![09 Tout C) Tarom 02 0.8 0.4 0.6 m. lkg/s] — Twout — Tair,out Tout CD in cho Tout C 0 0.2 0.8 0.4 0.6 m. [kg/5) - Tair, out —](http://img.homeworklib.com/questions/d92f4d90-6b29-11eb-9c74-51a1d13841d8.png?x-oss-process=image/resize,w_560)
![Tout ino TICI 0 0.2 0.8 0.4 0.6 m. [kg/5] -Twout — Tair,out Twout on 60 Teicot C) 0.2 0.4 0.6 0.8 Tair, out - Twout](http://img.homeworklib.com/questions/d998e160-6b29-11eb-970b-03d8e452ca6e.png?x-oss-process=image/resize,w_560)
Homework Answers
Add Answer to:
A counter-flow heat exchanger is stated to have an overall heat transfer coefficient of 284 W/m2.K...
Problem 2: Heat exchanger (25 points) Cold water (op 4179 J/kg K) enters the tubes of a heat exchanger at 20 °C at a rate of 3 kgs. while hot oil (cp 2200 J/kg.K) enters the shell at 130 C at the sam...
Problem 2: Heat exchanger (25 points) Cold water (op 4179 J/kg K) enters the tubes of a heat exchanger at 20 °C at a rate of 3 kgs. while hot oil (cp 2200 J/kg.K) enters the shell at 130 C at the same mass flow rate and leaves at 60°C The heat exchanger consistsoftwo shells and 20 tubes, each executing four passes (two passes per shell). If the W/m2-K, assume the tube wall is very thin with convective heat transfer...
[10] Design Problem As shown in the figure below, a double-pipe parallel-flow heat exchanger is used...
[10] Design Problem As shown in the figure below, a double-pipe parallel-flow heat exchanger is used to heat cold fluid which is water (Cp = 4180 J/(kg.K), p = 1000 kg/m) from 20°C to 80°C at a rate of 0.15 kg/s. The heating is to be accomplished by hot fluid, which is geothermal water (Cp = 4310 J/(kg.K), p = 1050 kg/m²) available at 130°C at a mass flow rate of 0.25 kg/s. The inner tube has an inner diameter...
Problem X3-5, Heat Transfer, Spring 2018 A single-pass, double-tube counterflow heat exchanger will be used to...
Problem X3-5, Heat Transfer, Spring 2018 A single-pass, double-tube counterflow heat exchanger will be used to heat a 0.14 kg/s stream of water nowing in the 12-mm diameter inside tube. The water in the inside tube enters the heat exchanger at 25 C. The water will be heated with a 0.12 kg/s m of hot water flowing in the annulus between the inside and outside tube that enters the heat exchanger at 80°C. UP the hot and cold streams, and...
6 Problem 4 (25%) A 2-shell passes and 4-tube passes heat exchanger is used to heat...
6 Problem 4 (25%) A 2-shell passes and 4-tube passes heat exchanger is used to heat glycerin (Cp.gly = 2447) entering at 15 °C by hot water (Cp water = 4180 f.), which enters at 90°C. The thin-walled inner tube has a 4 cm diameter and a total length of 15 m. The hot water flows through the tube at a total rate of 0.265 kg/s, and the glycerin through the shell at a rate of 0.6 kg/s. The convection...
this problem in heat exchanger, please solve. . In a parallel flow heat exchanger, hot liquid...
this problem in heat exchanger, please solve.
. In a parallel flow heat exchanger, hot liquid enters at 400°C and leaves at 250°C. Cold fluid enters at 50°C and leaves at 110°C. The inside and outside heat transfer coefficients are 120W/m2 K and 190 W/m2 K respectively. The inside and outside diameters of tube are 0.06 m and 0.08 m respectively. If the heat transferred per hour is 1.6x 105 kJ. Determine the length of tube required. Ans:12.5 m
Twenty [kw] of heat is to be removed from 375 [k] water flowing at 0.15 [kg/s] into the inner pipe of concentric tube heat exchanger. Cooling water enters the annulus at 290 [k] and leaves at 320...
