Question

EXPERIMENT 3: DETERMINATION OF RATIO OF VOLUME ОВІЕСТIVES 1. To determine the ratio of volume and compares it to the theoreti I need help for writing problem statement and limitations of this experiment

0 0
Add a comment Improve this question Transcribed image text
Answer #1

Answes Expesiment Volume Detemination Ratio Objectives: he 3atio Volumie investigate compane tato df Volume the theaetcal Tofluxuati ns Deviations Hhe measunemSnt Pressune due the letical pocedune due to not muuh Accusauy Jcldings vadowdu veadings P

Add a comment
Know the answer?
Add Answer to:
I need help for writing problem statement and limitations of this experiment EXPERIMENT 3: DETERMINATION OF...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • In gas absorption column experiment, the purpose of the experiment is to measure the absorption of...

    In gas absorption column experiment, the purpose of the experiment is to measure the absorption of carbon dioxide into water flowing down the tower, using the gas analysis equipment provided. The experiment procedure is as follows. 1. First fill the two globes of the absorption analysis equipment on the left of the panel with 1.0 Molar caustic soda. Adjust the level in the globes to the '0' mark on the sight tube, using drain valve Cv into a flask to...

  • i just need help with the error anaylsis question. 11.9 volt 0.12 ump EXPERIMENT 19 ELECTROLYTIC...

    i just need help with the error anaylsis question. 11.9 volt 0.12 ump EXPERIMENT 19 ELECTROLYTIC CELLS 89 0-30 LABORATORY REPORT SHEET RECORD ALL VALUES WITH PROPER UNITS! Date Name Mass of copper anode before electrolysis 11.04979 Mass of copper anode after electrolysis 10.37269 Mass of copper removed 0.4771g Time start 12:00pm Time end 12:41 Total time_41 minulos Value with units that match R Use units on all values! Measured Value L'atm 0.08206 mole-K 294k Temperature 21.0°c 756.0 mmily Atmospheric...

  • 10/110 Section CHE 100 Section Experiment Date: Lab Partner: Experimental Determination of the Gas Constant Experimental...

    10/110 Section CHE 100 Section Experiment Date: Lab Partner: Experimental Determination of the Gas Constant Experimental Data A (a) Mass of Magnesium metal used (b) Volume of H, a collected (c) Temperature of collected () Atmospheric Pressure (c) Temperature of Water in bath (bucket) Vapor Pressure of Water above temperature 0.02659 9. 1220c Zalm Hg 2. c 12.2.. Data Analysis • Using your experimental de determine the value of the count Show all your conversions and calculations for each step...

  • I need help on how to find the atmospheric pressure from the scatter plot and trend...

    I need help on how to find the atmospheric pressure from the scatter plot and trend line I made with the results from my Boyle's Law lab. I don't know if my scatter plot is correct. I need the atmospheric pressure in order to fill in Table 5 and answer some questions. 24. Use the data in Data Table 1 and Data Table 3 to create a scatter-plot graph of 1/Average Volume vs. Pressure; with “1/Average Volume (mL-1)” on the...

  • i just wanna double check whether i answered correct or not please. Why do we measure...

    i just wanna double check whether i answered correct or not please. Why do we measure the volume of the flask in this experiment with water rather than using the volume listed on the side? Select all correct answers that apply. Must include all correct answers for full credit. The volume is not accurate on a flask to the number of significant figures required for this experiment The volumetric markings on the flask do not extend to it's full height...

  • With the data given, help on the calculations please - Tes Name Determination of the Gas...

    With the data given, help on the calculations please - Tes Name Determination of the Gas Constant, R, and the Purity of KCIO, Data Unknown number or letter Mass of test tube and iron (IIT) oxide 44.5928 Mass of test tube, iron (III) oxide and sample 44.979 8 Mass of test tube and contents after heating 44.8488 Volume of water displaced Barometric pressure 976 mbar Temperature of water temperature of O, 23 Vapor pressure of water at this temperature 21.068_mm...

  • i need help getting the theoretical value for this experiment i got a numbe that was...

    i need help getting the theoretical value for this experiment i got a numbe that was way too low please explain how you did it and show limiting reagents thank you Desk No. benzo?r Leauatons ti coretac 14 Struuure -Name entaldehyde 4HSCHO 106.12 1.04 3a,491 2.13 as wel os eyes Date THE HAYDEN-McNEIL STUDENT LAB NOTEBOOK Note: Insert Divider Under Copy Sheet Before Writing 47 Lab Partner Course & Tntamine 265358 when in Coveer wih CLHLOH Benzon 3e Procedures mth...

  • i am lost woth Titration, please help... i was able tondo my virtual lab and get...

    i am lost woth Titration, please help... i was able tondo my virtual lab and get the data needed... but i dont understand what to do on the remaining problems! please help! Experiment 11 part 2 ACID BASE TITRATIONS OBJECTIVES 1. To learn general titration techniques 2. To generate a standardized titrant. 3. To determine the concentration of various acid samples. PROCEDURES - WORK ALONE INTRODUCTION In part 1 you practiced standardizing a titrant: using KHP is a common procedure...

  • Hi I am im a biochemistry lab and we are doing an experiment titled: PCR Amplification...

    Hi I am im a biochemistry lab and we are doing an experiment titled: PCR Amplification of LeuRS F C Terminal Domain. I am having troubles figuring out the rest of my caluclations. I already did the calculations for the first dilution set, I was wondering how I would do the calculation for the second dilution set. Also I was wondering how I would determine the theoretical values for my data. Is there a specific formula I can use? If...

  • I need help calculating theoretical yield for my Diels-Alder lab experiment. This reaction was between 1,3-butadiene...

    I need help calculating theoretical yield for my Diels-Alder lab experiment. This reaction was between 1,3-butadiene and maleic anhydride, forming cis 1,2,3,6-tetrahydrophthalic anhydride. In this experiment 1.0g of maleic anhydride was combined with 1.8g 3-sulfolene and 2 mL dry xylene and refluxed for 30 mins. 6 mL of xylene was added to dissolve solids and then decanted, then warm pet. ether was added to form crystalline product after cooling. some of this info may be irrelevant in what is needed...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT