Homework Answers
Answer
According to Hebbian learning, method to convert a neuron an inability to learn and enables it to develop cognition with response to external stimuli.
According to Error correction learning, technique of comparing the system output to the desired output value, and using that error to direct the training.
So answer,
*Using Hebbian learning, A should decrease and B should increase
*Using Error correction learning, A should increase and B should decrease
Add Answer to:
QUESTION 22 Given the activations and teaching signals displayed in the figure, how would learning change...
Just the program code please, thank you Question: How to compute the convolution of these two...
Just the program code please, thank you
Question: How to compute the convolution of these two signals in MatLa.. (1 bookmark) How to compute the convolution of these two signals in MatLab, without using the conv function/command System response: y(t)= 2tu(t)-3(t-1)u(t-1)-(t2)u(t-2) should be this one according to the book's solutions. Suppose that the system of Figure P3.2(a) has the input x(t) given, in Figure P3.2(b). The impulse response is the unit step fund ion h(t)u(t). Find and sketch the system...
how to slove 4-25,26,27 ?? and please 2way slove state assignment gray code and counting Order or tIne Circuit....
how to slove 4-25,26,27 ?? and please 2way slove state
assignment gray code and counting Order
or tIne Circuit. snTor the (b) Find the state table for the circuit and make a state assignment (c) Find an implementation of the circuit using D flip-flops and logic gates 4-23. In many communication and networking systems, the signal transmitted on the communication line uses a non-return-to-zero (NRZ) format. USB uses a specific version referred to as non-return-to-zero inverted (NRZI). A circuit that...
Could you please show me how I can drw those circuits. please using (NI Multisim 14)...
Could you please show me how I can drw those circuits.
please using (NI Multisim 14)
Optocoupler Objectives Use an ohmmeter to determine the condition of the optoisolator. Observe the operation of an optocoupler. Determine the maximum frequency response of the optocoupler. Required Materials (1) Dual DC power supply (1) Function generator (1) Oscilloscope (2) Multimeters (1) Optocoupler (ECG3040) (1) 3.9ΚΩ resistor (1) 220 resistor Introduction An optoisolator is a hybrid integrated circuit that contains an LED on one side...
how do i do even questions 1-12? 90 SECTION 2 The Controller d Where load chans The magnitude of the integraR Where...
how do i do even questions 1-12?
90 SECTION 2 The Controller d Where load chans The magnitude of the integraR Where lo Problems I. Which section of the closed-loop system performs the four 2. In an Oe-OfT beating system, an error signal is produced 19. a. h length of time the error - both a and b control modes? applied input voltage (above. when the measured temperature is below) the setpoint The term derivative means A derivative controllo portional...
PLEASE DO IN MATLAB Problem 8 (PID feedback control). This problem is about Proportional-Integral-Derivative feedback control...
PLEASE DO IN MATLAB
Problem 8 (PID feedback control). This problem is about Proportional-Integral-Derivative feedback control systems. The general setup of the system we are going to look at is given below: e(t) u(t) |C(s) y(t) P(s) r(t) Here the various signals are: signal/system r(t) y(t) e(t) P(s) C(s) и(t) meaning desired output signal actual output signal error signal r(t) y(t) Laplace transform of the (unstable) plant controller to be designed control signal Our goal is to design a controller...
(a) Design an inverting amplifier by choosing suitable resistor values for R1 and R2 to produce...
(a) Design an inverting amplifier by choosing suitable resistor
values for R1 and R2 to produce a gain of 5 when both switches
Sw1 and Sw2 are open.
(b) Design the bias input circuit by choosing suitable resistors
R3 and R4 such that the voltage vb will be 0.5V if the
positive power supply of the op-amp is connected to a 5V battery.
Again both switches are open.
(c) Given Sw1 is open, the amplifier is turned on for
enough...
CMOS Design Styles Quiz Problem 1: a) What is the typical "topology" for pMOS and nMOS...
