https://drive.google.com/open?id=1NRSvATA5DWW6fVrL8w7-yNZrjHg1X0Xe
Problem 2. (20 points) Based on the given section view of FRONT, to finish the RIGHT...
Given: The front and top views of an object.
Required: Draw the right side view and complete the bottom half
as instructed.
For part 2: Draw the right side view of surface
14,17,19,20,26.
ORTHOGRAPHIC READING GIVEN: The front and top views of an object. 10 REQUIRED: Draw the right side view and complete the bottom half as instructed. 13 14 15 16 17 18. 26 20 22 Draw the right side view of surface 14,17,19,20,26. 14 26
Draw the front, top, right side view and section view, and
Isometric view. Use half section view.
- FILLETS AND ROUNDS R.12 Ø5.501 s 02.75 L4X 05 1.498-1.500 Figure 8.5: Bearing.
given the top and right side views, sketch the front view as a
full section
SECTIONA-A SECTION B-B SECTION C-C
2. Draw the orthographic projections - front, top and right side views for the given figure below. (20 points)
sketch an isometric view given top front and right
views.
ㄚ Top, Front & the side views are given. Sketch an isometric view.
1. Draw the part illustrated below using a full section view (front view, side view, and top section view) to scale. Use blank, letter-sized paper and include the scale used. Draw a frame around the perimeter of the page, 1cm in from the edges. Do not use grid paper (15%) Grid spacing is 5mm 2. For part illustrated below produce a multiview drawing on landscaped on a blank paper with proper dimensions following standard practice (e.g. ASME). Draw a frame...
1、 The complete FRONT and LEFT SIDE views are given. Using the foid lines to measure, draww the AUXILIARY view of the inclined surface. Label comers LEFT SIDE ONT 2. The complete FRONT and LEFT SIDE views are given. Using he fold lines to measure, draw he AUXILIARY view of the inclined surface. Label comers for reference F LS AUXILIARIES GRADE ENGINEERING |NAME GRAPHICS FILE NO.: AUX-6 SECTION
1、 The complete FRONT and LEFT SIDE views are given. Using the...
2-(20%) Use the three orthographic views given below and freehand sketch the oblique view. The drawing should be somewhat proportional. TOP FRONT RIGHT SIDE
Please draw the front , right, and top view of the object in the
third line and show construction lines, central line and hidden
line . show the size plz. of 3 drawing.
R7.50 50.50 12.30 21.6 5 13:00 400 5.00 10.00 935 -12.00 5.00 T 18.50 25.00 050 430 50 -15 2 holes R15 59 26 60 -30 -60 pant 50 40 15R SER 215 15 4 holes! 170 -70
Isometric & Oblique 1. Given the front, top and right side views of the object, sketch the Isometric pictorial of the object. You may use isometric grid paper if desired. Keep the object in proportion. TOP Zoo FRONT RIGHT SIDE 2. Given the front and top views of the object, sketch the Oblique Cavalier pictorial of the object on Engineering paper at 30 degrees. Keep the object in proportion. - - ТОР FRONT