Which of the following is a safety concern for this lab? HCl is a strong acid....
Which of the following is a safety concern for this lab?
- HCl is a strong acid. If you get any on your skin flush the area immediately with water and inform your instructor.
- Take care when heating the solution that it does not splatter or boil. Allow the solution to cool on a hot pad or other appropriate surface. NEVER put hot glassware on a cold counter.
- Make sure you properly label (chemical name, concentration, date prepared & initials of preparer) all prepared solutions with labeling tape and sharpie even if you will be disposing of solutions.
- All of these are concerns for this lab.
Homework Answers
All the given points are safety concerns for lab because you have to be very careful while handling chemicals in lab as there are certain strong acids like HCl which if by mistake fall oon your skin can lead to severe hazards and also while heating the solution you should make sure that it should not boil as it can lead to rupture of glassware and cause serious hazards so you must cool the solution on hot pad.
Apart from this you must be careful about the chemical you are handling so proper labelling of chemical should be done with initials to prevent any accident in lab
Add Answer to:
Which of the following is a safety concern for this lab?
HCl is a strong acid....
1. Identify which pieces(s) of glassware could be used in the following lab scenarios. a. Measuring...
1. Identify which pieces(s) of glassware could be used in the following lab scenarios. a. Measuring 25.00 mL of a solution b. Heating a mixture on a hot plate c. Preparing a solution of a specific concentration d. Slowly adding small variable volumes of solution e. Mixing solutions
some of the reagents used in this lab are easily confused: such as persulfate and thiosulfate....
some of the reagents used in this lab are easily confused: such as
persulfate and thiosulfate. A student inadvertently switched these
reagents, adding the persulfate to beaker A and thiosulfate to
beaker b. How would this affect the results? What would the student
observe with respect to the mixture in beaker A?
3. Some of the reagents used in this lab are easily confused: such as persulfate (S.O,2-) and thiosulfate (S,0,2-). A student inadvertently switched these reagents, adding the persulfate...
Preparation of Benzoic Acid using a Grignard Reagent URGENT 1. During your Grignard formation, a small...
Preparation of Benzoic Acid using a Grignard Reagent URGENT 1. During your Grignard formation, a small amount of benzene is formed. Provide a brief explanation and mechanism to explain this observation. 2. During your Grignard formation, a small amount of biphenyl is formed. Provide a brief explanation and mechanism to explain this observation. 3. What mass of water would be required to destroy the phenylmagnesium bromide that you prepared in this experiment? What volume does this represent? 4. Why is...
than other labs. These are toxicity, volatility, and flammability. We routinely use toxic organic solvents like...
than other labs. These are toxicity, volatility, and flammability. We routinely use toxic organic solvents like methanol and acetone that are volatile (have low boiling points), but even solid organic materials can produce vapors that may be toxic. Furthermore, organic materials are flammable, and solvent vapors in the air can and do produce explosive mixtures. You should take some general precautions when doing organic chemistry: Do not get solutions on your skin. You do not need to always wear gloves...
i need help with #3 please! SAFETY NOTES: Bromobenene and acetophenone are irritants. Wear gloves and...
i need help with #3 please!
SAFETY NOTES: Bromobenene and acetophenone are irritants. Wear gloves and avoid contact with skin, eyes, and clothing • MHC) is dritating to the skin avoid contact with the skin, eyes, and clothing Diethyl ether, usually referred to simply as "ether", is volatile and flammable. Keep a safe distance from hot electrical devices WASTE DISPOSAL *** A itrate is the liquid that passed through the Hirsch funnel, ending up in the bottom of the sidearm...
d. Suppose you mistakenly acidify the filtrate with HCl instead of with HNO3. What would you...
d. Suppose you mistakenly acidify the filtrate with HCl instead of with HNO3. What would you obser after completing the halide test, and what would that observation lead you to conclude? Organic Laboratory Technique Primer Sodium Fusions and lon Testing Background: The elements that commonly occur in organic compounds along with carbon, hydrogen, and oxygen, are: nitrogen sulfur, and the halogens. The detection of these latter three elements depends on converting them into water soluble lons (CNS , and X...