CMOS Design Styles Quiz Problem 1: a) What is the typical "topology" for pMOS and nMOS in digital circuitry? -pMOS Vdd to Vout, nMOS Vout to Gnd -nMOS Vdd to Vout, pMOS Vout to Gnd -pMOS Vdd to Gnd, nMOS Vin to Vout -Only use xMOS -Both transistors Vin to Vout b) How do you implement nMOS in AND functions? -series connected, with increased widths -Parallel connected, with standard widths -Series connected with half the widths -Parallel connected, alternating large...
Please show the method of solving :) Question 1: multiple-choice questions. 1) For northem hemisphere at...
Please show the method of solving :)
Question 1: multiple-choice questions. 1) For northem hemisphere at solar noon, knowing that solar altitude can be written as sin sin o · sin 8 + cos o cos 8; from January 1" to February 28", Ys in northern hemisphere at solar po D. depends on the latitude A. will increase B. will decrease C. not sure 2) For a region (longitude x in degrees) using local time = UTC + y where...
[MATLAB Scriptfile task] Design N-band tone vocoder with a given figure (below) in MATLAB implementing the...
[MATLAB Scriptfile task]
Design N-band tone vocoder with a given figure (below) in MATLAB
implementing the given script file(bands_cutoff). This program
should be able to process any sound(.wav) file. Then, graph the
band-passed signals and amplitude envelopes extracted(after
rectification and low-pass filtering) and waveforms of the original
sound and vocoded sound. Additionally, using the output of the
script file, make spectrograms of the original sound and the
synthesized sound.
Bandpass filter Modulation Band-limiting Envelope detection BPF RECT LPF BPF sine...
[MATLAB Scriptfile task] Design N-band tone vocoder with a given figure (below) in MATLAB implementing the...
[MATLAB Scriptfile task]
Design N-band tone vocoder with a given figure (below) in MATLAB
implementing the given script file(bands_cutoff). This program
should be able to process any sound(.wav) file. Then, graph the
band-passed signals and amplitude envelopes extracted(after
rectification and low-pass filtering) and waveforms of the original
sound and vocoded sound. Additionally, using the output of the
script file, make spectrograms of the original sound and the
synthesized sound.
Bandpass filter Modulation Band-limiting Envelope detection BPF RECT LPF BPF sine...
Just the program code please, thank you
Question: How to compute the convolution of these two signals in MatLa.. (1 bookmark) How to compute the convolution of these two signals in MatLab, without using the conv function/command System response: y(t)= 2tu(t)-3(t-1)u(t-1)-(t2)u(t-2) should be this one according to the book's solutions. Suppose that the system of Figure P3.2(a) has the input x(t) given, in Figure P3.2(b). The impulse response is the unit step fund ion h(t)u(t). Find and sketch the system...
how to slove 4-25,26,27 ?? and please 2way slove state
assignment gray code and counting Order
or tIne Circuit. snTor the (b) Find the state table for the circuit and make a state assignment (c) Find an implementation of the circuit using D flip-flops and logic gates 4-23. In many communication and networking systems, the signal transmitted on the communication line uses a non-return-to-zero (NRZ) format. USB uses a specific version referred to as non-return-to-zero inverted (NRZI). A circuit that...
Could you please show me how I can drw those circuits.
please using (NI Multisim 14)
Optocoupler Objectives Use an ohmmeter to determine the condition of the optoisolator. Observe the operation of an optocoupler. Determine the maximum frequency response of the optocoupler. Required Materials (1) Dual DC power supply (1) Function generator (1) Oscilloscope (2) Multimeters (1) Optocoupler (ECG3040) (1) 3.9ΚΩ resistor (1) 220 resistor Introduction An optoisolator is a hybrid integrated circuit that contains an LED on one side...
how do i do even questions 1-12?
