Homework Answers
Add Answer to:
After running the lab, you select an analysis point with the following properties: Atmospheric Pressure: 14.7...
If you could show all work with explanations that would be great!! Thanks!! #2. (30 pts)...
If you could show all work with explanations that would be
great!! Thanks!!
#2. (30 pts) A turbocharger boosts the inlet air pressure to an automobile engine. It consists of an exhaust gas-driven turbine directly connected to an air compressor, as shown in a below figure. For a certain engine load, the conditions are given in the below figure. Assume that both the turbine and the compressor are reversible and adiabatic, having also the same mass flow rate. Engine power...
Problem 1 - Gas Turbine Engine. Assume the gas turbine engine operates on basic non-ideal Brayton...
Problem 1 - Gas Turbine Engine. Assume the gas turbine engine operates on basic non-ideal Brayton cycle with the following specifications Inlet Condition: Dry air at 537 R and 14.7 psia Pressure Ratio: 24.2 Actual Exhaust Temperature: 950 F Compressor and Turbine Efficiency: 85% Actual Power Output 34 MW Using given/assumed values, determine: a) firing temperature, b) cycle efficiency, c) air mass flow rate. Problem 2- HRSG. Assume the HRSG is used to produce saturated steam at 600 psia using...
A compressor works on a pressure of 105 kPa and temperature 300 K in a Brayton...
A compressor works on a pressure of 105 kPa and temperature 300 K in a Brayton cycle and has an efficiency of 45%. The exhaust temperature is 700 K. Find the pressure ratio and the specific heat addition by the combustion for this cycle. The inlet pressure of an air compressor is 100 kPa, with temperature 290 K, and brings it to 600 kPa, after which the air is cooled in an intercooler to 330K by heat transfer to the...
Quantitative: In the 1950s liquid hydrogen was considered as a fuel for a new type of...
Quantitative: In the 1950s liquid hydrogen was considered as a fuel for a new type of aircraft being developed, the SR-71 Blackbird (shown in Figure 1). Figure 1: The SR-71 Blackbird Early research on the project focused on which fuel to use for the Blackbird. Pratt & Whitney had a J-57 engine that was designed for kerosene and being considered for implementation on the Blackbird. The J-57 only took 5 months to convert to running on liquid hydrogen, however tests...
The solution belongs to the 1st question, i need the solution for the 2nd question. 1....
The solution belongs to the 1st question, i need the solution
for the 2nd question.
1. A single cylinder 1.6 lt, spark ignition engine is operating on the ideal Otto cycle at a compression ratio of 9. The ambient air around the engine is at 1 bar and 20 °C and the fuel consumption of the engine is 13 L/h gasoline at 5600 rpm. Evaluate a. The highest pressure and temperature in the cylinder throughout the cycle b. Net work...
C) Axial-flow compressor Answer 3) Specifie speed (0.) for the compressor compressor should selected? application is 0.9. Which of the following type of 52 th Reciprocating compressor B) none of t...
C) Axial-flow compressor Answer 3) Specifie speed (0.) for the compressor compressor should selected? application is 0.9. Which of the following type of 52 th Reciprocating compressor B) none of these A) Centrifug al compressor 1,) compressor D) Centrifugal fan 6) &7) The compressor is tested at sea level on a stationary atmospheric temperature and pressure is design operating point, the mass flow rate through the compr rotational speed is 7000 rpm. Determine the flow compressor is operating at the...
The Boeing 747 has a cruising altitude of 45,000 feet and cruising speed of 275 m/s....
The Boeing 747 has a cruising altitude of 45,000 feet and
cruising speed of 275 m/s. At this elevation, the temperature and
pressure according to the US Standard Atmosphere (air properties as
a function of altitude) are 220K and 1.8x104 Pa, respectively. The
engines are steady state devices that can be modeled using the 1st
Law of Thermodynamics with air (ideal gas) as the working fluid
undergoing several processes.
a. The inlet area of the engines is 0.5 m2. What...
If you could show all work with explanations that would be
great!! Thanks!!
