was moved to position 2 at t-os, were Vo-14 V, R1-2 Ω, R2 = 148 Ω, R3-40 Ω, and L-1 H OL (a) Determine () and VL(O) iL(:0.000 (A); VL(o):0.000 (V) You are correct ies ur receipt no. is 146-1674 (b) Determine iL(O) and Vi(O):...
the answer is shown below, please show all work on how to get to this answer....
the answer is shown below, please show all work on how to get
to this answer.
21.3.1. An AC source of Vo = 1200 V amplitude and f= 50 Hz alternating potential is connected to a circuit that has R = 40 12 resistance, L = 0.3 H inductance and C = 5x10-5 F capacitance. A. Setup with a labeled diagram. b. Calculate the impedance Z of the circuit and the amplitude lo of the alternating electric current. c. Write...
would you like please answer all questions in part 3 THEVENIN'S THEOREM AND MAXIMUM POWER TRANSFER...
would you like please answer all questions in part 3
THEVENIN'S THEOREM AND MAXIMUM POWER TRANSFER 131 Part 3 Maximum Power Transfer (Experimental Approach) (a) Construct the network of Fig. 11.8. Insert the measured value of each resistor R EIOV 95.732 218S2 325 2 . 424e R FIG. 11.8 Eths Vabs 6.8v Rths Resissn (b) The Thevenin equivalent circuit will now be determined for the network to the lel of the terminals a-b without disturbing the structure of the network....
I am working on my Physics lab report where it was all about Direct Current Measurement...
I am working on my Physics lab report where it was all about Direct Current Measurement and Ohm’s Law. We had 5 different resistors and had to construct different circuits using a power supply, volt-ohm-milliammeter (VOM) and a digital multimeter to get measurements of resistance, voltage, and current. Nominal values of resistance and tolerance Resistor Nominal Resistance (Ohms) Tolerance (Ohms) R1 680 +/- 68 R2 1000 +/- 50 R3 1500 +/- 75 R4 4700 +/- 470 R5 10,000 +/- 500...
Please show all your work clearly and write out
explanations. I know the solution involves a cotangent equation but
I don't know where it comes from. Can you please show a derivation
for that equation? thanks
Problem 2.29 A 50-MHz generator with Z, 50 2 is connected to a load 2L = (50_/25) Ω The time-average power transferred from the generator into the load is maximum when Zg = , where ZL is the complex this condition without changing Zg,...
7) Two half-wave dipole antennas, each with an impedance of 75 Ω, are connected in parallel through a pair of 0.5-A transmission lines, and the combination is connected to a feed 0.25-2 transmission line, as shown in the Figure. 75Ω (Antenna) (a) What is the impedance of the 0.25-2 feed transmission line such that Zin will be matched to a 5042 TL? (b) If the result of (a) is connected to a 50 Ω TL that is, in turn, connected...
Hello, I am providing the answers for this assignment but can
you do it and show the work. I also had a questions, I am not sure
when the answers will be 0, so how am i able to tell when the
current and voltage will be 0 and when they will not. Is there an
easy way to tell this?
The circuit shown below has a triangle wave voltage source with Vpeak-10 V, Vminimum10 Vand period T-3 mS series...
Good day all.
I am facing the following problem and would like to seek some
kind help, please.
Sincerely appreciate all help and input.
- Ms Tan
1. An 10 MVA, 33 kV, 34 pole, 60 Hz, three-phase wye-connected synchronous generator has a synchronous reactance of 10 and a negligible armature resistance. a. Find the synchronous speed of this generator. b. At a certain excitation, the generator delivers 50% of rated load at 0.7 leading power factor at '33' kV....
Please show all the steps and write neatly. Do not skip any
steps and write out any formula u used please. write neatly as
well. Thank you
Problem 2: (35 Points Design the reinforced concrete (normal weight concrete, NWC) beam AB shown in Fig. 2. The beam shown in Fig. 2 is the same beam as shown in Fig. 1. The beam is subjected to an uniformly distributed loading which can be calculated from Fig. (based on tributary area). In...
Can you please sow the work for the highlighted portion of the
question. I have no idea how that is found. Please show all steps.
Thanks
4, A 50 Ω lossless transmission line of 2 ¼ λ long is connected to an AC source, having a phasor voltage V,- 15 V and a terminal impedance of 50 Ω, and a load Z-50 +j 100 Ω. 1) Draw a schematic of this transmission line circuit; 2) Find the power delivered to...
Please show all work and explain steps So that I can see where I
am going wrong.
After having been in position 1 for a long time, the switch in the circuit as shown below was moved to position 2 at t-os, were Vo-14 V, R1-2 Ω, R2 = 148 Ω, R3-40 Ω, and L-1 H OL (a) Determine () and VL(O) iL(:0.000 (A); VL(o):0.000 (V) You are correct ies ur receipt no. is 146-1674 (b) Determine iL(O) and Vi(O):...
the answer is shown below, please show all work on how to get
to this answer.
21.3.1. An AC source of Vo = 1200 V amplitude and f= 50 Hz alternating potential is connected to a circuit that has R = 40 12 resistance, L = 0.3 H inductance and C = 5x10-5 F capacitance. A. Setup with a labeled diagram. b. Calculate the impedance Z of the circuit and the amplitude lo of the alternating electric current. c. Write...
would you like please answer all questions in part 3
THEVENIN'S THEOREM AND MAXIMUM POWER TRANSFER 131 Part 3 Maximum Power Transfer (Experimental Approach) (a) Construct the network of Fig. 11.8. Insert the measured value of each resistor R EIOV 95.732 218S2 325 2 . 424e R FIG. 11.8 Eths Vabs 6.8v Rths Resissn (b) The Thevenin equivalent circuit will now be determined for the network to the lel of the terminals a-b without disturbing the structure of the network....
Most questions answered within 3 hours.
-
1-Write an algorithm to get two numbers from the user (as
inputs) and calculate the sum...
asked 1 hour ago -
Define white-collar crime. What is the difference between
offender and offense-based definitions of white-collar crime? What...
asked 2 hours ago -
Consider a reaction which is 1st order with respect to A and 1st
order with respect...
asked 2 hours ago -
c++
The length of the hypotenuse of a right-angled triangle is the
square root of the...
asked 2 hours ago -
When a metal rod is heated, not only its resistance but also its
length and cross‐sectional...
asked 2 hours ago -
write a c++ program that computes the L^1 - Norm of a given
vector (L^1 norm...
asked 2 hours ago -
A manufacturer of banana chips would like to know whether its
bag filling machine works correctly...
asked 2 hours ago -
Complete the chapter case, "Turnover Analysis".
Chapter Case
Turnover Analysis
You recently completed your company’s new...
asked 2 hours ago -
What is the pH of solutions having the following H3O+
concentrations? Identify each as acidic, basic,...
asked 3 hours ago -
How does over-voltage of the diode usually occur?
asked 3 hours ago -
If you step on a dirty nail, your doctor will recommend you
update your Tetanus vaccination....
asked 3 hours ago -
Suppose that decreases in the price of milk lead to decrease s
in the retail prices...
asked 3 hours ago