Write a code/sketch to send sensor readings from Nodemcu esp8266 12e to Blynk App to show the Current and power consumed by loads. (voltage=220 volts)
Write a code/sketch to send sensor readings from Nodemcu esp8266 12e to Blynk App to show the Current and power consumed...
Based on the motor nameplate below, when operated at the rated
voltage and current, determine the following:
a. The real power, P, reactive power, Q, and
apparent power, S, used by the motor.
b. Sketch an equivalent circuit to model for
the motor.
c. The efficiency of the motor (calculated from
shaft power/real power in).
d. What value of capacitor would you use to
correct the power factor to 1?
e. Sketch a vector diagram showing the phasor
current in...
Please show step for step and, all equations used. Thank
you.
1) For the power supply circuit: 120v Dc. 6Oh time values on your sketch E. hat is the DC load Current? 7 C. What is the average current in each diode? I = D. what is th peak current in each uld be reqLlired to redLICe the E. What minimLm va l Lle.Pf capac i tor 120v 7 1 For the power suipply circuit: ツー time values on Your...
10. Two loads connected in parallel draw a total of 2.4 kW at 0.8 pflagging from a 120-V rms, 60- Hz line. One load absorbs 1.5 kW at a 0.707 pf lagging. Determine: (a) the pf of the second load, INV 11. Calculate the line currents for the system shown in figure. Calculate also the total power and reactive power consumed by the load. w 12. For the balanced three-phase circuit in Fig.. Calculate the line currents, the phase voltage...
solve no: 3.14 , 3.16, 3.19
please show each step and solve for beginners
120 Power System Analysis 3.12. A single-phase system similar to that shown in Figure 3.11 has two transformers A-B a B-C connected by a line B feeding a load at the receiving end C. The ratings and parame ter values of the components are 500 V/1.5 kV, 9.6 kVA. leakage reactance 5 % 1.2 kV/120 V, 7.2 kVA, leakage reactance 4 % series impedance (0.5 +...
Notes for lab dc02-Resistors and the Color Code will skip are Part 2 e, g: Part 4; Exercises 2, 4,5,6 and 3. It is important to answer the exercises correctly in each labl you should include the appropriate prefix for the unit in the Numerical Value We will not be Volt using the Volt-Ohm meter (VOM) for this lab, so skip the parts that ask for VOM measurements. The parts we You do need to complete Exercises1 Note that in...