Twenty [kw] of heat is to be removed from 375 [k] water flowing at 0.15 [kg/s] into the inner pipe of concentric tube heat exchanger. Cooling water enters the annulus at 290 [k] and leaves at 320 [k] with a flow in the opposite direction of the inner flow. The diameter of the thin- walled inner pipe is 2.5 [cm] a) b) c) Calculate the exit temperature of the hot fluid and the mass flow rate of the cold fluid...
Question 5 The following data is given for counter flow in concentric tube heat exchanger, mean...
Question 5 The following data is given for counter flow in concentric tube heat exchanger, mean heat transfer area = 0.02 m2 Test No Flow rate hot Flow rate Tin hotTout hot|Tin cold Tout cold (L/min) cold (L/min) (THI) (TH2) (TCI) (TC2) 13 1 60 56 30 42 a) Calculate the heat transfer rate in kW. b) The overall heat transfer coefficient U. c) The mean temperature efficiency of the two circuits (ń).
Hot water flows thorough a parallel flow heat exchanger at a rate of 10 kg/min and...
Hot water flows thorough a parallel flow heat exchanger at a rate of 10 kg/min and is cooled by a cold water stream of flow rate 25 kg/min. The inlet temperatures of hot and cold water streams are 70 oC and 25 oC, respectively. The outlet temperature of the hot water is expected to be 50 oC. The individual convective heat transfer coefficient on both sides of the heat transfer area is 600 W/m2 .K. Take the specific heat for...
2. (35P) Ashell-and-tube heat exchanger with 1-shell pass and 20-tube passes is used to heat glycerin...
2. (35P) Ashell-and-tube heat exchanger with 1-shell pass and 20-tube passes is used to heat glycerin (Cp = 2480 J/kg) in the shell, with hot water in the tubes. The tubes are thinwalled and have a diameter of 1.5 cm and length of 2 m per pass. The hot water (Cp=4180 J/kg Centers the tubes at 102°C at a rate of 9 kg/s and leaves at 55°C. Overall heat transfer coefficient U=13900 W/m2C. The glycerin enters the shell at 15°C...
Question 3 A counter flow single pass double pipe heat exchanger is supplied with hot water...
Question 3 A counter flow single pass double pipe heat exchanger is supplied with hot water at 120°C that is to be cooled by water entering at 20°C. The mass flow rate of the hot stream is 5 kg/s, and that of the cold stream is 6 kg/s. The specific heat capacity of both fluids may be taken as 4180 J/kg.K. The overall U value is 1500W/m2.K, and the surface area for heat transfer is 20 m2 a) Determine the...
Problem 2: Heat exchanger (25 points) Cold water (op 4179 J/kg K) enters the tubes of a heat exchanger at 20 °C at a rate of 3 kgs. while hot oil (cp 2200 J/kg.K) enters the shell at 130 C at the same mass flow rate and leaves at 60°C The heat exchanger consistsoftwo shells and 20 tubes, each executing four passes (two passes per shell). If the W/m2-K, assume the tube wall is very thin with convective heat transfer...
[10] Design Problem As shown in the figure below, a double-pipe parallel-flow heat exchanger is used to heat cold fluid which is water (Cp = 4180 J/(kg.K), p = 1000 kg/m) from 20°C to 80°C at a rate of 0.15 kg/s. The heating is to be accomplished by hot fluid, which is geothermal water (Cp = 4310 J/(kg.K), p = 1050 kg/m²) available at 130°C at a mass flow rate of 0.25 kg/s. The inner tube has an inner diameter...
Problem X3-5, Heat Transfer, Spring 2018 A single-pass, double-tube counterflow heat exchanger will be used to heat a 0.14 kg/s stream of water nowing in the 12-mm diameter inside tube. The water in the inside tube enters the heat exchanger at 25 C. The water will be heated with a 0.12 kg/s m of hot water flowing in the annulus between the inside and outside tube that enters the heat exchanger at 80°C. UP the hot and cold streams, and...
