Pump - 5] 24 hW of power is supplied to a pump system, with 10 kw...
Question 18 (10 April 2020) 51.5 kW 12 cm Pump An oil pump is drawing 51.5 kW of electric power while pumping oil with p= 860 kg/m3 at a rate of 0.23 m3/s. The inlet and outlet diameters of the piper are 8 cm and 12 cm, respectively. If the pressure rise of oil in the pump is measured to be 500 kPa and the motor efficiency is 87.5 percent, determine the mechanical efficiency of the pump. Motor 8 cm...
A motor which is used to rotate a pump consumes 20 kW energy. Its efficiency is 85%. a. What is the power delivered to the pump by the motor? b. The pump whose pipe diameter is 10 cm delivers the water at a mass flow rate 3 kg/s. What is the velocity of water? Assume density of water is 1000 kg/m3.
Question 1 of 2) A pully drive system is used to transmit power from a diesel engine to a hydraulic pump. The diameter of the smaller pully is 5 (cm). ine diesel engine produces 9.9 (kW) of mechanical power at speed of 2100 (RPM) in its optimum operating point. ne hydraulic pump needs 110 (N.m) of torque to provide hydraulic gage pressure of 220 (bar) at efficiency of 75%. Calculate the followings: 1) Assuming that the diesel engine is running...
HELPPPP 5 Hydraulic Press ●4 11.0 ft Flow 10.0 ft 2.0 ft 1 6 3.0 ft Filter Pump Flow The diagram on the next slide shows a fluid power system for a hydraulic press. The following is known: The volume flow rate is 35 gpm. The hydraulic fluid has a specific gravity of 0.87 and v-4.30X10+ ft'/s. The power input to the pump is 20 hp. . The pump efficiency is 80 percent. The filter has a resistance coefficient K-1.85...
Hydraulic Press 11.0ft Flow 10.0 ft 2.0ft 6 3.0 ft Filter Pump Flow The diagram on the next slide shows a fluid power system for a hydraulic press The following is known: The volume flow rate is 35 gpm. The hydraulic fluid has a specific gravity of 0.87 The power input to the pump is 20 hp. The pump efficiency is 80 percent. The filter has a resistance coefficient K-1.85 based on the velocity head in the suction line All...
Please show detailed work and write clearly.Thank you. A chilled-water system requires a 100 gal/min pump with 40 ftWG of head. Select the most appropriate pump from the pump curves in the figure below. State the efficiency, motor power input, impeller size, and NPSH requirement for your selection. Note that the pump may not be a precise match to the specified flow condition Capacity (L/s) 10 12 18 60% 40% 50%: 55%,65% о, 68% 67% 7" 1750 50 68% 12...
9. The absolute pressure in water at a depth of 5 m is 145 kPa. What is the absolute pressure in a liquid whose specific gravity is 1.34 at the same depth? Hint: Determine the atmaspheric pressure first 10. Water is pumped from a lake to a storage tank 30 m above at a rate of 55 L/s, while consuming 22.6 kW of electrie power to run the motor. Detemine the overall efficiency of the motor-pump unit. .A hydraulic power...
A house is located near a freshwater lake. The homeowner decides to install a pump near the lake to deliver 25 gallons/min (0.0557 ft3/s) of water to a tank adjacent to the house to be used for plumbing and the lawn. For the systenm shown n the figure below 1. Determine the power that the pump must supply to the fluid i order to maintain the flow rate, specify your answer in Horsepower 2. State how much power must be...
A pump station must fill a 15-million-gallon tank within 10 hours. The pump must overcome a total head of 115 feet (this include both elevation head and friction). Assume the pump and motor efficiency are 0.75 and 0.90, respectively. Water temperature is 80°F. Assume the cost of electricity is $0.22/(kW-h). What is the yearly cost to operate the pump station? Round your answer to the nearest whole dollar. (Conversion factor: 1 horsepower = 745.7 W)
A pump station must fill a 15-million-gallon tank within 10 hours. The pump must overcome a total head of 115 feet (this include both elevation head and friction). Assume the pump and motor efficiency are 0.75 and 0.90, respectively. Water temperature is 80 °F. Assume the cost of electricity is $0.22/(kW-h). What is the yearly cost to operate the pump station? Round your answer to the nearest whole dollar. (Conversion factor: 1 horsepower = 745.7 W)