A power plant using a Rankine power generation cycle and steam operates at a temperature of...
A power plant using a Rankine power generation cycle and steam operates at a temperature of 80 oC in the condenser, a pressure of 2.5 MPa in the boiler, and a maximum boiler temperature of 700 oC. Draw the two cycles described below on a temperature-entropy diagram for steam, and answer the following questions.
a) What is the efficiency of this power plant, assuming the pump and turbine operate adiabatically and reversibly? What is the temperature of the steam leaving the turbine?
b) If the turbine is found to be only 85% efficient, what is the temperature of the steam leaving the turbine in this case?
Homework Answers
Add Answer to:
A power plant using a Rankine power generation cycle and steam
operates at a temperature of...
Consider a steam power plant which operates on the simple ideal Rankine cycle (shown in the...
Consider a steam power plant which operates on the simple ideal
Rankine cycle (shown in the next page), where the boiler pressure
is 3 MPa and the condenser saturation temperature is 50°C. The
temperature at the exit of the boiler is 500°C. Water leaves the
condenser as a saturated liquid. The mass flow rate through each
component is 15 kg/s. Calculate:
1. The power output of the steam power plant
2. The thermal efficiency of the steam power plant
Now,...
A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of...
A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of 6 MPa and 50 kPa. The temperature of the steam at the turbine inlet is 450◦C, and the mass flow rate of steam through the cycle is 50 kg/s. (a) Find the temperature, pressure and specific volume at states 1, 2, 3, and 4. (b) Find the heat supplied, heat rejected, work consumed by the pump, work produced by the turbine, net power generation,...
2) A steam power plant operates on an ideal regenerative rankine cycle with superheated steam leaving...
2) A steam power plant operates on an ideal regenerative rankine cycle with superheated steam leaving the boiler, entering the turbine at 10 mPa,600C. X fraction of steam is extracted from the turbine at 0.6 mPa pressure for the high pressure open feedwater heater. Then x fraction more of steam is extracted from the turbine at 0.2 mPa pressure for the low pressure open feedwater heater . The condenser pressure in the cycle is 5 kPa. The mass flow rate...
1. A Steam Power Plant that operates on an ideal regenerative Rankine Cycle with an open...
1. A Steam Power Plant that operates on an ideal regenerative Rankine Cycle with an open feedwater heater is considered. The turbine inlet conditions are 6 MPa, 450 C. The regeneration pressure is 0.4 MPa. The condenser pressure is 20 kPa. a) Draw the T-s diagram, and the sketch of the steam power plant. b) Calculate the low pressure pump work. c) Calculate the high pressure pump work. d) Calculate the fraction of the steam extracted from the turbine for...
A steam plant operates on a reheat Rankine cycle and has a net power output of...
A steam plant operates on a reheat Rankine cycle and has a net power output of 80MW. Steam enters the high pressure turbine at 10 MPa and 500 °C and the low pressure turbine at 1 MPa and 500 °C. Steam leaves the condenser as a saturated liquid at a pressure of 10kPa. The efficiency of the turbine is 80% and the efficiency of the pump is 95%. Determine the thermal efficiency of the cycle. Rankine Cycle with Reheat
Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters...
Consider a 210-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the turbine at 10 MPa and 500°C and is cooled in the condenser at a pressure of 10 kPa. Assume an isentropic efficiency of 85 percent for both the turbine and the pump. (a) the quality of the steam at the turbine exit (b) the thermal efficiency of the cycle (c) the mass flow rate of the steam.
Consider a steam power plant that operates on the ideal regenerative Rankine cycle with a closed...
Consider a steam power plant that operates on the ideal
regenerative Rankine cycle with a closed feedwater heater as shown
in the figure. The plant maintains the turbine inlet at 3000 kPa
and 3508C; and operates the condenser at 20 kPa. Steam is extracted
at 1000 kPa to serve the closed feedwater heater, which discharges
into the condenser after being throttled to condenser pressure.
Calculate the work produced by the turbine, the work consumed by
the pump, and the heat...
Problem 3. Rankine Cycle (90 points) A steam power plant operates with high pressure of 4 MPa and has a boiler exit at 600°C receiving heat from a 700° C reservoir. The ambient air at 20°C provid...
Problem 3. Rankine Cycle (90 points) A steam power plant operates with high pressure of 4 MPa and has a boiler exit at 600°C receiving heat from a 700° C reservoir. The ambient air at 20°C provides cooling to maintain the water/vapor mixture in the condenser at 60°C. All components are ideal (i.e., reversible) except the turbine which has an efficiency 92% ofa reversible isentropic process. Other than the irreversibility of the turbine, the power plant can be considered as...
Consider a steam power plant that operates on a reheat Rankine cycle and has a net...
