We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
(c) A trapezoidal channel, as shown below, has a base width b = 6 m and...
Q1. For a uniform flow, a trapezoidal channel has a base width b = 8 m and side slopes 11:1V. The channel bottom slope is so = 0.0002 and the Manning roughness coefficient n = 0.016. Compute a) The depth of uniform flow if Q = 14.3 m3/s b) The state of flow. yo У. b= 8 m
('15 Marks) Question 4 An earth drainage ditch may be approximated a trapezoidal channel has a base width b = 6 m and side slopes 1H:1V. The channel bottom slope is So = 0.0002 and the Manning roughness coefficient is n = 0.014. Compute a) the depth of uniform flow if Q = 6.01 m/s b) the state of flow (25 Marks) Chapter 8 Question 5 brick channel designed to carry 5.5
A trapezoidal channel with a bottom width of 8ft and side slopes of 1V:1H is designed for a discharge of 160cfs. If the channel has a slope of 0.002, what will be the water depth if the Manning n is 0.017?
A trapezoidal channel with bottom width of 10 m and side slopes of 1V:1.5H is carrying a flow of 80 m3/s. The channel bottom slope is 0.002 and n = 0.015. A dam is planned that will raise the flow depth to 10 m. Compute the flow depth by using standard step method in the channel 250, 500, and 750 m upstream of the dam.
clear handwriting please. write all steps please. Problem One: A trapezoidal channel of base width 20 ft and side slopes of 1.5H:1V is laid on a slope of 0.001, at a discharge of 1000 ft/s. Compute the flow and draw the surface profile upstream from the overfall to the region where the depth is 10 percent lower than uniform. Assume a manning n- 0.025 and that critical flow occurs at the overfall. Classify the profile.
#4 [5 points] A trapezoidal channel of bottom width 25 ft and side slope 1:2.5 carries a discharge of 450 cfs with a normal depth of 3.5 ft. The elevations at the beginning and end of the channel are 685 and 650 ft., respectively. Determine the length of the channel if n = 0.02. #5 [5 points] Water is flowing at a rate of 4.5 m3/s in a trapezoidal channel whose bottom width is 2.4 m and side slopes are...
A trapezoidal channel has a bottom width, b, of 10.0 m and a side slope ratio of 3:1. The Manning’s n of the channel is 0.025, and it is laid on a slope of 0.001. If the water depth is 2 m at the downstream end, write and submit an R script to compute the water surface profile for a discharge of 30 m3 /s. Also submit a plot of the water profile in elevation (m) for 1000 m channel...
A grouted-riprap, trapezoidal channel (n=0.025) with a bottom width of 4 meters and side slopes of m=1 carries a discharge 12.5 m3/s on a 0.001 slope. a) Find depth of delta(L) using the standard step method b) Find delta(L) where y=yn (1.66m) using direct step method
Question 6 A concrete-lined trapezoidal channel with uniform flow has a normal depth of 1.5 m. The base width is 4 m and the side slopes are equal at 1 vertical to 2 horizontal. Mannin‘s n-0015. The bed slope 0.001 Compute the mean velocity and discharge. If the above channel were to be designed for flooding, it may have a section like in Figure below 8 m 8 m 4 m When the flow goes over the top of the...
4.17. Design a riprap-lined trapezoidal channel that has a capacity of 1000 cfs and a slope of 0.0005 ft/ft. Crushed rock is to be used and the channel bottom width is not to exceed 15 f. Determine the riprap size, the side slopes, and the design depth of flow 4.17. Design a riprap-lined trapezoidal channel that has a capacity of 1000 cfs and a slope of 0.0005 ft/ft. Crushed rock is to be used and the channel bottom width is...