90 SECTION 2 The Controller d Where load chans The magnitude of the integraR Where lo Problems I. Which section of the closed-loop system performs the four 2. In an Oe-OfT beating system, an error signal is produced 19. a. h length of time the error - both a and b control modes? applied input voltage (above. when the measured temperature is below) the setpoint The term derivative means A derivative controllo portional...
PLEASE DO IN MATLAB
Problem 8 (PID feedback control). This problem is about Proportional-Integral-Derivative feedback control systems. The general setup of the system we are going to look at is given below: e(t) u(t) |C(s) y(t) P(s) r(t) Here the various signals are: signal/system r(t) y(t) e(t) P(s) C(s) и(t) meaning desired output signal actual output signal error signal r(t) y(t) Laplace transform of the (unstable) plant controller to be designed control signal Our goal is to design a controller...
(a) Design an inverting amplifier by choosing suitable resistor
values for R1 and R2 to produce a gain of 5 when both switches
Sw1 and Sw2 are open.
(b) Design the bias input circuit by choosing suitable resistors
R3 and R4 such that the voltage vb will be 0.5V if the
positive power supply of the op-amp is connected to a 5V battery.
Again both switches are open.
(c) Given Sw1 is open, the amplifier is turned on for
enough...
Please show the method of solving :)
Question 1: multiple-choice questions. 1) For northem hemisphere at solar noon, knowing that solar altitude can be written as sin sin o · sin 8 + cos o cos 8; from January 1" to February 28", Ys in northern hemisphere at solar po D. depends on the latitude A. will increase B. will decrease C. not sure 2) For a region (longitude x in degrees) using local time = UTC + y where...
[MATLAB Scriptfile task]
Design N-band tone vocoder with a given figure (below) in MATLAB
implementing the given script file(bands_cutoff). This program
should be able to process any sound(.wav) file. Then, graph the
band-passed signals and amplitude envelopes extracted(after
rectification and low-pass filtering) and waveforms of the original
sound and vocoded sound. Additionally, using the output of the
script file, make spectrograms of the original sound and the
synthesized sound.
Bandpass filter Modulation Band-limiting Envelope detection BPF RECT LPF BPF sine...
[MATLAB Scriptfile task]
Design N-band tone vocoder with a given figure (below) in MATLAB
implementing the given script file(bands_cutoff). This program
should be able to process any sound(.wav) file. Then, graph the
band-passed signals and amplitude envelopes extracted(after
rectification and low-pass filtering) and waveforms of the original
sound and vocoded sound. Additionally, using the output of the
script file, make spectrograms of the original sound and the
synthesized sound.
Bandpass filter Modulation Band-limiting Envelope detection BPF RECT LPF BPF sine...
Most questions answered within 3 hours.
-
Ripples in a pond travel at a velocity of 3 m/s with one peak
passing a...
asked 1 minute from now -
A man stands on the roof of a building of height 13.0 mm and
throws a...
asked 4 minutes ago -
Based on the range, which of the following sets of scores has
the greatest variability? 3,...
asked 8 minutes ago -
The extent to which assets are financed by borrowed funds and
other liabilities is indicated by:...
asked 1 hour ago -
Explain in detail
Germany is the fifth largest economy
explain what goods and services Germany specializes...
asked 1 hour ago -
The density of platinum is 21.45 g/mL. If a cube of platinum
with a mass of...
asked 1 hour ago -
Accounts Receivable
Sales
A/R Posting
Extended Sales Invoice
Packing Slip
Compare invoice to packing slip 2...
asked 1 hour ago -
Michaella, age 23, is a full-time law student and is claimed by
her parents as a...
asked 1 hour ago -
Why are polymers not typically casted into products?
asked 1 hour ago -
When rolling a die 129 times, what is the probability of rolling
a 6 no more...
asked 2 hours ago -
4. A call option currently sells for $7.75. It has a strike
price of $85 and...
asked 1 hour ago -
1.
You need to prepare 10.0 liters of an acid aqueous solution with a
pH of...
asked 1 hour ago