#2. (30 pts) A turbocharger boosts the inlet air pressure to an automobile engine. It consists of an exhaust gas-driven turbine directly connected to an air compressor, as shown in a below figure. For a certain engine load, the conditions are given in the below figure. Assume that both the turbine and the compressor are reversible and adiabatic, having also the same mass flow rate. Engine power...
Problem 1 - Gas Turbine Engine. Assume the gas turbine engine operates on basic non-ideal Brayton cycle with the following specifications Inlet Condition: Dry air at 537 R and 14.7 psia Pressure Ratio: 24.2 Actual Exhaust Temperature: 950 F Compressor and Turbine Efficiency: 85% Actual Power Output 34 MW Using given/assumed values, determine: a) firing temperature, b) cycle efficiency, c) air mass flow rate. Problem 2- HRSG. Assume the HRSG is used to produce saturated steam at 600 psia using...
Quantitative: In the 1950s liquid hydrogen was considered as a fuel for a new type of aircraft being developed, the SR-71 Blackbird (shown in Figure 1). Figure 1: The SR-71 Blackbird Early research on the project focused on which fuel to use for the Blackbird. Pratt & Whitney had a J-57 engine that was designed for kerosene and being considered for implementation on the Blackbird. The J-57 only took 5 months to convert to running on liquid hydrogen, however tests...
The solution belongs to the 1st question, i need the solution
for the 2nd question.
1. A single cylinder 1.6 lt, spark ignition engine is operating on the ideal Otto cycle at a compression ratio of 9. The ambient air around the engine is at 1 bar and 20 °C and the fuel consumption of the engine is 13 L/h gasoline at 5600 rpm. Evaluate a. The highest pressure and temperature in the cylinder throughout the cycle b. Net work...
C) Axial-flow compressor Answer 3) Specifie speed (0.) for the compressor compressor should selected? application is 0.9. Which of the following type of 52 th Reciprocating compressor B) none of these A) Centrifug al compressor 1,) compressor D) Centrifugal fan 6) &7) The compressor is tested at sea level on a stationary atmospheric temperature and pressure is design operating point, the mass flow rate through the compr rotational speed is 7000 rpm. Determine the flow compressor is operating at the...
The Boeing 747 has a cruising altitude of 45,000 feet and
cruising speed of 275 m/s. At this elevation, the temperature and
pressure according to the US Standard Atmosphere (air properties as
a function of altitude) are 220K and 1.8x104 Pa, respectively. The
engines are steady state devices that can be modeled using the 1st
Law of Thermodynamics with air (ideal gas) as the working fluid
undergoing several processes.
a. The inlet area of the engines is 0.5 m2. What...
Most questions answered within 3 hours.
-
Exercise 2.5. Use the Binomial Theorem to prove that, for all n
≥ 0 and for...
asked 10 minutes ago -
The teachers at Bryan ISD want to examine if a newly developed
intervention program for disadvantaged...
asked 15 minutes ago -
Describe the
characteristics of small business.
- Name the most
common causes of small business failure....
asked 18 minutes ago -
A pendulum is made up of a small sphere of mass 0.500 kg
attached to a...
asked 40 minutes ago -
Given a pn junction with both thin p-type and n-type materials
such that Wn and Wp...
asked 39 minutes ago -
it was discussed that animals should be treated the same as
humans, that pain is pain,...
asked 40 minutes ago -
The vapor pressure of water at 20°C is 17.54 torr. Calculate the
vapor pressure (in torr)...
asked 1 hour ago -
In python:
Create a list called numten that contains ten numbers go through
the list and...
asked 54 minutes ago -
Suppose you just bought the new Windoze 8 and that you realize
that it really sucks....
asked 56 minutes ago -
Hi,
can someone please explain to me the time complexity of an
algorithm specially big O...
asked 1 hour ago -
Python
Prompt the
user to enter a step size to step down by. Write a while
loop...
asked 1 hour ago -
Demonstrate the power of the Containment Theory of Walter
Reckless with regard to the idea of...
asked 1 hour ago