Length of column = 30.50 cm
Flow rate = 0.313 mL/min
A chromatogram of a mixture of species A, B, C, and D provided the following data:
Species |
Retention time, minutes |
Width of peak base (W), minutes |
A |
5.4 |
0.41 |
B |
13.3 |
1.07 |
C |
14.1 |
1.16 |
D |
21.6 |
1.72 |
Calculate the resolution for species C and D
We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
Length of column = 30.50 cm Flow rate = 0.313 mL/min A chromatogram of a mixture...
The following data applies to a column for liquid chromatography: Use this information to answer the question below Length of column = 30.50 cm Flow rate = 0.313 mL/min A chromatogram of a mixture of species A, B, C, and D provided the following data: Species Retention time, minutes Width of peak base (W), minutes А 5.4 0.41 B 13.3 1.07 C 14.1 1.16 D 21.6 1.72 Calculate the resolution for species C and D Select one: O A 2.60...
Two compounds C and D are separated on a column 34 cm long . Given the chromatographic data below calculate The column resolution? , the number of theoretical plates ?the height of theoretical plate and what length of column would be required to give a resolution of 1.5? Compound C retention time 18.3 width at base of peak(min) = 2.18 Compound D retention time 17.7, width at base 1.23
(3) During the separation of two steroids by HPLC on a C18 column, a student reported the following elution times with a certain % acetonitrile/water mobile phase (uracil was added to the steroid mixture) tm (uracil) 1.2 min t, (steroid1) 4.55 min t, (steroid2) 6.55 min base width, w (steroid 1) 0.56 min base width, w (steroid 2) 0.79 min a. Sketch the chromatogram to illustrate the above separation. Label the peaks and the x- and y-axis. Calculate the resolution...
2.0 EXAMPLEI : The following data were obtained for a separation using a 0.5 mm id, 10 meter open tubular column: Retention time (min) Peak base width (min) Methane Cyclohexane 8.0 0.65 Methylcyclohexane 8.17 0.72 Toluene 10.2 0.95 a)Draw the chromatogram and label the peaks b) Calculate the number of theoriticla plate for each compound (N) and palte height (H) c) Calculate the capacity factor for each compound d) the resolution between tow consequent peak R, e) Calculate the length...
help needed with this problem set Refer to the HPLC chromatograms below for a 5-component mixture of organic acids for the following questions. The specific HPLC parameters for chromatogram A (top) are described in the figure title and the insert. You only need the lecture notes and/or your personal experience to answer those questions. Mobile phase: 30 % MeCN, 70 % TFA, 0.1 M (pH 2.0) low rate: 1.0 mL/min 2Benzok Acid Maleic Aci 1. (a) Which component has the...
3. a) b) c) How many theoretical plates produce a chromatography peak eluting at 4.78 min with a full width at half max (FWHM) of 1.20 s? The length of the column is 30.0 m. What is the plate height in microns? What is the peak resolution for this peak and another peak eluted at 4.73 minutes that has a full peak width (measured at the base) of 2.14 seconds? Is this sufficient for quantitative analysis of those two components?...
The flow rate was 1.00 mL/min and the column mobile phase volume was 1.80 mL. The stationary phase volume was 0.140 mL. For the compound with the peak at 2.75 min, what was the partition coefficient between the gas phase and the stationary phase at 150 degree C.
EXERCISE 6: Two chemical species, A and B are separated by isothermal gas chromatography, using a 2.00 m column having 5000 theoretical plates at a flow rate of 15.0 ml / min. The peak of unabsorbed air appears after 30 s; the peak of A appears after 5 min and that of B after 12 min (a) Calculate the dead volume VM of the column, and the retention volumes Va and VB. (b) Calculate the reduced volumes V’a and V'B...
A group of analysts was working on developing a method to separate and determine carbamate insecticides used for control of pests in food production They used HPLC with an Eurospher 100-5 C-18 column and a mobile phase consisting of a mixture of water and methanol, with post-column derivatization. .The column was determined to have an average of 1999 theoretical plates for this group of compounds. The stationary and mobile phases volumes in the column were SMV = 0.51mL, V =...
For the table below, design an ion exchange system for the removal of calcium. The flow rate to be treated is 5.45 ML/d. The system should be sized so that the minimum time between regenerations is 72 h. The column diameter should be 3 m and there should be at least 2 columns. Pilot testing indicates optimal regeneration efficiency corresponded to using 10% NaCl solution (specific gravity = 1.07) at a salt usage rate of 310 kg NaCl per m3...