Question

520 A 2Ω 20 2-902 V 4Ω 21 Figure 3

jst need answer for simulation not calculation.could someone help me.tq

By using a simulation tool determine I .(Electronics Workbench or Pspice).

Answer 1

Solution: Note : As the frequency is not specified in the input sources so that we can take w-1 rad/sec or f-0.15915 Hz such that the above two reactances will satisfy the given conditions . L-(XL)/w and C-l/(wXc). on solving we get L-1 H and C-0.5 F R1 2 PRINT F1 PHASEok R2 V1 MAG = yes AC=yes 4 GAIN 2 C1 ACMAG 20 ACPHASE =-90 0.5 Circuit simulation diagram for current I using PSPICE

Simulation Settings gfh General Analysis Configuration Files Options Data Collection Probe Window An AC Sweep Type AC Sweep/Noise Start Fre 0.15916 , Linear ○ Logarithmic End Frequ 0.15916 Options General Settings Monte Carlo/Worst Case Decade Total Points Parametnc Sweep Noise Analysis Temperature Sweep) Save Bias Point Load Bias Point Enabled Output Voltage /V Source Interval: Output File Options □ Include detailed bias point information for nonlinear controlled source$ and semiconductors(.0Pl OK Cancel Apply Help A.C sweep simulation settings

IM(V_PRINT1)IP(V_PRINT1) FREQ Results obtained from output 1.592E-01 7.906E+00 4.349E+01 simulation file JOB CONCLUDED 05/26/19 00:37:24 ** Spice Lite (April 2011) ID# 10813 ** Profile "SCHEMATIC1-fh"H2016pspice gtfre-PSpiceFiles SCHEMATIC1 gfh.sim JOB STATISTICS SÍMARE 0 1=7.906-43.49 Ampere