We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
A concentration cellis made using Zn2+ solutions and Zn metal in both beakers but different concentrations....
A battery is constructed at 25ºC using the voltaic cell with initial concentrations Zn│Zn2+ (0.100 M) ││Ag+ (1.500 M) │Ag How much does the cell voltage drop when 95% of the capacity (i.e., the concentration of Ag+ drops to 5% of its starting value) is consumed? The standard reduction potentials for the two half-cells are + Zn2+ + 2e- → Zn Eº = − 0.76 V Ag+ + e- → Ag Eº = 0.80 V
A battery is constructed at 25ºC using the voltaic cell with initial concentrations Zn│Zn2+ (0.100 M) ││Ag+ (1.500 M) │Ag How much does the cell voltage drop when 95% of the capacity (i.e., the concentration of Ag+ drops to 5% of its starting value) is consumed? The standard reduction potentials for the two half-cells are Zn2+ + 2e- → Zn Eº = − 0.76 V Ag+ + e- → Ag Eº = 0.80 V
Information for Questions 8 -9: A concentration cell is set up with two different Zn (s) / Zn2+ (aq) half-cells that contain different concentrations of Zn2+ (aq). The two half-cell solutions are connected with a salt bridge, and the zinc electrodes are connected with a wire and voltmeter. Consider the following standard reduction potential at 25°C: Zn2+ (aq) -0.76 V 2e--> Zn (s) E。= + Use the information here about this concentration cell for Questions 8 and 9. 8. What...
how
would you go about solving this problem via using equations
just looking for the equation order i should go about solving this
problem
In this experiment you will be using the two half reactions Cu?"/Cu and Zn2 /Zn. The standard electrode potential, E°, for these half reactions is +0.34V and-0.76V respectively, so the Nernst Equation for these half reactions is the following Cu ea)+2e - Cus) E - 0.34V 0.0592V Cu2+] 0.0592V Zn 2 Note that solids by definition...
Chem 1212 Lab Report on electrochemistry
Electrochemistry When electrons transfer between reaction components in a redox reaction, we can harness the motion of the electrons to create a potential. Electrochemistry revolves around the separation of the two half-reactions in a redox reaction and establishing two different electrodes. This might involve physically separating the half-reactions or including a separator, such as a semi-permeable membrane or plastic dividers. With the reactions separated, the electrons will need to flow through the wire connecting...
need help with the rest of the table
EXPERIMENT 10 DETERMINATION OF THE ELECTROCHEMICAL SERIES PURPOSE To determine the standard cell potential values of several electrochemical coll INTRODUCTION The basis for an electrochemical cell is an oxidation reduction Corredor be divided into two half reactions reaction. This reaction can Oxidation half reaction Gloss of electrons) takes place at the anode, which is the positive electrode that the anions migrate to Chence the name anode) Reduction half reaction (gain of electrons)...
Can't figure out the concentration of the complex of
solns. 10, 11, 12, 13, & 14.
Modern Experimental Chemistry Chemistry 153 The Iron(III) Thiocyanate Complex Purpose of the Experiment To determine the chemical formula of a complex ion and measure its formation equilibrium constant Equipment Spectro Vis spectrophotometer and LabQuest, cuvette, 25-mL buret (3), ring stand, buret clamp (2), 50-mL beaker (3), small plastic beakers Reagents SCN, as KSCN, 0.00200 M solution Fe; as Fe(NO), 0.00200 M solution and a...
Page 1 and 2 are instructions. Please help me solve K for page 3
and page 4 and please check the other work on Page 3.
Thanyou very much. Will Rate!
CHM 112 Electrochemical Cells and Thermodynamics Section A. Constructing a Small-Scale Electrochemical Cell Woodbridge Campus Objective To construct a small-scale electrochemical cell using a redox system, to measure the cell potential and derive thermodynamic quantities. Procedures 1. Connect the red and black alligator clips to the multimeter to read...
5. What was the purpose of the NaNO3 solution in this experiment? 6. Could a solution of NaCl be used instead of NaNO3? 7. What was the purpose of FeSO4 solution in this experiment? 8. Could a solution of FeCl, be used instead of FeSO4? 9. Could a solution of NaSO4 be used instead of FeSO4? 10. Calculate the standard cell potential for the spontaneous redox reaction between a Pb(s)/Pb(NO3)2(aq) half-cell and a Ag(s)/AgNO3(aq) half-cell. Which metal would be oxidized?...
please help answer question 4, a-f please
using the data below from chart 1
objectives from lab, thank you
DATA:CA y 3 Ay No3 Part I: Cell Potential of voltaic cells under standard conditions: cell CU CND2 #27 14.0m Give the half Half cell reaction at Combinations Oxidation Reduction E the anode and with [ion] takes place Theoretical takes place cathode. Write in M here here (V) above the arrow E c (V) if it is oxidation or reduction. |-0.340...