A quantity of a monatomic ideal gas undergoes a process in which both its pressure and...
A quantity of a monatomic ideal gas undergoes a process in which
both its pressure and volume are doubled as shown in the figure
above.
DATA:
V0 = 0.39 m3
P0 = 12500 Pa.
A. What is the change of the internal energy of the
gas?
B. What was the work done by the gas during the expansion?
C. What amount of heat flowed into the gas during the expansion?
Homework Answers
If
you like the solution then please give rating. thank
you.
Add Answer to:
A quantity of a monatomic ideal gas undergoes a process in which
both its pressure and...
A quantity of a monatomic ideal gas undergoes a process in which both its pressure and...
A quantity of a monatomic ideal gas undergoes a process in which
both its pressure and volume are doubled as shown in the figure
above.
DATA:
V0 = 0.23 m3
P0 = 14500 Pa.
What is the change of the internal energy of the gas?
Tries 0/20
What was the work done by the gas during the expansion?
Tries 0/20
What amount of heat flowed into the gas during the expansion?
Tries 0/20
Post
Discussion
We were unable to transcribe...
1 mole, n=1, of an ideal monatomic gas undergoes the following process: It starts in the...
1 mole, n=1, of an ideal monatomic gas undergoes the
following process: It starts in the state(Po, Vo). It expands
isobarically to the state(Po, 5Vo). It is heated at constant
volume(isochorically) to (7Po, 5Vo)
A.) Plot this on a PV diagram
B.) What is the temperature difference between the initial and the
final state?
C.) What is the internal energy change?
D.) What is the total heat flow into the gas?
1 mole , n l, of an idcal monatomic...
A monatomic ideal gas undergoes isothermal expansion from 0.08 m3 to 0.22 m3 at a constant...
A monatomic ideal gas undergoes isothermal expansion from 0.08 m3 to 0.22 m3 at a constant temperature (initial pressure is 310 kPa). What are its (a) internal energy change (ΔEΔE), (b) net heat transfer (Q), and (c) net work done (W)? Use negative quantity for heat transfer out of the system or work done on the system.
The figure shows a reversible cycle through which 2.44 mol of a monatomic ideal gas is...
The figure shows a reversible cycle through which 2.44 mol of a monatomic ideal gas is taken. Assume that p = 2p0lV = 2V0,p0 = 3.91 times 105 Pa, and V0 = 0.0201 m3. Calculate (a) the work done during the cycle, (b) the energy added as heat during stroke abc, and (c) the efficiency of the cycle, (d) What is the efficiency of a Carnot engine operating between the highest and lowest temperatures that occur in the cycle? (e)...
An ideal monatomic gas undergoes changes in pressure and volume, as shown in the pV diagram...
An ideal monatomic gas undergoes changes in pressure and volume, as shown in the pV diagram below. The initial volume is 0.02 m3 and the final volume is 0.10 m3 20 10 01 (a) Calculate the magnitude, or absolute value, of the Work done on the gas in this process. (Be careful with units. Your answer should be in Joules. 1 atm 1.013x 105 Pa.) (b)The work done ON the gas is: O positive O negative (c) The initial temperature...
A 3-mole of a monatomic ideal gas undergoes an isothermal expansion at 450 K, as the...
A 3-mole of a monatomic ideal gas undergoes an isothermal expansion at 450 K, as the volume increased from 0.010 m3 to 0.060 m3. What is the work done by the gas and the change in the internal energy of the gas respectively during this process? (R = 8.31 J/mol · K) 15.1 kJ, 3.6 kJ 20.1 kJ, O.O kJ 20.1 kJ, 18.5 kJ -17.2 kJ, 20.1 kJ -20.1 kJ, O kJ
(17%) Problem 4: A monatomic ideal gas is in a state with volume of Vo at...
(17%) Problem 4: A monatomic ideal gas is in a state with volume of Vo at pressure Po and temperature T . The following questions refer to the work done on the gas, W- -PA 17% Part (a) The gas undergoes an isochoric cooling from its initial state (I-Po-T0). For this process, choose what happens to the energy heat, and work from the following Grade Summary Deductions Potential 100% 0% Submissions OAU > 0, Δυ-o-w. Q < 0, and w...
(5 pts) 13. A monatomic ideal gas undergoes an adiabatic expansion (Q0). In this process what...
(5 pts) 13. A monatomic ideal gas undergoes an adiabatic expansion (Q0). In this process what happens to the temperature of the gas? 001 ( Creos ToD a) decreases (b) doesn't change (c) increases 00 () sto() (5 pts) 14. A quantity of 4.00 moles of a monatomic ideal gas (C, 3R/2, C, - 5R/2) undergoes an isothermal process (AT = 0) at a constant temperature of T 300 K. In the process the volume of the gas increases from...
A container holds 4.5 mol of an ideal monatomic gas with a pressure of 125 kPa....
A container holds 4.5 mol of an ideal monatomic gas with a pressure of 125 kPa. The container initially has a volume of 0.10 m3. The gas undergoes an adiabatic expansion until it reaches a volume of 0.3 m3 and a pressure of 20.0 kPa. What is the thermal energy of the gas after the expansion? How much energy went into or out of the gas as work during the expansion? (Positive for energy into the gas, negative for energy...
