option b is correct
Final Exam, Spring 2019 ENEE 3518 (5pts) 15. A function generator with 100Hz square wave and...
(5pts) 11. A 0.5V peak-to-peak 1kHz sine wave with a 100mV DC offset is provided as the input into a non- inverting operational amplifier with a gain of 20. If the output of the op-amp is read using an oscilloscope with AC coupling, then the value is close to a. 2V DC b. 2V peak-to-peak 1kHz sine wave c. 10V peak-to-peak 1kHz sine wave with 2V DC offset d. 10V peak-to-peak 1kHz sine wave only (5pts) 12. Which of the...
The following questions pertain to the circuits shown below. ЗmA 6mA 30 M2 ? 15 ΜΩ In an amplifier design, your company has a non-ideal current source. The amplifier acts like a resister of 15MS2 but can only take 3mA as input or it will overheat and cease function. It was discovered in testing e that the above schematic delivered 4mA to the amplifier and most of the amps burned out. Over 1000 of these amps have already been built...
c sine wave with phase shift d. none of the above The following questions pertain to the circuits shown below. 3mA 15 M2 6 mA ? 330MS In an amplifier design, your company has a non-ideal current source. The amplifier acts like a resister of 15MA but can only take 3mA as input or it will overheat and cease function. It was discovered in testing that the above schematic delivered 4mA to the amplifier and most of the amps burned...
thanks Laboratory 1: operation amplifier characteristics A. Objectives: 1. To study the basic characteristics of an operational amplifier 2. To study the bias circuit of an operational amplifier B. Apparatus: 1. DC Power supply 2. Experimental board and corresponding components 3. Electronic calculator (prepared by students) 4. Digital camera (prepared by students for photo taking of the experimental results) 5. Laptop computer with the software PicoScope 6 and Microsoft Word installed. 6. PicoScope PC Oscilloscope and its accessories. 7. Multimeter...
Vout should be a sinusoid signal of 12Vp-p Dc voltage to uA741 : +/-8.5V Please simulate as well please help, im completely lost on this this is all of the information Experiment 5. RC Sinusoidal Oscillators PURPOSE: This laboratory provides an introduction to the background, analysis and design of sinusoidal oscillators using RC feedback networks and active devices to achieve the criteria for continuous oscillations to occur. EQUIPMENT REQUIRED : 1 Operational amplifier u.A741 1 CEU development station Resistors and...