Compute the pressure loss in Pascals through a 4 inch 90 degree standard elbow with a...
Compute the pressure loss in Pascals through a 4 inch 90 degree standard elbow with a L/D ratio of 30. The initial pressure is 90 psi and it must carry a flow of 0.236 cubic meters/second.
Homework Answers
Answers may slightly varry for selction of data from data book for properties of water. Please forgive me for any calculation mistake and do comment for any short of queries.
Add Answer to:
Compute the pressure loss in Pascals through a 4 inch 90 degree
standard elbow with a...
Compute the pressure loss in Pascals through a 4 inch 90 degree standard elbow with a...
Compute the pressure loss in Pascals through a 4 inch 90 degree standard elbow with a L/D ratio of 30. The initial pressure is 90 psi and it must carry a flow of 0.236 cubic meters/second.
I need help with this whole page. I got them all wrong Determine the approximate pressure...
I
need help with this whole page. I got them all wrong
Determine the approximate pressure change in 4.00 meter acceleration of 2.00 meters per second Euler Eq 18 Water flows up through the vertical pipe at a flow rate of 0.0300 m'/s and h is 508.6 mm velocity and static pressure at point D? (This can be worked via two methods, outline two algebra, and numerically complete a solution. Check your work by the other method Pascals along a...
Threaded regular 90° elbow Square-edge exit Square-edge entrance Half-open gale valve Miter 90° elbow Open globe...
Threaded regular 90° elbow Square-edge exit Square-edge entrance Half-open gale valve Miter 90° elbow Open globe valve Water is pumped between two reservoirs through a 5 cm diameter pipe that is 12.2 m long with a number of minor losses shown in the image. The elevation difference between the two reservoirs is Az = 2.8 m. For a pipe roughness ratio of e/D=0.001, what is the minimum pump power (in W) required to move 30°C water at a volumetric flow...
3. A pump draws water at 15°C from a well through 10 m of 3 inch...
3. A pump draws water at 15°C from a well through 10 m of 3 inch sch 40 steel pipe. The pump is 7 m above the water level in the well. The pump discharges the water -horizontally through 30 m of 3 inch sch 40 steel pipe to a sprinkler. There is one check valve (ball type), and three 90° standard elbow installed at various places in the system. The pressure into the sprinkler should be 500 kPa and...
Problem 3 Pictured to the right is a pipe with a 90 degree bend and an annulus (a solid pipe on t...
Problem 3 Pictured to the right is a pipe with a 90 degree bend and an annulus (a solid pipe on the inside). An important consideration in pipe flow is the losses due to friction, D which is called head loss, h, and is measured in meters. Dimesnionlessly, we can say the following: ionlessly, we can say the following: L V2 Di Do Where the pipe dimensions are listed on the diagram, is average flow velocity, p is viscosity, and...
Problem 3 Pictured to the right is a pipe with a 90 degree bend and an annulus (a solid pipe on t...
Problem 3 Pictured to the right is a pipe with a 90 degree bend and an annulus (a solid pipe on the inside). An important consideration in pipe flow is the losses due to friction, which is called head loss, h, and is mea sured in meters. Dimesnionlessly, we can say the following: Where the pipe dimensions are listed on the diagram, V is average flow velocity, H is viscosity, and p is density A) Assume you have a real...
A system using 10-inch (10") internal diameter pipe requires a selection of flanged valves. Consider 10"...
A system using 10-inch (10") internal diameter pipe requires a selection of flanged valves. Consider 10" ball valves, gate valves, globe valves, and check valves in the fully-open position; and butterfly valves in a variety of open positions. FNW has been chosen as the equipment supplier; the relevant data sheets can be found on Desire2Learn (see below for information on valve part numbers and cor- responding files). The data sheets give valve coefficients (C,): flow rates in GPM corresponding to...
Check m A five-story bullding plan is shown in figure (a). Following the ASCE standard, the wind pressure along t...
Check m A five-story bullding plan is shown in figure (a). Following the ASCE standard, the wind pressure along the helght the windward side has been established as shown in the figure (c). on (1 2 4 5 D 4@ 25'- 100 Plan (a) roof 20 5 4 15 13 2 wind pressures in Ib/ft2 Building Section 5@ 12'= 60- 3 @30'=90 3 @ 20= 60 Considering the windward pressure in the east-west direction, use the tributary each floor level....
Water is being pumped from reservoir A to reservoir F through a 30-m long PVC pipe...
Water is being pumped from reservoir A to reservoir F through a 30-m long PVC pipe (e 0) of diameter 0.150 m. There is an open gate valve located at C; 90 bends (threaded) located at B. D and E; and a pump shown with the letter P. The pump is required to deliver 0.25 m'/s of water to reservoir F from A. NOTE: p. 1000 kg/m. y=9.80 kN/m, v= 1.12 x 10 m/s L-30-m to' -0.25m %2 10 m...
Please solve a,b,c,d,e,f 1) A water fountain is to be installed at a remote location by attaching a cast iron pipe directly to a water main through which water is flowing. The entrance to the pipe...
Please solve a,b,c,d,e,f
1) A water fountain is to be installed at a remote location by attaching a cast iron pipe directly to a water main through which water is flowing. The entrance to the pipe is sharp-edged 15m (K-0.5), and the 15m long piping system involves three 90 bends without vanes (K1.1), a fully open gate valve (K.-0.2), and a fully open angle valve (K-5). If the diameter of the pipe is 2 em and the system is to...
