Q1. A cylinder is filled with an oil (SG4c=0.825) and is pressured by a piston. (i)...
A cylinder filled with ideal gas is sealed by a piston that is
above the gas. The piston is a cylindrical object, with a weight of
45.0 N, that can slide up or down in the cylinder without friction.
The area of the top (or the bottom) of the piston is 100
cm.
The top of the piston is exposed to the atmosphere, and the
atmospheric pressure is 100 kPa. As shown in the figure, the piston
is tied to...
4. A tank is filled with incompressible oil to a depth of (h) 6.43 m open tank The tank is being drained via a horizontal pipe that is attached at a height of (h2) 0.789 m above the tank bottom. Oil is flowing out of the tank into the pipe at a rate of 2.34 x 10 m'/s, but the tank is so large that the descent speed of the oil level at the top is negligible (0) The gauge...
A tank is filled with incompressible oil to a depth of (h_1) 6.43 m. The tank is being drained via a horizontal pipe (radius 1.92 cm), attached at a height of (h-2) 0.789 m above the tank bottom. Oil is flowing out through the pipe at a rate of 2.34 times 10^-3 m^3/s, but the tank is so large that the descent speed of the oil level at the top is negligible (almostequalto 0). The gauge pressure in the drain...
A graduated cylinder is filled to the 20 cm mark with an emulsion of oil of density 800 kg/m3 and water. The gauge pressure at the bottom of the cylinder is 1864 Pa. The solution is left to sit, and the oil slowly separates from the water and rises to the top. (a) Calculate the height of the water, hwater, and the oil, hoil. (b) What is the gauge pressure at the bottom of the container once the solution has...
. I The gauge pressure at the bottom of a cylinder of liquid is P 0.40 atm. The liquid is poured into another cylinder with twice the radius of the first cylinder. What is the gauge pressure at the bottom of the second cylinder?
Problem 13.9/P. 461 A tall cylinder contains 25 cm of water. Oil is carefully poured into the cylinder, where it floats on top of water, until the total liquid depth is 40 cm. What is the gauge pressure at the bottom ofthe cylinder? (Po-900 kg/m3) Sue ion ge pressube
Q1 20 points. Two tanks contain liquid filled to the same depth h as shown below Liquid A: Has a constant density pAPo Liquid B: The density varies with position acording to the formula pn() where the coordinate z is shown in the figure. 0 is the bottom of each tank while z = h is the top of the liquid surface exposed to atmosphere. The : liquids are in hydrostatic equilibrium. Two tanks containing liquids with the same depth...
Assume that you are using an open-end manometer filled with mineral oil rather than mercury. The level of mineral oil in the arm connected to the bulb is 243 mm higher than the level in the arm connected to the atmosphere and atmospheric pressure is 741 mmHg. What is the gas pressure in the bulb in mm of Hg? (The density of mercury is 13.6 g/mL, and the density of mineral oil is 0.822 g/mL.) Express your answer with the...
Assume that you are using an open-end manometer filled with mineral oil rather than mercury. The level of mineral oil in the arm connected to the bulb is 231 mm higher than the level in the arm connected to the atmosphere and atmospheric pressure is 752 mmHg. What is the gas pressure in the bulb in mm of Hg? (The density of mercury is 13.6 g/mL, and the density of mineral oil is 0.822 g/mL.) Express your answer with the...
62) Assume that you have a cylinder with a movable piston. What would happen to the gas pressure inside the cylinder if you were to do the following? (a) Triple the Kelvin temperature while holding the volume constant (b) Reduce the amount of gas by 1/3 while holding the temperature and volume constant (c) Decrease the volume by 45% at constant T (d) Halve the Kelvin temperature, and triple the volume 63) Assuming that air contains 78.0 percent Ni, 20.0...