*Please help!* Link BD is 6.4 mm thick and is made of a steel with a...
Link BD is 5.6 mm thick and is made of a steel with a 566 MPa ultimate strength in tension. What should be its width, w, in mm if the structure shown is being designed to support a 17.9 kN load with a factor of safety of 3.1? LAB=189 mm and LBC=149 mm. Note: Your answer should be given in the requested units and be to 1 decimal place. Suggestion: Work out the problem symbolically and then plug in the...
show every step 2·The link BC is 1-6mm thick (into the page) and has width, w(that is, the cross section of the link is t by w). The link is made of steel, with an ultimate strength of 450 MPa in tension. What should the width of the link be if 40 480mm the structure is designed to support a load of P- 20 kN with a factor of safety equal to 3. (Hint: BC is a two-force member.) Ans:...
Determine the sheer stress (in ksi) of pin C if structure shown is being designed to support a 6.4 kip load. Pin C has a diameter of 0.7 in, LAB IS 15.2 in and LBC is 6.4 in VOICE CU MENU 93.3 4070 98.5 AM Fri Jul 31 mycourses tudu This test does not allow backtracking. Changes to the answer after submission are prohibited. Your answers are saved automatically. Remaining Time: 1 hour, 03 minutes, 21 seconds. Question Completion Status:...
help Op File File Edit View Chat Window Help 95% Bryant today at 12:03 PM Fri 12:04 PM Determine the shear stress (in ksi) of pin C if the structure shown is being designed to support a 5.3 kip load. Pin C has a diameter of 0.54 in, LAB is 12.8 in and LBC is 10 in. Note: Your answer should be given in the requested units and be to 1 decimal place. D Front view D w CB B...