10. Line-of-sight communication systems is not found in which range of frequencies? (LF VHF, UHF, or...
6. A 10-GHz line-of-sight microwave communication link consists of two lossless parabolic dish antennas, each has 40 dB gain. If the receiver antenna requires 3 nW of receive power for good reception and the distance between the antennas is 35 km, how much power (in both mW and dBm) should be transmitted? 6. A 10-GHz line-of-sight microwave communication link consists of two lossless parabolic dish antennas, each has 40 dB gain. If the receiver antenna requires 3 nW of receive...
In addition to cable and satellite broadcasts, television stations still use VHF and UHF bands for digitally broadcasting their signals. Twelve VHF television channels (channels 2 through 13) lie in the range of frequencies between 54.0 MHz and 216 MHz. Each channel is assigned a width of 6.00 MHz, with the two ranges 72.0 – 76.0 MHz and 88.0 – 174 MHz reserved for non-TV purposes. (Channel 2, for example, lies between 54.0 and 60.0 MHz.) (a) Calculate the broadcast...
need help 10. A boat is equipped with a VHF marine radio, which it uses to communicate with other nearby boats and shore stations. If the antenna on the boat is 2.3 m above the water, calculate the maximum distance for communication with a) another similar boat b) a shore station with an antenna on a tower 22 m above the water level e) another boat, but using the shore station as a repeater 10. A boat is equipped with...
10. the infrared bending and twisting frequencies, which constitute the “fingerprint” of a molecule, are found mostly between? 11. the vertical axis of infrared spectra is usually in? 12. infrared is good for differentiating compounds with the same functional group? t/f The Infrared bending and twisting frequencies, which constitute the "fingerprint" of a molecule, are found mostly between? Select one: a. 2000-1500 frequency units O b. 4000-2500 frequency units C. 1500-600 frequency units O d. 2500-2000 frequency units The vertical...
10. Consider a version of Internet in which each communication link capacity is greater than the sum of the input rates for all end systems in Internet. Is the flow control not necessary in this scenario? Explain.
Designing a High speed Wireless Data Link Line of Sight Link Budget Analysis Several major factors that can impact the performance of a radio system are Available/permitted output power e Bandwidth, . Receiver sensitivity Antenna gains In this case study, the students will be required to calculate the link budget for a LOS Wireless link. Read through the following to understand some of the aspects and elements that need to be considered when calculating a Link Budget. If the estimated/calculated...
Copper is a toxic metal routinely found in older piping systems. Water treatment plants must report to EPA any values of copper ions in their water that exceed 1.3 mg/L, as it is hazardous above this level. Water running through the pipes contains bicarbonate at a fixed concentration of 95 mg/L (reminder: pK_a2 = 10.35 for carbonate system). Assume that copper is present in pipes as copper (II) carbonate [solid], which can disassociate into water per the equation below: CuCO_3(s)...
Fitting a Line to Data The method of least squares is a standard approach to the approximate solution of overdeter- mined systems, i.e., sets of equations in which there are more equations than unknowns. The term "least squares" means that the overall solution minimizes the sum of the squares of the errors made in the results of every single equation. In this worksheet you will derive the general for- mula for the slope and y-intercept of a least squares line....
Q.10- For the system shown in Figure 5 with K (s + 3)(s +5) Gs)s-2)s-4) Find the range of gain, K, which will cause the system to be stable. Cs) Q.11. Draw the Root Locus of the following systems. Find the points of intersection with the real and imaginary axis. 6(s)H(s)- s(s +2) K(s+5) of- Draw the Bode diagram of the following tmamsfer finction. His)- -100 s +12s +21s +10 213- Obtain the phase and gain margins of the system...
microwave communication Question Soalan 1 A 50Q microstrip line is built on a FR-4 substrate which the specification is given in Table .The line is connected to an ultrasonic sensor of 100 Q Satu garis mikrostrip 50 Q dibina pada substrat FR-4 yang mana spesifikasinya diberikan dalam Jadual 1. Garis ini disambungkan kepada sensor ultrasonik 100 Q Table 1 Jadual 1 Specifications Dielectric Constant Dissipation factor Substrate thickness Copper thickness Surface resistance Operating frequency 2.4 GHz Value 4.7 0.019 1.6...