please answer all parts:
Assume flat voltage profile. For a 3 phase balanced,
solid fault at bus 3, calculate:
A) the fault current
B) fault voltages
at each bus
C) if generator with Xg'' = 0.15 PU is connected to bus 1,
calculate the fault current contribution of the generator
please answer all parts: Assume flat voltage profile. For a 3 phase balanced, solid fault at...
Please help me to answer those question and answer with PHASOR
MAGNITUDE and PHASE ANGLE
Part 1:
Taking the rated power of generator G1 as the base power, and
the transformer T1 low-voltage
side rated voltage as the base voltage, calculate the Thevanin’s
equivalent zero-sequence
impedance, positive sequence impedance and the negative sequence
impedance viewed from
Bus-2. Specify your answers in per-unit.
Part 2:
Assuming the pre-fault bus voltages are at 1.02 pu, calculate the
fault currents in each phase...
Exercise 3 Consider a 2 generator 4 bus power system shown in Figure E3. The impedance data of the network in p.u. are given in Figure E3. A bolted symmetrical three phase fault occurs at bus 4. Assuming the prefault bus voltages as I p.u., calculate the fault current and the current delivered by the generators during the fault and the bus voltages during the fault. j0.12 0.05 0.16 j0.18 j0.12 0.15 0.05 j0.12 j0.1 j0.14 4 (2 Figure E3:...
By MATLAB Code:
Assume all emf = 1 p.u.
ALL Faults happen at BUS 6:
Step 3: Carry out symmetrical fault analysis at bus 6 showing the fault current, bus voltages and line currents during the fault. Step 4: Repeat step 3 with single-line-to-ground fault. Step 5: Repeat step 3 with line-to-line fault Step 6: Repeat step 3 with double-line-to-ground fault. We were unable to transcribe this imageLine & Transformer Data Generator Data From To X-XX 4 0.225 0.400 5...
PLEASE COMPLETE ALL PARTS AND SHOW ALL
WORK.
6. Consider the system shown below. The generator initially supplies 10 MW at unity power factor to the infinite bus. The voltage atthe infinite bus has a magnitude of 1 pu. Note that there is no load at bus 4 L1 G 1 D2 G1 20 kV 20 MVA 3 phase 60 Hz 4 pole X' 0.15 pu H 5 S T 20 kV Y- 169 kV Y 20 MVA 3 phase...
Consider the system shown in the single-line diagram of Figure (3). All reactances are shown in per unit to the same base. Assume that the voltage at both sources is \(1 \mathrm{p}\).u.
a- Find the fault current due to a bolted- three-phase short circuit at bus \(3 .[10\) points \(]\)
b- Find the fault current supplied by each generator and the voltage at each of the buses 1 and 2 under fault conditions. \([10\) points \(]\)
please answer 13.16
at rated load of unity power factor and rated terminal voltage, determine efficienc including field rheostat loss. Ans. 93.139 13.11 A generator under test is rated at 100 KVA, 3-phase, 60-Hz; 2,400 volts. (a) If driven b a de motor unexcited, the motor output is 1.26 KW. (b) If driven by a de motor, generato on open circuit and excited to generate rated potential, the motor output is 2.5 KW. ( Ifdriven by a de motor, generator...