plz rate my solution
Problem 3.63 3 of 16> Part A ReviewI Constants Find the resistance seen by the ideal...
Problem 19.31 19 of 41 ReviewI Constants Part A Find the direction and magnitude of the net electrostatic force exerted on the point charge q2 in the figure.(Figure 1) Let q-+2.4MC and d 31cm. Express your answer using two significant figures. Figure 1 of 1 tiet 20d933.0 Submit uest Ans Part B Express your answer using three significant figures. counterclockwise from q2-93 dire 44.0q
Review| Constants Part A A Thevenin equivalent can also be determined from measurements made at the pair of terminals of interest. Assume the following measurements were made at the terminals a b in the circuit in the figure When a 20S2 resistor is connected to the terminals a,b, the voltage Vab is measured and found to be 104 V when a 50 Ω resistor is connected to the terminals a,b, the voltage is measured and found to be 222 V....
Part G What is the value of Co for the condition of Part E? Express your answer with the appropriate units Value Units Submit Request Answer Review Constants The peak amplitude of the sinusoidal voltage source in the circuit shown in the figure is 150 V, and its frequency is 5000 rad /s. The load resistor can be varied from 0 to 4000 Ω, and the load capacitor can be varied from 0.1 μF to 0.5 μF (Figure 1) Figure...
ReviewI Constants Part A A 200 g ball attached to a spring with spring constant 2.40 N/m oscillates horizontally on a frictionless table. Its velocity is 22.0 cm/s when What is the amplitude of oscillation'? Express your answer to three significant figures and include the appropriate units. -5.00 cm. A: cm Submit Request Answer Part B What is the speed of the ball when 3.00 cm? Express your answer to three significant figures and include the appropriate units. Submit Request...
Constants Find the admittance Yab in the circuit seen in the figure. Take that R1 = 4 Ω , R2 = 5 Ω , R3 = 7 Ω and R4 = 14 Ω -j128 Ω a1 ab j10 Ω ▼ Part A Express Yab in rectangular form. Express your answer in complex form. mS ab =
ReviewI Constants Part A RI-3 kΩ and R2-3 kΩ in the circuit shown. Find the (unitless) voltage gain Vo/Vi for this circuit 2 k2 Express your answer to three significant figures. 0 R2 Submit Request Answer
Problem 19.50 11 of 16 Constants Part A The batteries shown in the circuit in (Figure 1) have negligibly small internal resistances. Assume that 13.0 V and R 21.0 Find the current through the 30.0 Ω resistor. Express your answer in amperes to three significant fig ures. Submit Part B Find the current through the 21.0 Ω resistor. Figure Express your answer in amperes to three significant figures. 1 of 1 +30.0 2 5.00 V Submit Request Answer Problem 19.50...
ReviewI Constants Part A ZR-40 Ω shown. ZL-jl0Q, and ZC- j35Ω in the circuit Find I2 using mesh current analysis. Express your answer to three significant figures in cartesian OR degree-polar form (using the r 20 template or by typing rcis()). MA 4/90° A Submit Request Answer Part B Find I. Express your answer to three significant figures in cartesian OR degree-polar form (using the rL8 template or by typing MA Submit Request Answer ReviewI Constants Part A ZR-40 Ω...
ReviewI Constants Part A The ultrasonic transducer used in a medical ultrasound imaging device is a very thin disk (m-0.10 g) driven back and forth in SHM at 1.0 MHz by an electromagnetic col. The maximum restoring force that can be applied to the disk without breaking it is 47,000 N. What is the maximum oscillation amplitude that won't rupture the disk? Express your answer to two significant figures and include the appropriate units. A.1 Value Units Submit ▼ Part...
Part A Constants What is the emt of the battery? Express your answer to two significant figures and include the appropriate units. When the resistor R in (Figure 1) is 30 Ω , the high- resistance voitmeter reads 91 V When R is replaced by a 8.02 resistor, the voltmeter reading drops to 6.7 V Value Units Figure 1 of 1 Submit Incorrect; Try Again Part B What is the internal resistance of the battery? Express your answer to two...