13.A monatomic ideal gas (N=9.1x1023), undergoes adiabatic expansion. During the expansion, the temperature of the gas...
13.A monatomic ideal gas (N=9.1x1023), undergoes adiabatic expansion. During the expansion, the temperature of the gas decreases from 800.0K to 500.OK. The initial volume of the gas is 0.10 m². a. What is the final volume and pressure of the gas, after expansion? b. What is the change in internal energy of the gas? C. Calculate the work associated with this process.
A quantity of a monatomic ideal gas undergoes a process in which
both its pressure and volume are doubled as shown in the figure
above.
DATA:
V0 = 0.23 m3
P0 = 14500 Pa.
What is the change of the internal energy of the gas?
Tries 0/20
What was the work done by the gas during the expansion?
Tries 0/20
What amount of heat flowed into the gas during the expansion?
Tries 0/20
Post
Discussion
We were unable to transcribe...
1 mole, n=1, of an ideal monatomic gas undergoes the
following process: It starts in the state(Po, Vo). It expands
isobarically to the state(Po, 5Vo). It is heated at constant
volume(isochorically) to (7Po, 5Vo)
A.) Plot this on a PV diagram
B.) What is the temperature difference between the initial and the
final state?
C.) What is the internal energy change?
D.) What is the total heat flow into the gas?
1 mole , n l, of an idcal monatomic...
The figure shows a reversible cycle through which 2.44 mol of a monatomic ideal gas is taken. Assume that p = 2p0lV = 2V0,p0 = 3.91 times 105 Pa, and V0 = 0.0201 m3. Calculate (a) the work done during the cycle, (b) the energy added as heat during stroke abc, and (c) the efficiency of the cycle, (d) What is the efficiency of a Carnot engine operating between the highest and lowest temperatures that occur in the cycle? (e)...
An ideal monatomic gas undergoes changes in pressure and volume, as shown in the pV diagram below. The initial volume is 0.02 m3 and the final volume is 0.10 m3 20 10 01 (a) Calculate the magnitude, or absolute value, of the Work done on the gas in this process. (Be careful with units. Your answer should be in Joules. 1 atm 1.013x 105 Pa.) (b)The work done ON the gas is: O positive O negative (c) The initial temperature...
A 3-mole of a monatomic ideal gas undergoes an isothermal expansion at 450 K, as the volume increased from 0.010 m3 to 0.060 m3. What is the work done by the gas and the change in the internal energy of the gas respectively during this process? (R = 8.31 J/mol · K) 15.1 kJ, 3.6 kJ 20.1 kJ, O.O kJ 20.1 kJ, 18.5 kJ -17.2 kJ, 20.1 kJ -20.1 kJ, O kJ
(17%) Problem 4: A monatomic ideal gas is in a state with volume of Vo at pressure Po and temperature T . The following questions refer to the work done on the gas, W- -PA 17% Part (a) The gas undergoes an isochoric cooling from its initial state (I-Po-T0). For this process, choose what happens to the energy heat, and work from the following Grade Summary Deductions Potential 100% 0% Submissions OAU > 0, Δυ-o-w. Q < 0, and w...
(5 pts) 13. A monatomic ideal gas undergoes an adiabatic expansion (Q0). In this process what happens to the temperature of the gas? 001 ( Creos ToD a) decreases (b) doesn't change (c) increases 00 () sto() (5 pts) 14. A quantity of 4.00 moles of a monatomic ideal gas (C, 3R/2, C, - 5R/2) undergoes an isothermal process (AT = 0) at a constant temperature of T 300 K. In the process the volume of the gas increases from...
13.A monatomic ideal gas (N=9.1x1023), undergoes adiabatic expansion. During the expansion, the temperature of the gas decreases from 800.0K to 500.OK. The initial volume of the gas is 0.10 m². a. What is the final volume and pressure of the gas, after expansion? b. What is the change in internal energy of the gas? C. Calculate the work associated with this process.
Most questions answered within 3 hours.
-
The random variable X is exponentially distributed, where X
represents the time it takes for a...
asked 1 minute ago -
MATLAB
write a MATLAB function (1) output a third-order polynomial
function with the coefficients as the...
asked 9 minutes ago -
A z-score
communicates a raw score’s "relative standing"
under the normal curve in relation to:
asked 17 minutes ago -
An object is vibrating on a spring with the following equation
of motion:
?=(30 ??)cos((2?)/(160)?)
a)...
asked 17 minutes ago -
Vulcan Flyovers offers scenic overflights of Mount St. Helens,
the volcano in Washington State that explosively...
asked 19 minutes ago -
If organizations do not adapt fast enough and move incrementally
from the twentieth-century model to the...
asked 20 minutes ago -
A helium balloon with 2.5L of gas has a gauge pressure of 10,000
Pa. The balloon...
asked 24 minutes ago -
What is responsible for Jupiter's enormous magnetic field?
asked 40 minutes ago -
At the end of the year, a company offered to buy 5,000 units of
a product...
asked 41 minutes ago -
Implement C++ program for each of the following.
Let D = [-48, -14, -8, 0, 1,...
asked 1 hour ago -
Consider a labor market in which LD = 400 – 4W and LS = 250 +...
asked 1 hour ago -
Let’s say you are teaching a typically-developing young child
how to eat with a spoon. Describe...
asked 59 minutes ago