I
need help with this whole page. I got them all wrong
Determine the approximate pressure change in 4.00 meter acceleration of 2.00 meters per second Euler Eq 18 Water flows up through the vertical pipe at a flow rate of 0.0300 m'/s and h is 508.6 mm velocity and static pressure at point D? (This can be worked via two methods, outline two algebra, and numerically complete a solution. Check your work by the other method Pascals along a...
Threaded regular 90° elbow Square-edge exit Square-edge entrance Half-open gale valve Miter 90° elbow Open globe valve Water is pumped between two reservoirs through a 5 cm diameter pipe that is 12.2 m long with a number of minor losses shown in the image. The elevation difference between the two reservoirs is Az = 2.8 m. For a pipe roughness ratio of e/D=0.001, what is the minimum pump power (in W) required to move 30°C water at a volumetric flow...
3. A pump draws water at 15°C from a well through 10 m of 3 inch sch 40 steel pipe. The pump is 7 m above the water level in the well. The pump discharges the water -horizontally through 30 m of 3 inch sch 40 steel pipe to a sprinkler. There is one check valve (ball type), and three 90° standard elbow installed at various places in the system. The pressure into the sprinkler should be 500 kPa and...
Problem 3 Pictured to the right is a pipe with a 90 degree bend and an annulus (a solid pipe on the inside). An important consideration in pipe flow is the losses due to friction, D which is called head loss, h, and is measured in meters. Dimesnionlessly, we can say the following: ionlessly, we can say the following: L V2 Di Do Where the pipe dimensions are listed on the diagram, is average flow velocity, p is viscosity, and...
Problem 3 Pictured to the right is a pipe with a 90 degree bend and an annulus (a solid pipe on the inside). An important consideration in pipe flow is the losses due to friction, which is called head loss, h, and is mea sured in meters. Dimesnionlessly, we can say the following: Where the pipe dimensions are listed on the diagram, V is average flow velocity, H is viscosity, and p is density A) Assume you have a real...
A system using 10-inch (10") internal diameter pipe requires a selection of flanged valves. Consider 10" ball valves, gate valves, globe valves, and check valves in the fully-open position; and butterfly valves in a variety of open positions. FNW has been chosen as the equipment supplier; the relevant data sheets can be found on Desire2Learn (see below for information on valve part numbers and cor- responding files). The data sheets give valve coefficients (C,): flow rates in GPM corresponding to...
Check m A five-story bullding plan is shown in figure (a). Following the ASCE standard, the wind pressure along the helght the windward side has been established as shown in the figure (c). on (1 2 4 5 D 4@ 25'- 100 Plan (a) roof 20 5 4 15 13 2 wind pressures in Ib/ft2 Building Section 5@ 12'= 60- 3 @30'=90 3 @ 20= 60 Considering the windward pressure in the east-west direction, use the tributary each floor level....
Water is being pumped from reservoir A to reservoir F through a 30-m long PVC pipe (e 0) of diameter 0.150 m. There is an open gate valve located at C; 90 bends (threaded) located at B. D and E; and a pump shown with the letter P. The pump is required to deliver 0.25 m'/s of water to reservoir F from A. NOTE: p. 1000 kg/m. y=9.80 kN/m, v= 1.12 x 10 m/s L-30-m to' -0.25m %2 10 m...
Please solve a,b,c,d,e,f
1) A water fountain is to be installed at a remote location by attaching a cast iron pipe directly to a water main through which water is flowing. The entrance to the pipe is sharp-edged 15m (K-0.5), and the 15m long piping system involves three 90 bends without vanes (K1.1), a fully open gate valve (K.-0.2), and a fully open angle valve (K-5). If the diameter of the pipe is 2 em and the system is to...
Most questions answered within 3 hours.
-
convert grams into vloume with the density of water being at
.997514 g/cm^3 at 23.1 Celsuis...
asked 1 hour ago -
Foreman company obtained a $20,000, 6% loan on May 1, 2018.
Principal and interest will be...
asked 1 hour ago -
5. Problem 11.05 (Discounted Payback)
eBook
Project L costs $60,000, its expected cash inflows are $14,000
per...
asked 1 hour ago -
1. Which of the following is true about politics and health
organizations?
A. Health organizations are...
asked 2 hours ago -
A space vehicle is coasting at a constant velocity of 18.1 m/s
in the +y direction...
asked 3 hours ago -
5) Use the following balanced equation to answer questions
(a)-(i).
3 Cu(s) + 8 HNO3(aq) →...
asked 2 hours ago -
A three-year maturity bond with a 12% annual coupon rate is
currently traded at par $1000...
asked 3 hours ago -
1.
What is the minimum volume to use in the Spec 20 cuvette in order
to...
asked 3 hours ago -
A builder wants to install wall-to-wall carpeting in a living
room of length 8.87 m and...
asked 3 hours ago -
Organizational change can produce anxiety in those affected by
the change. In what ways can change...
asked 3 hours ago -
Ozone in the atmosphere may react with nitric oxide.
From the following data, calculate the DG...
asked 3 hours ago -
Steven Long, a bond analyst, is analyzing a convertible bond.
The characteristics of the bond are...
asked 3 hours ago