Post Laboratory Questions: 1. Predict the value for the Van't Hoff factor, i, for each of...
1) What is the value for the van't Hoff factor (i) for Zn(NO3)2? a) i = 1 b) i = 2 c) i = 3 d) i = 4 e) i > 4
urgent 1) What is the value for the van't Hoff factor (i) for Zn(NO3)2? a) i = 1 b) i= 2 c) i= 3 d) i-4 e) i>4
Hint: Change in temperature, AT = KX molality X Van't Hoff factor CA 1 M CscI OB 2 M CaCl2 OC. 1 M TI(NO3)3 OD 2 M Naci OE 2 M Sn(NO3)4 QUESTION 34 Which statement best describes the colligative properties of a solvent OA Depend on the nature of the solute OB Independent of the solute concentration c. Independent on the nature of the solute OD. Depend on the solute concentration OE. Both C and D QUESTION 35 Lowering...
Pre-Laboratory Questions 1. The freezing point of 20.024 grams of distilled water was determined by recording a thermogram (see plot below). 1.006 grams of an unknown, nonelectrolyte compound was added to the water, and a second thermogram was recorded to determine the freezing point of the solution. Freezing Point Curves for Water and Unknown Nonelectrolyte Temperature, c -Water -0.270 °C Time, s a. Determine the freezing point depression, Tg, for the unknown solution. b. Determine the molality, m, of the...
1) What is the value for the van't Hoff factor (i) for Zn(NO:)? a) i = 1 b) i - 2 di-4 e)i>4 2) Which of the following makes formation of a solution from two pure chemical substances more likely to occur? a) If randomness increases when a solution forms b) If energy decreases when a solution forms c) If energy increases when a solution forms d) Botha and be e) Both a and 3) For a chemical reaction to...
1. For the following reactions, determine the products when two solutions are mixed. Use the solubility rules to predict whether a precipitate would form. If no reaction occurs, write "NR”. Be sure to balance your reaction and include all states of matter. The first one has been done for you. a) 3 Ba(NO3)2 (aq) + Al2(SO4)3 (aq) → 2 AI(NO3)3 (aq) + 3 BaSO4 (s) b) LINO3(aq) + Mg(C2H302)2 (aq) → c) NiSO4 (aq) + K3PO4 (aq) → d) Na2S...
in the table below, predict which of the following reactant combinations will produce precipitates and write all the products that form (including states of matters- l, s, aq, g; write "ss" if it is slightly soluble). Useful information is also below. TABLE 4.1 | Simple Rules for the Solubility of Salts in Water 1. Most nitrate (NO3-) salts are soluble. 2. Most salts containing the alkali metal ions (Li+, Na+, K+, Cst, Rb+) and the ammonium ion (NH4+) are soluble....
PLEASE COMPLETE ASAP! PLEASE SHOW WORK FOR EACH TABLE CLEARLY AND IN CORRECT ORDER! I WILL GIVE YOU A GOOD RATING IF DONE CLEARLY AND CORRECTLY :) FEEL FREE TO MAKE YOUR OWN TABLE SINCE THIS ONE DOES NOT ALLOW YOU TO INPUT DATA. UPDATE: Someone asked which solvent is being used. It does not specify in the data provided, it already gives the volume and the mass of the solvent so you would use that to find the density....
EQUL 404: Studying Chemical Equilibris and Applying Le Chateliers Pricipale Using Microscale Lechnique Post-Laboratory Questions (Use the spaces provided for the answers and additional paper if necessary.) 1. Experience teaches us that most solids are more soluble in warm water than in cold water. Does the sol ubility of Mg(OH), fit this pattern? Briefly explain (2) The student draws some of the blue solution into the bulb ola Beral pipet. The pipet is placed, bulb down, in a hot-water bath....
numbers 1-3 Post-Laboratory Questions-EXP 3 Nitration of Aromatic Compounds Name: Due after completing the lab. 1. Why is concentrated sulfuric acid emploved in thie on? What is the electrophile that is produced by the reaction of sulfuric acid and nitric acid? 2. Why is it important to maintain the reaction temperature low and the addition of nitric acid-sulfuric acid mixture carried out slowly? 3. Explain why concentrated H2SO4, not concentrated HC1, was used in this experiment? 4. Which ring of...