Consider a steam power plant that operates on a reheat Rankine cycle and has a net power output of 80 MW. Steam enters the high-pressure turbine at 10 MPa and 550°C and the low-pressure turbine at 1 MPa and 550°C. Steam leaves the condenser as a saturated liquid at a pressure of 10 kPa. The isentropic efficiency of the turbine is 80 percent, and that of the pump is 95 percent. Show the cycle on a T-s diagram with respect...
Consider a steam power plant that operates on a reheat Rankine cycle and has a net...
Consider a steam power plant that operates on a reheat Rankine cycle and has a net power output of 80 MW. Steam enters the high-pressure turbine at 10 MPa and 500°C and the low-pressure turbine at 1 MPa and 500°C. Steam leaves the condenser as a saturated liquid at a pressure of 10 kPa. The isentropic efficiency of the turbine is 74 percent and that of the pump is 95 percent. Determine the quality (or temperature, if superheated) of the...
Consider a steam power plant which operates on the simple ideal
Rankine cycle (shown in the next page), where the boiler pressure
is 3 MPa and the condenser saturation temperature is 50°C. The
temperature at the exit of the boiler is 500°C. Water leaves the
condenser as a saturated liquid. The mass flow rate through each
component is 15 kg/s. Calculate:
1. The power output of the steam power plant
2. The thermal efficiency of the steam power plant
Now,...
2) A steam power plant operates on an ideal regenerative rankine cycle with superheated steam leaving the boiler, entering the turbine at 10 mPa,600C. X fraction of steam is extracted from the turbine at 0.6 mPa pressure for the high pressure open feedwater heater. Then x fraction more of steam is extracted from the turbine at 0.2 mPa pressure for the low pressure open feedwater heater . The condenser pressure in the cycle is 5 kPa. The mass flow rate...
1. A Steam Power Plant that operates on an ideal regenerative Rankine Cycle with an open feedwater heater is considered. The turbine inlet conditions are 6 MPa, 450 C. The regeneration pressure is 0.4 MPa. The condenser pressure is 20 kPa. a) Draw the T-s diagram, and the sketch of the steam power plant. b) Calculate the low pressure pump work. c) Calculate the high pressure pump work. d) Calculate the fraction of the steam extracted from the turbine for...
A steam plant operates on a reheat Rankine cycle and has a net power output of 80MW. Steam enters the high pressure turbine at 10 MPa and 500 °C and the low pressure turbine at 1 MPa and 500 °C. Steam leaves the condenser as a saturated liquid at a pressure of 10kPa. The efficiency of the turbine is 80% and the efficiency of the pump is 95%. Determine the thermal efficiency of the cycle. Rankine Cycle with Reheat
Consider a steam power plant that operates on the ideal
regenerative Rankine cycle with a closed feedwater heater as shown
in the figure. The plant maintains the turbine inlet at 3000 kPa
and 3508C; and operates the condenser at 20 kPa. Steam is extracted
at 1000 kPa to serve the closed feedwater heater, which discharges
into the condenser after being throttled to condenser pressure.
Calculate the work produced by the turbine, the work consumed by
the pump, and the heat...
Problem 3. Rankine Cycle (90 points) A steam power plant operates with high pressure of 4 MPa and has a boiler exit at 600°C receiving heat from a 700° C reservoir. The ambient air at 20°C provides cooling to maintain the water/vapor mixture in the condenser at 60°C. All components are ideal (i.e., reversible) except the turbine which has an efficiency 92% ofa reversible isentropic process. Other than the irreversibility of the turbine, the power plant can be considered as...
Most questions answered within 3 hours.
-
The blues made its way into many kinds of music. Eric Clapton,
The Beatles, and Elvis...
asked 1 hour ago -
8. A wave in a string has a wave function given by: y (x, t) =...
asked 21 minutes ago -
If you’re standing at the bottom of a hill and asked to evaluate
it while being...
asked 2 hours ago -
1. Which region has taken the lead in the world of
e-waste handling?
a) European Union...
asked 2 hours ago -
A 8.15- g bullet from a 9-mm pistol has a velocity of 366.0 m/s.
It strikes...
asked 3 hours ago -
The outstanding bonds of Alpha Extracts have a yield to maturity
of 7.4 percent and a...
asked 3 hours ago -
The Problem: The Case of the Harmonizing Vacations
Your CEO is exploring partnering with a European...
asked 5 hours ago -
A chemical equation is balanced by adding coefficients in front
of some formulas so that the...
asked 4 hours ago -
From the literature (reference your sources): What are the
lattice parameters of calcite and aragonite? Why...
asked 5 hours ago -
Your system is rejecting the question am asking which is
preceded by a case study. It...
asked 5 hours ago -
3. On January 2, 2000, Larry creates a trust with himself as
trustee. Larry as trustee...
asked 5 hours ago -
A member of the volleyball team spikes the ball. During this
process, she changes the velocity...
asked 5 hours ago