6 Problem 4 (25%) A 2-shell passes and 4-tube passes heat exchanger is used to heat glycerin (Cp.gly = 2447) entering at 15 °C by hot water (Cp water = 4180 f.), which enters at 90°C. The thin-walled inner tube has a 4 cm diameter and a total length of 15 m. The hot water flows through the tube at a total rate of 0.265 kg/s, and the glycerin through the shell at a rate of 0.6 kg/s. The convection...
this problem in heat exchanger, please solve.
. In a parallel flow heat exchanger, hot liquid enters at 400°C and leaves at 250°C. Cold fluid enters at 50°C and leaves at 110°C. The inside and outside heat transfer coefficients are 120W/m2 K and 190 W/m2 K respectively. The inside and outside diameters of tube are 0.06 m and 0.08 m respectively. If the heat transferred per hour is 1.6x 105 kJ. Determine the length of tube required. Ans:12.5 m
Twenty [kw] of heat is to be removed from 375 [k] water flowing at 0.15 [kg/s] into the inner pipe of concentric tube heat exchanger. Cooling water enters the annulus at 290 [k] and leaves at 320 [k] with a flow in the opposite direction of the inner flow. The diameter of the thin- walled inner pipe is 2.5 [cm] a) b) c) Calculate the exit temperature of the hot fluid and the mass flow rate of the cold fluid...
Question 5 The following data is given for counter flow in concentric tube heat exchanger, mean heat transfer area = 0.02 m2 Test No Flow rate hot Flow rate Tin hotTout hot|Tin cold Tout cold (L/min) cold (L/min) (THI) (TH2) (TCI) (TC2) 13 1 60 56 30 42 a) Calculate the heat transfer rate in kW. b) The overall heat transfer coefficient U. c) The mean temperature efficiency of the two circuits (ń).
2. (35P) Ashell-and-tube heat exchanger with 1-shell pass and 20-tube passes is used to heat glycerin (Cp = 2480 J/kg) in the shell, with hot water in the tubes. The tubes are thinwalled and have a diameter of 1.5 cm and length of 2 m per pass. The hot water (Cp=4180 J/kg Centers the tubes at 102°C at a rate of 9 kg/s and leaves at 55°C. Overall heat transfer coefficient U=13900 W/m2C. The glycerin enters the shell at 15°C...
Question 3 A counter flow single pass double pipe heat exchanger is supplied with hot water at 120°C that is to be cooled by water entering at 20°C. The mass flow rate of the hot stream is 5 kg/s, and that of the cold stream is 6 kg/s. The specific heat capacity of both fluids may be taken as 4180 J/kg.K. The overall U value is 1500W/m2.K, and the surface area for heat transfer is 20 m2 a) Determine the...
Most questions answered within 3 hours.
-
1.Outline the contributions of three people in the field of
educational psychology and how these contributions...
asked 1 hour ago -
A microwave oven operates at 2.4 GHz with an intensity inside
the oven of 2800 W/m2...
asked 1 hour ago -
1. If a demand curve is perfectly inelastic and
consumers buy 500 units of the good...
asked 2 hours ago -
Think of a company that is viewing its market too narrowly. What
will be the consequences...
asked 2 hours ago -
The mean time it takes for workers at a factory to insert a
delicate bolt into...
asked 3 hours ago -
A ball is dropped from a rocket that is 350 m above the ground
and rising...
asked 5 hours ago -
Testbank, Question 31 James Water Park Company’s preferred
shares pay an annual dividend of $3.00 per...
asked 5 hours ago -
A steel wire in a piano has a length of 0.680 m and a mass of...
asked 8 hours ago -
Is validity and reliability tested by the following methods of
data analysis:
The questionnaires were coded...
asked 9 hours ago -
whats the relationship between toxoids and clostridium tetani and
botulinum?
asked 9 hours ago -
1)Explain what it means when demand is inelastic?
2) If demand is elastic, total revenue will...
asked 9 hours ago -
Jose is making quarterly contributions of of $210 to his savings
account which pays interest at...
asked 9 hours ago