Page 1 Question 1.1. (TCO 1) Receiving information from the user is considered a(n) _____ operation....

Question

Question

Page 1

Question 1.1. (TCO 1) Receiving information from the user is considered a(n) _____ operation.
(Points : 5)

       input
       process
       assignment
       output

Question 2.2. (TCO 2) Which statement is not true about variable names?
(Points : 5)

       They should be descriptive.
       They must start with a letter.
       You cannot use spaces.
       None of the above

Question 3.3. (TCO 3) The statement below would be placed within which symbol on a flowchart?
Print total
(Points : 5)

       Rectangle
       Diamond
       Parallelogram
       Lozenge

Question 4.4. (TCO 2) Set course =

Answer 1

Similar Homework Help Questions

Question 1.1. (TCO 1) Which number system has a radix of two? (Points : 4) Hexadecimal...

Question 1.1. (TCO 1) Which number system has a radix of two? (Points : 4) Hexadecimal Binary Decimal Octal Question 2.2. (TCO 1) Convert 24 base 10 to hexadecimal. (Points : 4) 1A 18 20 30 Question 3.3. (TCO 1) If FF h is converted to decimal, the result is _____. (Points : 4) 100 200 255 256 Question 4.4. (TCO 1) Convert decimal 103 to an 8-bit binary number. (Points : 4) 1110 0100 0100 0000 0110 0111 0110...
1. (TCO 1) What is the output of the following C++ code? int list[5] = {0,...

1. (TCO 1) What is the output of the following C++ code? int list[5] = {0, 5, 10, 15, 20}; int j; for (j = 0; j < 5; j++) cout << list[j]; (Points : 4) 0 1 2 3 4 0 5 10 15 0 5 10 15 20 5 10 15 20 Question 2.2. (TCO 1) What is stored in alpha after the following code executes? int alpha[5] = {0}; int j; for (j = 0; j...
Question 1 A turning operation is carried out on aluminum. Based on the specific energy values...

Question 1 A turning operation is carried out on aluminum. Based on the specific energy values in Table 20.2, determine material removal rate and cutting power in the operation under the following sets of cutting conditions: (a) Cutting speed 5.6 m/s, feed 0.25 mm/rev, and depth of cut 2.0 mm; and (b) cutting speed- 1.3 m/s, feed 0.75 mm/rev, and depth 4.0 mm. Question 2 Consider a turning operation performed on steel whose hardness 225 HB at a cutting speed...

Which of the following matters would an auditor most likely consider to be a significant deficiency to be communicated to the audit committee

1. Which of the following matters would an auditor most likely consider to be a significant deficiency to be communicated to the audit committee? A. Management's failure to renegotiate unfavorable long-term purchase commitments.B. Recurring operating losses that may indicate going concern problems.C. Evidence of a lack of objectivity by those responsible for accounting decisions.D. Management's current plans to reduce its ownership equity in the entity. 2. After obtaining an understanding of internal control and arriving at a preliminary assessed level...