If concentrated phosphoric acid is 14.7 M, how many ml of acid would you use to make 400 ml of 2N phosphoric acid?
If concentrated phosphoric acid is 14.7 M, how many ml of acid would you use to...
Barium hydroxide reacts with phosphoric acid to form barium phosphate and water. How many mL of 0.2195 M barium hydroxide would be required to titrate 12.57 mL of phosphoric acid? (Density of ohosphoric acid is 1.834 g/mL.) >> answer should be 1608 mL
A test procedure requires 500mL of a 4N phosphoric acid solution. The concentrated phosphoric acid available has a specific gravity of 1.69 and an assay of 85%. How would you prepare this solution? (MW H3PO4 = 98) (Valence is 3)
Part A.How many moles oh phosphoric acid will be formed upon the complete reaction of 25.2 grams of diphosphorus pentoxide with the excess water? Part B. how many grams of bromine trifluordie are necessary to form 0.485 moles fluorine gas ? Part C. you wish to make a 0.202 M hydrochloric acid solution from a stock solution of 3.00 M hydrochloric acid. How much concentrated acid must you add to obtain a total volume of 50.0 mL of the dilute...
Commercial concentrated ammonia NH3 is 14.5 M. How many mL of concentrated ammonia would be needed to prepare 1.00 L of 2.00 M NH3?
Question 1: In the laboratory you dilute 3.33 mL of a concentrated 6.00 M hydrochloric acid solution to a total volume of 75.0 mL. What is the concentration of the dilute solution? M Question 2: You wish to make a 0.153 M hydroiodic acid solution from a stock solution of 3.00 M hydroiodic acid. How much concentrated acid must you add to obtain a total volume of 100 mL of the dilute solution? mL Thank-you!
2. a. Both concentrated sulfuric acid and concentrated phosphoric acid are known to catalyze the conversion of cyclohexanol to cyclohexene via dehydration reaction. Concentrated hydrochloric acid, however, is not a viable option. Provide two reasons on what make sulfuric acid and phosphoric acid advantageous over hydrochloric acid. Look up additional information on these acids if needed. b. In preparation of the bromohydrin (trans-2-bromo-1-methylcyclohexanol) with bromine, side products dibromides shown below are often observed. This side reaction can be essentially avoided...
concentrated phosphoric acid solution is 85.5% H3PO4 by mass and has a density of 1.69 g/mL at 25°C. What is the molarity of H3PO4? What is the mole fraction of urea, CO(NH2)2, in a solution prepared by dissolving 5.6 g of urea in 30.1 g of methanol, CH3OH? How will an understanding of this concept help you in your healthcare career?
22. The pH of 100 ml of 0.1 M phosphoric acid is 2.5, sketch the titration curve obtained by titrating the phosphoric acid solution with 0.2 M sodium hydroxide. Show clearly how you calculate the values used to plot the curve. (Use Ka values given in no. 15)
Phosphoric acid, HiPO, is prepared from phosphate rocks by the following equation 11. 3CaSO4), Cas(PO)2(s) +3H, SOA2HPO can be produced from 1.00 x 10 kg of Ca (Pos, and excess of (a) How many kilograms of HsPO, (b) If all of H,PO, obtained in part (a) is converted into concentrated phosphoric acid solution, how ,so, if the yield is 92.0% many liters of concentrated HPO, will be produced? (Concentrated phosphoric acid has density 1.685 g/mL and contains 85.0% by mass...
You have a sample of 87.1 mL of 2.2 M phosphoric acid solution in the lab. If you want to completely react (neutralise) the acid with a solution 1.6 M sodium hydroxide, What volume (in mL) of the basic solution will need to be used?