CHROMIC ACID OXIDATION Pre Lab Questions the amounts of materials that will be used from the...
CHROMIC ACID OXIDATION Pre Lab Questions the amounts of materials that will be used from the experimental section above) H2SO4 + Na2Cr207 2H20- H2O, A Molecular Weight Theoretical yield amount moles on (if applicable) Equivalents 2. Look up the melting point for p-nitrobenzoic acid and record the reference. 3. What color change is expected to be observed in the reaction? Explain why. CHROMIC ACID OXIDATION Experimental Procedure: Part I: Synthesis of p-nitrobenzoic Acid 1. Under the hood, add 0.400 g...
this is a lab of Percentage of Oxygen in Potassium Chlorate Percentage of Oxygen in Potassium...
this is a lab of Percentage of Oxygen in Potassium
Chlorate
Percentage of Oxygen in Potassium Chlorate Purpose of the lab Te esperimentar e te m o rgen in een constante decoration of poche Introduction The thermal decomposition of potassium chore can be described by the following 2KCIO 2 Cl +30 Ent epeal tehnic p e cale from the KCIO We poschodecomposes simply by heating the reaction is very Actitud is a m a ture accent the reaction, we not...
please find the purpse, Discussion, conclusion un 27 Phoenix June 20 8:10 PM a 35AEXPERIMENT 35A...
please find the purpse, Discussion, conclusion
un 27 Phoenix June 20 8:10 PM a 35AEXPERIMENT 35A Triphenylmethanol PROCEDURE ether MgBr+ C-OH + MgBr(OH) OMgBr 0 Addct Addition of Benzophenone While the phenylmagnesium bromide solution is being heated and stirred under reflux, make a solution of 1.09 g benzophenone in 2 mL of anhrudrous ether in a 5-mL conical vial. Cap the vial until the reflux period is over. Once the Grignard reagent is cooled to room temperature, draw some of...
Grignard Reaction with a Ketone: Triphenylmethanol Introduction: The purpose of this lab is to prepare phenylmagnesium...
Grignard Reaction with a Ketone: Triphenylmethanol Introduction: The purpose of this lab is to prepare phenylmagnesium bromide, a Grignard reagent, and react it with benzophenone to give triphenylmethanol. Grignard reagents are very reactive and must be synthesized in an environment free of water or any other source of potential proton donor. Once made, the Grignard reagent will do a nucleophilic attack on the carbonyl carbon of the ketone, benzophenone. The result is an alkoxide that is then protonated to give...
some of the reagents used in this lab are easily confused: such as
persulfate and thiosulfate. A student inadvertently switched these
reagents, adding the persulfate to beaker A and thiosulfate to
beaker b. How would this affect the results? What would the student
observe with respect to the mixture in beaker A?
3. Some of the reagents used in this lab are easily confused: such as persulfate (S.O,2-) and thiosulfate (S,0,2-). A student inadvertently switched these reagents, adding the persulfate...
than other labs. These are toxicity, volatility, and flammability. We routinely use toxic organic solvents like methanol and acetone that are volatile (have low boiling points), but even solid organic materials can produce vapors that may be toxic. Furthermore, organic materials are flammable, and solvent vapors in the air can and do produce explosive mixtures. You should take some general precautions when doing organic chemistry: Do not get solutions on your skin. You do not need to always wear gloves...
i need help with #3 please!
