P3. A 2-inch outside diameter (OD) by 1.5 -inch inside diameter (iD) wrought iron water line...
6 Water is heated in a pipe by exchanging heat with a warmer fluid that flows outside the pipe. Inside diameter of the pipe is dn 0.045 m and outside diameter dour0.05 m. Mean velocity of the water in the pipe is um-0.31 m/s and the bulk temperature is 323 K (density 988 kg m-3; viscosity 0.00055 kg m' sı. Pr 3.56, thermal conductivity k 0.64 W m1 Kt). The material of the pipe has thermal conductivity k 0.61 W...
Water is to be withdrawn from a 3-m-high water reservoir by drilling a 1.5-cm- diameter hole in the center of the bottom surface. Disregarding the effect of the kinetic energy correction factor, determine the flow rate of water through the hole for a) a sharp edged entrance followed by threaded 90° bend and then a 3.5m length of wrought iron pipe and finally a fully open Globe Valve b) redo a) for the ideal case with no viscous losses
P6-17 a steel hub with an inside diameter of 1.5 in., an outside diameter of 3.75 in., and a length of 3.0 in. The impeller is pressed onto a steel shaft. What is the ultimate pressure required for assem- bly? (c) Give the expression for allowance for given pressure P6-16 Use Machinery's Handbook to answer the following questions about shrink fits. (a) Plot and interpret a curve showing P6-18 A 35 in. diameter ring gear of steel is to allowance...
1. A ¾ inch (nominal), Schedule 40, mild steel pipe carries 40 psia steam through a room having an air temperature of 80°F. The pipe is covered with a 0.125 ft thick layer of fiberglass insulation having a thermal conductivity of 0.037 Btu/(h ft ‘F). The hi value on the steam side of the pipe is 1000 Btu/h ft2 °F. The ho value on the outside of the insulation is 2.0 Btu/(h ft2 ’F). For the mild steel, k=26Btu/(ft H...
1. Water at 100°F is pumped from a sea-level reservoir to a tank open to the atmosphere through a new 14-in ID galvanized iron pipe as shown below. The minor loss coefficients in the suction and discharge piping are EK = 1.5 and Eduk = 7.2. Perform the following: a. derive the equation for the system curve as hy = a + b where he and a have units of feet and b has units of ft/gpm); b. plot the...
3.2A horizontal 4-inch outer diameter (OD) tube is surrounded by saturated steam at 2 psia. The tube is maintained at 64°F. What is the average heat-transfer coefficient. Assume filmwise condensation and laminar flow. Use SI units during your calculations. (12) NB: Table for properties for saturated steam: Properties of saturated water Volume Expansion ent Enthalpy Specific Thermal Prandt en Dynamic Density C ity Nu Hea me Pressure Vaporization emp. P kPa Liquid Vapor A kkg Liquid Vapor Liquid Vapor Liquid...
I need help to write a nice introduction for experiment 6 please ( no hands write ) typing Thank you HEAT TREATMENT OF STEELS EXPERIMENT 6 EXPERIMENT 6 HEAT TREATMENT OF STEELS THEORY The Effect of Cooling Rate One of the most convenient methods for controlling the properties of a given steel, i.e., a steel whose composition is already fixed, consists of austenizing the steel and ten cooling to room temperature at some predetermined rate. A variation of cooling rates...