SAFETY NOTES: Bromobenene and acetophenone are irritants. Wear gloves and avoid contact with skin, eyes, and clothing • MHC) is dritating to the skin avoid contact with the skin, eyes, and clothing Diethyl ether, usually referred to simply as "ether", is volatile and flammable. Keep a safe distance from hot electrical devices WASTE DISPOSAL *** A itrate is the liquid that passed through the Hirsch funnel, ending up in the bottom of the sidearm...
d. Suppose you mistakenly acidify the filtrate with HCl instead of with HNO3. What would you obser after completing the halide test, and what would that observation lead you to conclude? Organic Laboratory Technique Primer Sodium Fusions and lon Testing Background: The elements that commonly occur in organic compounds along with carbon, hydrogen, and oxygen, are: nitrogen sulfur, and the halogens. The detection of these latter three elements depends on converting them into water soluble lons (CNS , and X...
CHROMIC ACID OXIDATION Pre Lab Questions the amounts of materials that will be used from the experimental section above) H2SO4 + Na2Cr207 2H20- H2O, A Molecular Weight Theoretical yield amount moles on (if applicable) Equivalents 2. Look up the melting point for p-nitrobenzoic acid and record the reference. 3. What color change is expected to be observed in the reaction? Explain why. CHROMIC ACID OXIDATION Experimental Procedure: Part I: Synthesis of p-nitrobenzoic Acid 1. Under the hood, add 0.400 g...
this is a lab of Percentage of Oxygen in Potassium
Chlorate
Percentage of Oxygen in Potassium Chlorate Purpose of the lab Te esperimentar e te m o rgen in een constante decoration of poche Introduction The thermal decomposition of potassium chore can be described by the following 2KCIO 2 Cl +30 Ent epeal tehnic p e cale from the KCIO We poschodecomposes simply by heating the reaction is very Actitud is a m a ture accent the reaction, we not...
please find the purpse, Discussion, conclusion
un 27 Phoenix June 20 8:10 PM a 35AEXPERIMENT 35A Triphenylmethanol PROCEDURE ether MgBr+ C-OH + MgBr(OH) OMgBr 0 Addct Addition of Benzophenone While the phenylmagnesium bromide solution is being heated and stirred under reflux, make a solution of 1.09 g benzophenone in 2 mL of anhrudrous ether in a 5-mL conical vial. Cap the vial until the reflux period is over. Once the Grignard reagent is cooled to room temperature, draw some of...
Most questions answered within 3 hours.
-
The sandwich maker of the EE-Cole-Eye Sandwich Truck was just
fired (for a reason described below)...
asked 1 hour ago -
Name the following coordination compounds using systematic
nomenclature.
1. [Co(H2O)6]Cl2:
2. [Cr(NH3)6](NO3)3:
3. K4[Fe(CN)6]:
4. Na[Au(CN)4]:...
asked 1 hour ago -
Propose an efficient synthesis of 2-Bromo-5-nitrotoluene from
benzene. Hint: 3 steps. Consider directing effects of substituents....
asked 3 hours ago -
This assignment will explore the impact of corporate decisions
on a local versus a global perspective....
asked 2 hours ago -
Given the function below, F(w,x,y,z)= x’z+w’z’+w’y
a) draw a logic diagram for an implementation which uses...
asked 2 hours ago -
Most political philosophers believe we have a duty to obey laws,
even if the laws in...
asked 3 hours ago -
Which of the following are common negotiation outcome
mistakes?
a. Leave money on the table b....
asked 3 hours ago -
Convert the following quantities:
a) 0.819 atm to torr b) 512 mmHg to bar c) 11.2...
asked 3 hours ago -
C ++ Implement cat command
The purpose of this assignment is to provide practice using the...
asked 3 hours ago -
we
convert sugars into another form of stored potential energy. This
is called?
asked 4 hours ago -
The manufacturers of Oriental Spice Sauce are concerned that the
sodium levels in their product vary...
asked 5 hours ago -
PLEASE DON'T ANSWER IF YOU CAN'T ANSWER ALL OF THE QUESTIONS. I
DESPERATELY NEED HELP
Consider...
asked 5 hours ago